What to do if the water dispenser overflows, what to do if the water dispenser overflows

You need to see what is the cause of the overflow on the water dispenser in order to deal with it better:

1. First of all, check whether there is a problem with the drinking bucket and the water leakage. If yes, then you just need to replace the bucket, wipe off the water on the water dispenser, and replace it with a new one.

2. If the drinking bucket is fine, then the drinking machine is damaged, and you need to contact professional maintenance personnel to check the location of the specific damage, and then repair the work. If the damage is relatively large, it is best to replace it with a new water dispenser.

Precautions for the use of water dispensers

1. Water dispensers are suitable for homes and similar places and must be used indoors.

2. The water dispenser should be placed in a dry, dark, cool and ventilated place, avoiding places where there may be liquid splashes, away from plants and heat sources (try to avoid being close to the veranda or places where the sun can shine), so as not to affect the water quality or taste.

3. The water dispenser should use bottled mineral water, purified water or distilled water that meets the national health standards.

4. Before using bottled water, the packaging seal should be removed, so as to avoid the outer packaging such as the certificate from entering the barrel or Huayu water dispenser and causing the pipeline to be blocked.

5. The two faucets of the water dispenser should be used alternately to ensure that the water in the inner tank of the Jinwo water dispenser flows frequently, and only a single faucet can not be used, so as not to cause poor water circulation in the machine.

6. Clean the air inlet of Jinwo water dispenser frequently, and do not store sweets near Jinwo water dispenser (especially near the air intake hole) to avoid ants entering Jinwo water dispenser.

It may be a problem with the bucket, which was not installed in place at the time of installation, so the water will overflow from the water dispenser, and the user can take out the bucket and reinstall it, so that this problem can be solved.

If it is the overflow caused by the rupture of the water bottle, the intact water bottle can be replaced, if the float fails when using the clean water bucket and cannot be effectively sealed, the float needs to be replaced, the faucet is leaking, you can tighten the loose cap, disassemble and clean the impurities, replace the faucet if necessary, etc.

Precautions for the use of water dispensers

1. It is necessary to pay attention to the sockets and power cords used by the water dispenser to meet the specified requirements, and also pay attention to frequent inspections, and repair and replace them in time if they are found to be damaged to prevent accidents.

2. The water dispenser should be placed in a well-ventilated place, and there should be no flammable and explosive, heat source, fire source, corrosive gas or dusty place around.

3. When no one goes out, unplug the power plug of the water dispenser or turn off the power switch, which is safe and power-saving.

2. In the process of use, the opening and closing valve of the faucet of the water dispenser is loose or the faucet of the water dispenser is not tightened, which will also lead to the phenomenon of water leakage of the faucet of the water dispenser.

3. When the two ends of the water dispenser inlet pipe are not firmly connected or the water inlet pipe of the water dispenser is broken, it will cause the cold tank of the water dispenser to leak, and eventually lead to the water dispenser leakage.

If the water dispenser overflows, it needs to be repaired.

Overflow analysis: The bucket has a leak of pores, and the bucket is detected.

The bucket was not properly placed, and the air pressure was leaking. Replace.

Smart seat damaged, replaced.

The water dispenser pipe is leaking, change the pipe.

If the water tank of the water dispenser is leaking, change the water tank or weld it.

Pay attention to safety, it is recommended to take it to the electrical maintenance department for inspection and maintenance.

Sketch of a water dispenser.

If the bucket is broken, just change the bucket. Or:

If the smart seat is broken, or the water dispenser is warm, go fix it.

Summary. 1. The outflow of water from the water dispenser may be due to: there is a problem with the bucket, it is damaged, or there is a gap between the contact with the bucket basin, in this case, change the bucket of water and try again.

2. If it is flowing from the inside of the water dispenser, it may be that there is a problem with the water pipe joint, and you can see it when you open it. 3. Explain where there is air leakage. Look at the bucket, the combination of the bucket and the water dispenser, and whether the water dispenser is not well sealed.

4. The wall above the bucket is damaged, so that the vacuum cannot be formed in the barrel, and the water in the bucket cannot overcome the gravity under the action of atmospheric pressure, and the water will leak out. 5.At the beginning, I also dismantled the cover plate of the water dispenser to check whether the pipelines were blocked, but after the inspection, the road was normal, but after the bottled water was loaded into the cabinet, there was still water, so I checked the bottled water bottle and found that the bottle mouth was deformed, and the fault was completely solved after replacing the bottled water bottle.

When the water is almost out.

1. The outflow of water from the water dispenser may be due to: there is a problem with the bucket, it is damaged, or there is a gap between the contact with the bucket basin, in this case, change the bucket of water and try again. 2. If it is flowing from the inside of the water dispenser, it may be that there is a problem with the water pipe joint, and you can see it when you open it.

3. Explain where there is air leakage. Look at the bucket, the combination of the bucket and the water dispenser, and whether the water dispenser is not well sealed. 4. The wall above the bucket is damaged, so that the vacuum cannot be formed in the barrel, and the water in the bucket cannot overcome the gravity under the action of atmospheric pressure, and the water will leak out.

5.At the beginning, I also dismantled the lid of the water dispenser to check whether the pipelines were blocked, but after the inspection, the road was normal, but after the bottled water was loaded into the cabinet, there was still a digital appearance of water, so I checked the bottled water bottle and found that the bottle mouth was deformed and closed, and the fault was completely solved after replacing the bottled water bottle.

Overflowing.

The water dispenser overflowing may be due to a problem with the bucket; In addition, when there is a small amount of water in the bucket, do not pick up the bucket and let the water flow into the smart seat of the water dispenser, which will cause pressure imbalance and leakage; It may be that the water tank of the water dispenser is leaking. Extended content: Drinking water slag machine smart seat:

Located between the bucket containing the water and the body where the bucket is placed, the structure is relatively simple, most of them are similar to a cylinder, when the water outlet above the water dispenser is less water, the eggplant oak will quietly have water flowing out of the bucket, passing through the smart seat. Prevent water from flowing out of the bucket and prevent it from overflowing. This is the principle of a communicator using physics!

For example, if you fill a mineral water bottle with half of the water and remove the water cap in the basin, as long as the bottle does not leave the water surface, the water level will not drop, and the external force ** is atmospheric pressure.

Summary. Hello, the water dispenser is always overflowing for the following reasons:

1. The switch valve of the water dispenser faucet is loose, and the water dispenser faucet is not tightened, which will also lead to the phenomenon of water dispenser faucet leakage.

2. The two ends of the water inlet pipe of the water dispenser are not firmly connected.

3. The water inlet pipe of the water dispenser is ruptured, which causes the cold tank of the water dispenser to leak, resulting in water leakage of the water dispenser.

4. The valve core of the water dispenser faucet is broken, causing the water dispenser faucet to leak.

What's wrong with the water dispenser always overflowing?

Hello, I have seen your question, I am typing and sorting out the answer, it will take a little time, please wait a while

Hello, the water dispenser is always overflowing, there are reasons for the following: 1. The field stove switch valve of the water dispenser faucet is loose, and the water dispenser faucet is not tightened, which will also lead to the leakage of the water dispenser faucet. 2. The two ends of the water inlet pipe of the water dispenser are not firmly connected.

3. The water inlet pipe of the water dispenser is ruptured, which causes the cold tank of the water dispenser to leak, resulting in the leakage of the water dispenser cover. 4. The valve core of the water dispenser faucet is broken, causing the water dispenser faucet to leak.