How to automatically lift the gate pole in the parking lot?

The smart barrier is remotely controlled so that the pole can rise and fall because it has an RS485 interface.

There is an infrared sensor.

pressure waves and other safety measures. It can also realize the automatic rise and fall of stickers through the automatic management system of the parking lot. The control panel of the barrier gate is to operate the motor forward and reverse according to the instructions, the motor is rotated with the input shaft of the reducer, the deceleration output drives the arm to swing up and down, and the spindle is together with the spindle arm to do lifting movement in the horizontal and vertical directions.

When the portrait of the gate of the parking lot is automatically raised, you need to scan 11 yards, and after scanning his ***, it will only lift up by itself after scanning your license plate.

How to automatically lift the parking lot barrier, automatically lift, he generally through some identification, it has this kind of system recognition, it will generally lift itself.

The gate pole in the parking lot is automatically raised, because they generally have the function of automatic scanning of the license plate by the camera, and after the license plate that has been entered is scanned, they will automatically control the lifting of the gate lever, which is connected to the computer system.

Reason: The turnstile is controlled by a controller, generally through a remote control or wire control. But if it can take off and land automatically, it proves that other devices are normal.

The controller may have some problems, but it may also be that the controller is disturbed by the signal, or it may be that the voltage is unstable and other conditions, causing the controller to misoperate.

If the gate lever of the parking lot is automatically raised, it is generally scanned with your license plate information and payment information, and there will be an electronic paper instruction to him, and then he will lift it.

1. Vehicle detector: **Whether the vehicle detector is always green, unplug the vehicle detector if it is always on, and then manually switch on and off the remote control. If it is not normal, replace the vehicle detector.

2. Control line: check the wiring of the starting line from the control board to the gate board, and the wiring of the vehicle detector. 【Summary】 How to automatically lift the gate pole in the parking lot [Question] Hello!

How does it work? It is the camera scanning and identifying the license plate, and the license plate is compared with the system.

Some barriers have anti-smashing functions, and when the limit adjustment of the falling rod is not good, the gate rod will know that it rises when it falls on the Zato, or the gate spring is too tight The barrier used in the parking lot charging system is not a problem! Whether the barrier gate is equipped with infrared.

You have to swipe the card to automatically lift it, otherwise he won't lift it.

Garage lifting rods generally cannot be lifted manually, and most of them have self-locking devices. The lever can be manually opened and re-lifted, or the lever can be lifted with an electric button.

1.The smart barrier gate can be controlled by remote control, so that the pole can rise and fall, because it has RS485 interface, infrared sensor, pressure wave and other safety measures. It can also be achieved through the automatic management system of the parking lot.

2.In order to prolong the life of the barrier, the balance arm and balance spring mechanism can balance the torque of the gate rod, thereby reducing the load.

3.The gate lever of the barrier should be controlled by the Hall sensor in the vertical position in the vertical position, and obviously the horizontal position is controlled by the horizontal Hall sensor.

How to manual the parking lot gate pole? Introduction to the working principle of the parking lot gate rod!

4.When the power goes out, the barrier can insert the rocker into the small hole at the rear of the gate box and control the rocker input shaft, so as to raise the rocker and lift the brake lever.

Generally, the design of the barrier must take into account the manual lifting rod, otherwise it does not meet the national standard, but the way of lifting the rod is different, the earliest is to shake it up with a crocker, and later some barriers are set up at the motor reducer.

Generally, the design of the barrier must take into account the manual lifting of the rod, otherwise it does not meet the national standard, but the way of lifting the rod is not the same, the earliest is to shake it up with a rocker, and later some barriers are set up at the motor reducer, manually rotate the clutch, you can manually lift the rod, and the digital barrier of Jieshun is more advanced, in the case of power failure, you can directly lift the rod by hand, and the rod is automatically locked when the rod is lifted to the vertical position, and it cannot be manually dropped to prevent the wind from blowing the rod and smashing the car.

Hello dear! Here's how! 01 Standard parking lot car in - take the card and swipe the card - the barrier automatically rises - there are two kinds of cars in and out: 1) car out - card to security - swipe card - barrier up - car go 2) car out - swipe card - barrier up - car fight beam go 02 single barrier gate 1) remote control rise fall stop three buttons control 2) wire control base stop system rise fall stop three buttons control car in - take the card and swipe the card - the barrier automatically rises - the car in and out of two kinds 1) Car out--card to security--swipe--barrier up--car go2) car out--swipe--barrier up--car go03 single barrier 1) remote control rise, fall, stop Hengbi three button control, 2) wired controller rise, fall, stop three button control.

The barrier rod cannot be automatically lifted, and can be analyzed according to the following conditions.

The iKaike wireless cloud parking system did not receive a reply from the bank.

When the car owner paid in the parking lot of Hemusui, which installed the wireless cloud parking equipment, the bank corresponding to the merchant number of the parking lot management party did not send the reply receipt of the receipt to the system, so it did not send the gate opening instruction.

2.The owner entered the wrong license plate when paying for parking when he came out.

When the car owner goes out of the parking lot, he enters the wrong license plate when scanning the code to pay the parking fee, resulting in his license plate payment information not being uploaded, so he cannot send the gate opening instruction. Zen Bu.

3.The owner of the car scans the *** paid in advance in the parking lot to pay the parking fee.

When the owner of the car in the parking lot swept the *** paid in advance to pay the parking fee, it means that it is not to leave the site after the payment is successful, but to leave the site within the specified time, so the gate opening instruction is not sent.

4.Whether the barrier gate is operating properly.

To determine whether the barrier of the intelligent parking lot system is operating normally, you can try to operate the barrier normally in manual operation or remote control, if the manual operation can not open the gate normally, then you can contact our customer service for door-to-door maintenance.

5.The communication motherboard signal is interrupted.

When all the above detections are normal, you can check whether the main board of the parking lot charging system control is faulty, if the signal of the main board is interrupted, so the gate opening instruction cannot be sent.

This kind of parking lot management is nothing more than an advantage, because it saves manpower and does not need to manually issue and receive cards, which is indeed more intelligent.

I guess it's called a garage lift pole.

A parking lot is a place where vehicles can be parked. There are simple parking lots with only parking spaces and no one to manage and pay for them, as well as paid parking lots with entry and exit gates, parking wardens and time collectors. Modern car parks often have automated metered billing systems and CCTV.

and video recorder systems.

The legal liability of car park owners and caretakers is usually only to provide a venue for motorists to park their vehicles, and does not protect the liability for damage and loss of vehicles. July 1, 2021, Beijing Municipal Administration for Market Regulation.

The "Parking Lot (Library) Operation Service Specification" issued by Beijing began to be officially implemented.

A parking lot in which a vehicle is placed in a parking space with the power of a mechanical device is called a mechanical parking lot. According to the provisions of China's mechanical parking equipment industry standard, the operation mode of mechanical parking equipment can be divided into three categories: lifting, traversing and circulation, with a total of eight kinds of equipment. The lifting class can be specifically divided into simple lifting parking equipment and vertical lifting (also known as tower) parking equipment.

Traversing can be divided into lifting and traversing parking equipment, plane moving parking equipment, and roadway stacking (also known as warehousing) parking equipment. Circulation can be divided into vertical circulation parking equipment, horizontal circulation parking equipment, and multi-layer circulation parking equipment. The most used parking lots in China are lifting parking lots and traversing parking lots.