Printer Continuous Ink Supply System One ink goes so slowly

Hello, I used to sell even offerings.

You first check if the blue wire is leaking. The elbow that includes the cord and cartridge connector is not a long time and needs to be replaced.

Whether the sprinkler head is blocked, if it is blocked, you can wash it several times.

If it can't be washed, you can remove the cartridge and use a syringe (without a needle) to blow and inhale into the nozzle (column) of the blue nozzle, a little lighter, and be careful to break the nozzle post.

You can also do this, you can take the original blue box and try it, or you can take an empty box and put a better lotion (non-corrosive is OK), and replace it with a box with a plug and wash it n times. Leave it overnight and try it out the next morning.

It is recommended that the landlord check the ink cartridge and the cartridge holder.

1. Remove the ink cartridge to see if the chip on the cartridge (especially the color box) is stained, if there is, wipe it clean with less dusty toilet paper;

2. Check the cartridge holder to see if there are ink stains and other stains, if there is, wipe it with anhydrous alcohol in front of the medical treatment, and then put the cartridge into the cartridge holder after the belt is completely dry, wait for 10 minutes, and then turn on the printer.

Agreed: 183216161 - Assistant Level 2 4-17 10:14

And then there's the mistake you shouldn't make:

There is a soft rubber plug on the top of the continuous ink cartridge, and the lid on the inner circle must be opened (to let air into the cartridge) when printing.

The blue tube is blocked, or the blue external inkwell is sealed. In short, the ink is not smooth!! Check the pipes!! Or maybe somewhere inside the machine, the blue tube is stuck.

The black water does go relatively fast. Because all colors will have a little bit of black mixed in them, and they will not be pure solid colors.

We worked for two years and printed ......

When you installed it, there was a leak in that pipe, and the ink couldn't pick it up. Use hot melt adhesive to find a way to plug a block.

Change the cartridge.

Maybe it's a problem with the cartridge.

Troubleshoot the cartridge later.

It's a matter of the control board.

I had to go to the pit for inspection.

It's difficult, the red color of my cartridge is ugly, the customer service can't solve it, I want to cry without tears, I have time or be patient to find them, I can't do it myself.

Change the printer, or fix it.

For the continuous ink supply system, the method is very simple and straightforward.

1. Try to wash your hair many times, and you can normally pull out the air that has been cut off.

2. If you wash your hair many times and still can't extract the air in the middle, you have to operate the manual macro socks with wide stimulation. The method is as follows: change the operation of the ink cartridge to the printer, write down the continuous supply, use the disposable needle to align the corresponding color, manually extract the air, and then quickly install the continuous supply.

It can definitely be solved

Note: If there is always a color and there will be an air outage even if you don't cut off the ink, you should check whether there is a continuous air leak at the connection position above. Generally, the continuous supply tube on the ink cartridge is easy to open the glue.

If you find an air leak, use a glue stick (preheat it will become liquid, and when it cools down, it will stick to it, 1 yuan and 1 stick), and it will be OK.