How to turn on the Toyota Zixuan automatic transmission, how to open the Toyota Zhixuan automatic tr

The automatic transmission car operates according to the following steps:

1. Get off the bus. 1. First check around the vehicle to see if the 4 tires are out of air or punctured, and then plug in the key to ignite.

2. About 1-2 minutes after the fire, see the number of revolutions down to about 1000 rpm, step on the brake with your right foot, hang the gear, hang the gear in D gear, then release the handbrake, and then slowly lift the right foot, which is the vehicle begins to move forward. According to the needs of road conditions, the right foot is not safely raised, step on the accelerator to refuel, and the car will drive normally.

3. When encountering congestion or red lights while driving, as long as you step on the brakes, the car will stop moving forward, no need to change gears, wait for the green light to turn on, and directly release the brakes to move forward.

Second, reversing. 1. After the vehicle stops, step on the brake, shift the gear to R gear, release the handbrake, slowly lift the right foot from the brake, and the car will go backwards.

3. Parking. 1. Arrive at the destination, park the car in the designated position, change the gear to P gear, then pull up the handbrake, release the foot brake, close the key door, pull out the key, get out of the car and lock the door.

When the vehicle needs to start, put the gear into D gear; Putting the gear into M gear belongs to the manual mode driving gear, which needs to be upshifted or downshifted upwards or downwards; Hook the gear into N gear, that is, neutral, used when stopping or towing for a short time; When the vehicle stops, put the gear into P gear; Put the gear into R gear and reverse gear. Pay attention to the safety of the rear of the car and observe the rear.

There is also the option to turn ESP off and on and on and on auto-start.

1. Use the brake pedal to step on the paddle shifter first, shift into "D" gear, and push the gear handle to the right. At this time, the vehicle can be downshifted through the "-" downshift paddle on the left, and the "+upshift paddle can upshift the vehicle. Although the manual fast mode is a bit cumbersome, it can accurately control the gear switching when the appropriate speed and torque are met.

2. R reversing gear: When the vehicle needs to reverse, it is in the reverse gear, and it should be noted that the vehicle needs to be stopped first before it can be engaged.

3. N neutral: The torque converter is in the idle state, and the power cannot be transmitted to the planetary gear, and the neutral gear is used for short-term parking.

4. D forward gear: used when the vehicle is advancing, and the forward gear is below the neutral gear.

5. M manual gear: In manual mode, the driver needs to manually increase or decrease the gear, and the gearbox will not automatically intervene.

A detailed explanation of the Toyota Zhixuan gear instruction manual.

p parking gear: this gear is generally on the top of the gear lever, long-term parking must be hung into this gear, if the fire is not hung into the parking gear, the next time the vehicle is run to hang into the parking gear and then ignition.

rRevers: When the vehicle must steer, put the reverse gear in reversing, note that the vehicle must be stabilized before it can be engaged.

n Neutral: The torque converter is at a high speed, the driving force cannot be transmitted to the gear transmission, and the neutral gear is used for short-term shutdown.

D Forward gear: applied when the vehicle is moving forward, and the forward gear is under neutral.

m manual transmission: in the manual transmission mode, the driver must manually raise or lower the gear, and the transmission is not easy to fully automatic intervention.

Toyota's Zhixuan shifts the actual operation method of the Sparrow.

1. The application of paddle shifting.

The brake pads crush first and shift into "D" gear, while the right side pushes the gear handle. At this time, you can also downshift the vehicle according to the "-" downshift puller on the left, and "" upshift the vehicle according to the "" upshift pulling. Although the manual mode is a bit complicated, it can be accurately controlled, which is suitable for the speed ratio and torque to beat the early gear change.

2. Select gears with different road conditions.

Uphill start: Downshifting with "D-" gives you a lot of torque, making the drive even stronger. Sometimes, when you bend and wait, you will notice that the driving force is left, and you can temporarily apply the "D" to upshift. When the inclination is high, the S intervention can be activated.

Downhill road: "D" should be used to raise to 2 3 gear, car engine restrictions can prevent car brake pads from being hot and ineffective due to long-term brake pedals. The torque of the first gear is very large, and the general 2 or 3 gears can already do a good job of restricting the actual effect.

Similarly, if you encounter a situation where the vehicle is slipping faster and faster, you also need to downshift the vehicle according to "D-".

Millions of car purchase subsidies.

Illustration of the Toyota Zhixuan gear instruction manual.

Parking: This gear is generally at the top of the gear lever, and it needs to be put into this gear for long-term parking. If the parking gear is not engaged when the engine is turned off, it should be parked before the next ignition of the vehicle.

Reverse: When the vehicle needs to reverse, put it in reverse gear. Note that the vehicle needs to be stopped in order to be in gear.

n Neutral: The torque converter is in an idling state, and the power cannot be transmitted to the planetary gear. Neutral stalls are used for short-term parking.

Forward gear: Used when the vehicle is moving forward, and the forward gear is below neutral.

Manual: In manual mode, the driver needs to manually increase or decrease the gears, and the transmission will not automatically intervene.

Toyota Zhixuan shift operation skills.

1.The paddle shifters are rotated with caution.

Press the brake pedal first, shift to the "D" position, and push the gear knob to the right. At this point, the "-" downshift paddle on the left can be used for vehicle downshift, while the "+" upshift paddle can be used for vehicle upshift. The manual mode, while a bit bulky, allows for precise control of gear shifting at the right speed and torque.

2.Gear selection in different road conditions.

Uphill: Downshift with "D-" for more torque and stronger power delivery. Sometimes you find that there is still power left, and you can temporarily upgrade it with "D+". When the slope is large, you can call the S gear to intervene.

Downhill: "D+" should be used to shift to 2 3rd gear, and the engine restraint prevents the brake pads from heating up and failing due to prolonged braking. If the torque of the first gear is too large, the second or third gear can generally achieve a good containment effect.

Similarly, if the vehicle is skidding faster and faster, the vehicle's downshift control should be carried out via "D-".

Millions of car purchase subsidies.

1. It is related to driving habits, such as whether it often accelerates and brakes sharply, and often merges; It is also related to road conditions, the size of the traffic flow, and finally there may be oil problems, do not refuel at a small private gas station.

The driving method is the same as in other automatic cars, and you can ask about specific aspects.