Tanggu, why are there yellow lines everywhere on the roadside?

Hello! The brick surface has a tactile feel, the stripes have a sense of direction, and the color is for normal people, be careful of bumping into people with disabilities.

When in doubt, please ask.

In general, there are two types of blind paths on the side of the road.

One is the strip-shaped pattern, which is to make the blind feel that the road only goes straight is a grainy circular pattern, which is paved with a turn.

As for the coloring, it is to remind normal people not to occupy the blind alley.

Yes, I've seen it too, and I'm living there.

Isn't it prospecting?

I'm all scared of Sichuan's **, right? Hehe.

It's looking for oil.

Go up and ask if you know, don't guess.

1. The yellow line is used to distinguish lanes in different directions, and is generally drawn in the middle of the road, like a separation belt, separating the road into two directions

1. Regardless of the single yellow line or the double yellow line, as long as it is a solid line, it is strictly forbidden to cross, such as overtaking, turning, U-turning, etc. You should not cross the line unless you are driving.

2. Regardless of the single yellow line or the double yellow line, as long as it is a dotted line, you can overtake or make a U-turn under the condition of ensuring safety.

3. The single yellow line is generally used on roads within 4 lanes in both directions (including bicycle lanes), and the double yellow line is generally used on wider roads.

4. If there are double yellow lines, one is a solid line and the other is a dotted line, which side of the dotted line is, the vehicles on that side can temporarily cross from there, such as overtaking or turning.

2. The white line is used to distinguish different lanes in the same direction, and everyone is in the same direction.

1. The dotted line can be merged and the lane can be changed.

2. The solid line is not allowed to merge, and the lane cannot be changed at will.

The lateral width is not enough, so it is necessary to use the oblique vehicle source position, so as not to affect the traffic.

Another relatively easy way to park on the street is to cross the parking space and level with the car in front of you, depending on the length of the parking space and the width of the road. Then turn the steering wheel to the right and reverse near the dead center until the right front corner of the car is close to the left rear corner of the car in front, and then start to turn the steering wheel back.

The steering wheel rotates slower at first, and when the front of the car passes over the front and rear bumpers, turn the steering wheel to the left to the near dead center. After observing from the left rearview mirror, the left side of the rear is aligned with the left front corner of the rear car, and then quickly turn the steering wheel back to the center and stop. All that's left is to make a slight correction and park the car in the middle of the parking space.

The roadside parking spot is located at an angle of 30°-45 degrees, and the reasons for this design are:

The transverse width is not enough, and the oblique parking space and vehicle must be recovered.

A: Only after stopping can it be guaranteed that it will not affect traffic;

Oblique parking space setting, the driver's vision is relatively wide when reversing;

The rear space occupied when reversing is reduced, and the rear passing vehicles are not affected to a large extent.

The design standards for parking spaces are divided into:

The length of the car is not more than 6 meters and the width of the car is not more than the meter, the spacing between the standard car and the car is not less than meters, and the spacing between the car and the wall and the end of the parking space is not less than meters;

If the length of the car is more than 6 meters but not more than 8 meters, the width of the car is greater than meters and not more than meters, and the distance between the cars is not less than meters. The corresponding specification of the carriage return section is to meet the needs of a one-time rotation of a vehicle.

Parking lots, parking spaces based on small cars, the size of the parking space is in meters, the width of the single-lane turnaround lane is not less than meters, and the two-lane lane is not less than 5 meters.

I just want you to stop diagonally.

It's good to stop and go.

Single solid line in the center: There are two types of white and yellow, which means that vehicles are not allowed to cross the line to overtake or turn left.

Double solid line in the center: There are two kinds of white and yellow, which means that it is strictly forbidden for vehicles to cross the line to overtake or drive on the line.

This is used to warn motor vehicles not to cross the yellow break.

The white curve represents the ** index in the usual sense announced by the Shanghai Stock Exchange, that is, the weighted number. The yellow curve does not consider the number of listings, and treats all the impact of ** on the SSE index equally.

When the index ** and the yellow curve are above the white curve trend, it means that the ** with a small number of issuances has risen greater; When the yellow curve is below the white curve trend, it means that the number of issuances is larger.

When the index is **, if the yellow curve is still above the white curve, it means that the decline of small-cap stocks is less than the decline of ** stocks; If the white curve is above the yellow curve, it means that the decline of the small-cap stock is greater than the decline of the ** stock.

The red and green bars reflect the current number of buy and sell orders. The growth of the red column means that the buying orders are greater than the selling orders, and the index will be gradually**; The red bar is shortened, indicating that the selling orders are greater than the buying orders, and the index will be gradually**. The green column grows, and the index ** volume increases; The green column is shortened, and the amount of exponential ** decreases.

The yellow bars indicate the volume per minute and are measured in lots.

What will be the word color of am5, am10, am20, am30, am120, am250 at the top of your software ** diagram The color of the line corresponding to the color is 5 days, 10 days, 20 days, 30 days, 120 days, 250 days** (250 days is the semi-annual line, which is also considered the bull and bear dividing line).

The lines of each color represent different **, such as 5th, 10th, etc., what is **See the link below.