Focus AT, R gear stalled.

When parking at the end of driving, press the brake and push into N gear, pull up the handbrake, release the foot brake and turn off the ignition, and finally push into P gear! Because when the ignition is turned off after entering the P gear, the vehicle will move back and forth a little due to the uneven road surface, and at this time, the P gear gearbox has an occlusion device that is bitten with the gear gear, and the movement will cause a little impact on the gear gear! The difference between P gear and N gear is that there is a gear engagement in the gearbox during P gear, which is not only used for parking, but also helps the vehicle brake, so the car must be pushed to the P gear after stopping, and must not be hung in N gear and rely on the handbrake alone!

This is especially true when parking in a place with a slope!

Don't forget to recommend it.

Hello, I am also a Focus owner, when I first bought a car, I often encountered the same situation as you, the main reason is that there is no hot car, so I start and reverse. Especially when encountering resistance, fire extinguishing is often extinguished. Except for Bigfoot Oil.

There is nothing else wrong, and the good habit of maintaining a hot car in the future can be done. In addition, I would like to tell you not to heat up the car for too long, which is easy to produce carbon deposits. In general, it can be done within 1 minute in summer, and in winter.

When you feel the engine revving smoothly, it's fine. I hope mine is helpful to you hehe. If there's anything you don't understand, you can ask me.

My buddy is in the 4S store, if you don't understand what to deal with, I can find an expert hehe.

Whether it is AT or MT, Fox has been driving for a while, and when he is stepping on the car, he has the problem of unstable speed, and sometimes the fire will be extinguished in serious cases. In fact, there is a problem with the throttle valve of the Focus, this problem is very common, and the 4S store refuses to admit that it is their problem, so they have no choice but to wash the throttle frequently. It is recommended not to go to the 4S store, it is very expensive, more than 200 RMB!

The above one is good, but I think the oil pump has not been pumped with oil, because you are directly ignition, Focus occasionally has this problem, I sell Focus, not only hang R gear, you hang D gear will also appear in this situation, but your parking space determines that you are R gear, in fact, to avoid this problem is very simple, after playing the car, ten seconds after the gear will leave, and it will never turn off. Don't believe me, you can try, I'm a Fox seller, and I often encounter it when I move the car in the morning in winter.

The Focus can't hang R and S gears, and it can be restarted after a few minutes of parking and turning off the engine and can hang R and S again, which is often the case.

Hello, dear. We're happy to answer your <>

This issue may be related to the Focus's transmission. Here are a few of the reasons that can cause this and how to fix it: Insufficient transmission levelIf the transmission level is lower than the specified level, it may result in the failure to engage R and S gears.

You can check that the transmission fluid level is correct and add fluids if necessary. Focus Transmission Failure Your Focus may have a transmission failure that may need to be repaired or replaced. It is recommended to go to the local auto potato repair station for inspection and maintenance.

Fox Electrical Failure: This condition can be caused by an electrical fault. R and S can be hooked up again after restarting a few minutes after the Focus is parked and turned off, indicating a possible electrical fault. It is advisable to go to a local car repair station for inspection and repair.

In short, if you are unable to solve this problem on your own, it is best to seek help from a professional organization and take appropriate measures based on their advice.

The cause of "carbon deposition" should not be underestimated, which will cause insufficient combustion of gasoline and cause the engine to shake. The impact of engine carbon deposition on the car is quite large, first of all, to reduce the engine power, that is, to make the power output uneven and gradually decay, in other words, more and more powerless. The second is to increase fuel consumption and increase your financial burden.

The third is the difficulty of cold start, that is, the difficulty of ignition, it is not easy to get on the car, and finally the carbon deposit in the combustion chamber is strict, and a heavy one will also cause cylinder detonation, and there will be a sound of low-speed acceleration, which will cause damage to the piston and crankshaft, and cause high temperature of the engine, which will seriously affect the safety of the car. Then there is the excessive discharge, which not only fails the annual inspection and inspection, but also directly aggravates the harm of polluting the environment.

There is another reason: the throttle valve is faulty. The above problems will cause engine shake and unstable speed.

It is difficult to start and easy to stall. Now, with the development of science and technology, it is also possible to solve the engine shake and unstable speed by not hanging the bottle. Difficult to start, easy to turn off the problem.