How to stick the edge of the fish tank, how to deal with the edge of the fish tank

Fish tank turtle tank, main tank edging paste.

It's not difficult, but it's very troublesome, first seal one side with transparent adhesive tape, put the material to be glued with glass glue, and then glue it on, and then press the glue that comes, and it runs on the transparent adhesive paper that has been glued first, and the fish tank is still very clean and will not leave glue. Just remove the adhesive tape.

1. Tools needed for sticking the cylinder: glass glue gun, glass glue, right-angle clamp, tape measure, triangle board, masking paper, glass knife, stretch bracket, folder, etc.

2. The steps of sticking to the fish tank: cut the glass and grind the edge, then measure the size of each piece of glass with a tape measure to get the size error of the glass, and then each piece of glass is dipped in masking paper.

3. The more common is the polymer decorative panel, the thickness is generally about 1 mm, and there will be various colors, such as red, orange, yellow, green, etc., more commonly used in Qiling is green, stainless steel edging is also more common, and the color of the macro is also relatively large, the material of stainless steel has a great benefit, that is, it can be processed into how to want the shape, not limited to right angles.

4. Aluminum-plastic panel edging, this kind of edging is very ordinary, and there are many colors and patterns to choose from, it is easy to see in the usual flower and bird market, and it is relatively cheap.

Fish tank turtle tank, main tank edging paste.

There are two kinds! One is to buy, aluminum alloy or plastic! There is also a kind of DIY that you can DIY!Wrap the edge of the fish tank with insulating tape (the black smooth kind), which is not only safe, but also beautiful!

Aluminum alloy strip or rubber strip PVC edging strip agrit edging.

Professional practice: The bottom of the fish tank is inside, and the bottom is left empty about 5mm (the bottom is suspended in the air).

Personal experience for reference.

1- The adhesive must be wiped clean with alcohol.

2- Glass glue is best to use acid fish tank special glass glue.

3- The adhesive must be held dry.

4- After gluing, be sure to press the glue surface tightly and squeeze out the air.

5- After gluing, you can't move the fish tank.

6- It is best to stand for more than 5 days before it can be completely combined with the glass.

The tutorial is as follows: 1. First determine the size of the fish tank and design the fish tank drawings, and determine the size of the fish tank according to the position of the fish tank and the species of fish to be raised.

2. The aluminum alloy shelf at the bottom of the fish tank can be purchased at a hardware store, and the cabinet doors around the fish tank can be installed by yourself or by a carpenter.

3. It is recommended to make doors on both sides of the fish tank to facilitate the maintenance of the bottom filter tank in the later stage.

4. Buy glass: The glass suitable for fish tanks is ordinary glass, float glass, and ultra-white glass, which rises in turn, and the viewing effect is also better.

5. Buy glass glue: many glass glue on the market can be roughly divided into three categories: acid glue, neutral glue and alkaline glue.

6. Other materials are recommended to be purchased: submersible pump: the hourly flow rate of the submersible pump is calculated as 6-8 times of the water volume of the fish tank; Aeration pump: the flow requirements are not very strict; Heating rod: It is recommended that Zhizhi Chop can be converted into a frequency heating rod, and the constant temperature error is very small.

7. The gluing cylinder is mainly glued twice, the first time is to stick the gap between the glass, and the second time is to reinforce.

8. Install the drain pipe of the bottom filter cylinder, make a dry-temperature separation box, and the next step is to test the water after the fish tank is glued to test whether there is any leakage.