The wooden floor at home is a little deformed, what should I do at this time?

Solid wood flooring because of the beauty of course. Zero pollution is loved by many customers, but after the installation of solid wood flooring, many customers find that the solid wood floor is deformed, <>

According to the analysis of authoritative experts, the deformation of the solid wood floor in the room is mostly caused by the resurgence of the floor. The moisture content of the floor is less than the equilibrium moisture content of the local or application conditions, and the floor should digest and absorb the moisture, because there is more paint on the surface of the floor, and the moisture is difficult to enter from the surface of the floor. Therefore, the reverse side of the floor is very easy to digest and absorb water, causing the side panels of the floor to swell and elongate, resulting in shingle-like deformation, and the surface will be squeezed and cracked when it is more serious.

The solid wood floor tile deformation can be dealt with with properly laid in a proper way, and there are three parts of moisture that can cause the solid wood floor tile deformation: 1moisture in the air; 2.

moisture in the keel; 3. Moisture in the pavement. In the whole process of laying the floor, it is important to effectively prevent these three parts of moisture from touching the opposite side of the floor.

There are some unreliable flooring companies that are prone to the following situations in the installation and use, resulting in floor deformation: 1Laying the floor does not use moisture-proof film (three parts of the moisture are not proof); 2.

The connection of the moisture-proof membrane is not sticky or not tightly glued, and it is breathable and cannot reach the purpose of waterproofing; 3.The moisture-proof film is laid under the light steel keel, which only avoids the effect of floor moisture; 4.The moisture-proof film is spread on the top of the keel, the moisture-proof film is wavy on the top of the keel, and there is a gap between the floor side plate and the moisture-proof film, which is <>

A part of the moisture can still be channeled in, causing the floor tile to deform; In fact, the size of the embedded gap of the floor should be based on the specific moisture content of the floor, the dry shrinkage index of the green plants, the total width of the floor, the equilibrium moisture content of the region and other elements of the effective embedded clearance. If you want to block moisture from touching the back side of the floor, the moisture-proof film must be in close contact with the floor side panel, and a layer of substrate should be placed on the main keel to support the moisture-proof film to ensure that the moisture-proof film is in close contact with the floor side panel.

Find a professional to repair it, or pry the deformed wooden floor up, wipe the surface and interior moisture, and wait for the moisture to evaporate before putting the board back.

At this time, it is necessary to wax the floor, or to polish it continuously, and it is also necessary to remove all the wooden floors and re-lay them.

At this time, you should buy some new wooden flooring, and then re-lay it at home, of course, you can also directly use thermal expansion and cold contraction to make the wooden floor at home better.

The deformation of wood floors is mostly due to the influence of moisture on the floor. Or the problem of ground flatness, the uneven ground will cause the uneven deformation of the floor for a long time, and now the ground is generally self-leveled with cement before the floor. Secondly, the expansion joints against the wall on all four sides of the master are not reserved enough when the master paves the floor, and the floor is deformed when it is heated and expands to the wall.

In addition, the floor will be deformed even if it is wet for a long time or under the scorching sun.

Generally speaking, the floor cannot adapt to the indoor environment, the indoor floor is damp, there is no moisture-proof device, or water seepage will cause the floor to deform. In the process of installation, according to the environment at that time, it is easy to warp if it is too loose and too tight, the wooden board can not be completely dried during the processing process, and the ground laying pipe can also be deformed and arched due to thermal expansion and cold contraction, which is the problem of the manufacturer.

When laying wooden floors, a moisture-proof layer should be laid. Because the back of the wooden floor is not the same as the surface paint, the back side can easily absorb moisture, and finally cause the floor to deform.

If the floor is not dry, it will also affect the moisture of the floor. After the ground mortar is leveled, don't rush to pave, wait until it is dry and then go to pave the wooden floor!

Whether the wooden keel contains moisture, if so, it needs to be replaced!

If you have children, you must pay attention to the fact that children do not play in the water on the wooden floor, which will also cause the floor to be deformed!

