How to clean and disinfect the foot soaking bucket, how to clean the electric foot washing bucket, c

1. Drain water first after use, if there is a small amount of residual water, you can wipe it with a dry cloth, or open the drainage pipe for a period of time to make it flow out naturally, but the time should not be too long.

2. When cleaning, the basin can be flushed face up, not reversed to rinse, and it is strictly forbidden to let water enter the basin from the back heat dissipation hole, so as not to damage the electrical function and cause danger.

3. If there are foreign objects or other dirt on the inner wall of the foot soaking bucket, you can simply clean it with the surfing function first, and then wipe it with a soft cloth, and the inner wall can not be scraped with hard objects.

4. The periphery of the foot soaking bucket can be wiped with a towel. After use, you can use a small amount of water to wash again, brush once a week, and use dish soap.

Washing with non-corrosive detergents such as laundry detergents. When not in use for a long time, clean it thoroughly, leave it to dry and put it in the box.

5. There is dirt in some crevices, which is difficult to remove during cleaning, and can be cleaned with detergent and steel wool balls, but be careful not to use too much force, so as not to damage the body, and avoid infrared buttons and rollers when cleaning.

6. In the case of not in use, cut off the power supply in time, and do not let the residual water remain inside, so as not to burn the internal parts of the machine. Disinfection can be sterilized with diluted 84.

After scrubbing with clean water, it is washed with diluted 5 alcohol, diluted high mongeric acid nails, and 84 disinfectant solution.

May you be healthy and happy!

The foot soaking bucket should be disinfected with 84 disinfectant, which is both disinfectant and sterilized.

I've never heard of disinfection outside.

It's just a brush.

84 disinfectant cannot be used.

It is strictly forbidden to wipe and clean the barrel with alcohol and other chemicals.

1. Salt is one of the non-staple foods used in daily use, which can be used to clean ceramic washbasins. Just mix salt and a small amount of pine resin into a paste, apply it to the ceramic washbasin, let it stand for 15 minutes, and then wipe it off with a damp sponge, and the yellowed white porcelain will instantly restore its original white appearance.

2. Large and heavy daily necessities should not be placed on the shelf above the footbath. To a certain extent, this will cause the shelf to be unable to bear it and fall onto the footbasin, which will cause a violent impact on the washbasin.

Yes, if it is used at home (some are only used by one person), it is not too dirty, and it is usually just washed with water; After a period of time, it can be disinfected once with 84 disinfectant. If the edge is difficult to wash, wipe it with dish soap.

Of course, you can, soak it in a diluted disinfectant solution for a while, and you can clean all the dead corners.

The one my dad used, every time I ran out of water, I washed it with water.

1. After soaking the feet in the foot bucket, pour out the water and dry it naturally.

2. Cleaning steps: First of all, turn off the power of the foot bathtub and pour the water inside.

3. The lowest end of the foot bath is a filter screen, remove the filter screen (some are very strong and can be removed slowly with a screwdriver).

4. Then use a screwdriver to remove the screws of the "fountain" outlet and remove the plastic of the water outlet.

5. After removing, use a brush to clean the plastic of the filter screen and water outlet.

6. Rinse the foot bath with clean water until there are no stains floating in the foot bath, then pour the water clean.

Tools to prepare: warm water, detergent, brushes, alcohol.

Disinfection process: 1. Add an appropriate amount of warm water and detergent to the basin.

2. Stir the water evenly to make a foam and soak for 10 minutes.

3. Brush the inside of the basin with a brush to remove the remaining stains.

4. Rinse with clean water to control the water, and evenly spray a layer of alcohol solution in the basin.

5. Set the footbasin aside and wait for the alcohol to evaporate before it can be used again.