What's more important is that the leakage of the water pipe will also cause the floor to deform, and the material must be bought with good quality assurance!

Deformation caused by improper construction by the master rarely occurs!

The influence of air, continuous rainfall, can also cause moisture on wooden floors.

Clean the floor hygiene, do not use a wet mop to clean, there will be water seeping into the floor, clean it up with a dry one in time!

In the installation of wooden flooring, it is necessary to deal with the moisture contact and other human factors on the back of the floor to ensure the life of the wooden floor! Decoration must pay attention to these matters, bring trouble and waste of money to replace the floor!

Small areas bulge, remove the arched floor and perimeter, ventilation and drying can play a relieving role. If a large area is deformed, you have to pry up the floor and wait for the keel, and then lay it back when the ground is dry, and check whether there is water seepage in the following home floor heating, faucets, drainage pipes, etc. Some masters will leave small expansion joints, and if they are blocked, they will clean them up.

You can mop the wooden floor with warm water, let it cool, and then apply a protective layer of lubricating oil to the surface, so that it will not deform.

These floors should be completely removed and redecorated, mainly when installing the floors, in order to be able to play a very good effect and look very beautiful, if there is deformation in this case, then the whole should be renovated.

The best way to do this is to change the planks, which is expensive and time-consuming, and you need to hire a lot of people to do it yourself.

If you don't know how to get it, you can hire a professional worker, because such a person is the most professional, and you can also repair the floor very well.

The wooden flooring at home is a little deformed, which should be replaced with a new one. When repairing, the deformed floor is removed and replaced with a new floor with cement to make the floor as smooth as before. Removing the arching block and the surrounding ground ventilation can alleviate the arching problem; Pry up the floor at the arch in a large area, and then lay the floor back after the ground and the dragon backbone are penetrated; Pay attention to the normal contact between the floor and the outside world so that it is balanced with the atmospheric humidity; If the arch of the foot is severe, consider replacing it.

In order to prevent the arching of the floor, experienced pavement masters will leave a certain small gap in advance when paving the floor, leaving room for "thermal expansion and cold contraction" to the floor.

1.During construction, the concrete base must meet the moisture content requirements before construction. When the moisture content exceeds the standard, a moisture-proof isolation layer must be laid, and the moisture-proof isolation layer should be sealed as a whole, and waterproof and moisture-proof isolation and sealing measures should be taken.

This can be well prevented. As for the solution, it is necessary to remove the wooden floor around the room to dissipate moisture, which can partially alleviate the deformation and replace the severely deformed wooden floor. If the deformation area of the wooden floor is large, the paved wooden floor can be removed and re-surfaced after the concrete base or keel has dried.

Re-install the original usable wood flooring and replace the wood flooring that affects the use.

2.Pay attention to frequent ventilation in summer, the floor of a long-term vacant room is prone to deformation such as arching and curling, so it is necessary to check the ventilation regularly. When you find signs of arching the floor slab, you must report for repair in time, and do not wait until the arching of the floor slab is serious before repairing.

At the same time, try not to step on the arch so that the incision is damaged and cannot be fully restored. At the place where the tile is changed, the baseboard should be removed immediately to cause convection under the solid wood floor, eliminate moisture, and make the surface of the solid wood floor slowly return to flatness with the evaporation of moisture.

3.Dusting and maintenance of solid wood floors is like washing your face every day, usually using a broom or vacuum cleaner to remove dust from solid wood floors, vacuuming more frequently where you step on them, paying special attention to the hallway and the walkway leading to the outside. In addition, to prevent dust from entering the house, you can place a dust mat at the entrance or install a dust strip at the bottom of the door.

The above is the answer to the question of what to do if the wooden floor at home is a little deformed.

Improper installation, material problems, excessive moisture, improper maintenance, etc. are all reasons for the deformation of the wooden floor, at this time, the deformed part should be removed for ventilation, and the new floor can also be replaced.

Many people like to install wooden floors in the decoration of the house, but in the process of use, the floor is often deformed, and the installation can not lead to the wooden flooring at home, but the important reason is that the wooden floor must be reserved for expansion and contraction during construction, if the pavement is too tight or the gap is insufficient, it will make the floor arch and deform due to external temperature changes during use.

Material problems are also an important reason for the deformation of wood flooring, many people buy wood floors when decorating is not really wood floors, but laminate wood floors, it is made of medium and high density boards, such a purpose is to put the relative density is small, the expansion coefficient is large, after the paving, once the water is too late to wipe it is easy to absorb water and expand, it will be deformed as a result, its moisture resistance is relatively poor, and it is easy to deform in a humid environment.

Too much moisture in the wooden floor is an important reason for its deformation, so that the moisture in the wooden floor exceeds the standard There are three kinds, one is the moisture in the air, there is the moisture in the keel, and then the moisture in the ground, in the process of wood floor construction, whether it can effectively block the impact of these three parts of water on the wooden floor, is the key to construction, if this aspect can be done well, the wood floor will not be deformed after paving, if the waterproof is not in place, there will be deformation. Improper maintenance of the wooden floor during use, and frequent wiping of the wooden floor with a damp rag or mop during maintenance will also cause it to deform.

When the wooden floor is deformed, you can warp up the deformed floor, wait for the ground and keel to dry, and then pave the floor back after they are completely dry, pay attention to maintaining the normal contact between the floor and the outside world, so that it can maintain a balance with the humidity of the atmosphere, so as to avoid the floor deformation again, if the floor will be deformed again after repair, then it is necessary to take off the deformed floor plate, pave the ground with cement, and replace it with a new floor, and the floor will become smooth after treatment.

1. Causes of deformation of solid wood flooring: (1) Moisture in the air (such as Huangmeitian). (2) The floor is not dry, and the keel is reinforced with cement.

3) Keel, the raw floor is too wet. (4) Use water-based glue. (5) Moisture-proof treatment that has not been done in humid environments such as the first floor.

2. Solutions for the deformation of solid wood floors: 1. The ground moisture-proof treatment method generally adopts "three oils and two felts", and the simple treatment method is to lay a layer of moisture-proof film. 2. Lay a layer of bottom plate on the keel, and the bottom plate should be made of environmentally friendly blockboard or environmentally friendly multi-layer plywood.

3. The floor is laid on the bottom plate, and the expansion coefficient between the floor strips should be according to the floor species.

The deformation of the wooden floor at home may be caused by external violence, or formed by the blow of gravity, or it may be accumulated corrosion and damage over the years. In this case, there is an option to replace the floor with a new one.

The main reason for the tile deformation phenomenon of the wooden floor in use is that the board surface is coated with multi-layer paint and the fiber of the wood has been closed, and the multi-layer paint film has a certain hardness to produce a stable tensile force on the surface, and the bottom of the board absorbs moisture and expands, and the size of the board surface has not changed. The moisture content of the walls and floors of the newly delivered residential buildings is more than 30%, that is, the houses that have been handed over for several years are not occupied for a long time, and the moisture content of the buildings closed by doors and windows is also difficult to drop.

It is very likely that the quality of the wooden floor is not good, it is not installed well when it is installed, it is likely to be caused by moisture, this situation is very common, and it may also be caused by the use of too long, and the usual life is not maintained will also lead to this phenomenon.

The reason may be that the wooden floor is damp, the way of laying the floor is not correct, the quality of the wooden floor is not very good, these reasons will lead to the deformation of the wooden floor, when buying the wooden floor, we must choose some, and also do a good job of moisture-proof, take the correct paving method.

It may be because the wooden floor has been used for too long, resulting in deformation, or it may be that the wooden floor is damp, resulting in deformation, or it may be that the quality of the wooden floor is not good, and the indoor temperature is too high, resulting in the deformation of the wooden floor.

It may be that the quality of the Trojan horse is not particularly good, so it will be deformed, or it may be that it has been used for too long, and the floor is mopped with water every day, and it will be deformed after a long time of soaking, and it may be that when the floor is pasted, the sticky is not firm and will also be deformed.