Why doesn t the Apple phone have headphones, and there is no sound

The reasons for the lack of sound from the mobile phone speaker and the treatment methods are as follows:

1.Check to see if the metal piece inside the headphone jack is out of place, and use the refill to dial it back.

3.Go to your phone's settings - Mode change - Change the headphone mode to the outgoing sound mode.

4.Use a toothpick to get through the speaker hole, and if that still doesn't work, restart the phone or restore it to factory settings.

5.If it doesn't work, you can only send it for repair to prove that the speaker is damaged.

Shut down and restart to try it, it may be the system stuck audio!

If it doesn't work after trying to shut down, try to restore all settings again (this will not delete the phone's memory data), so if it is not normal, please check whether there is no sound from the speaker alone, or no sound from the earpiece, microphone, and speaker. If it is a separate speaker, then the speaker may be broken, please send it for repair!

If it doesn't work for all three, it means that the sound control component is broken, please send it for repair!

That's because you turned on the mute switch of the phone, which is the key on the left, dial it up, just increase the volume, if there is no sound yet, there may be a problem with the speaker.

This is a technical question, hopefully subjected.

Mobile phones have mobile phone jacks, I don't know what the subject said is plugged in the headphones to play no sound or the headphones do not make a sound?

If it is not sounded externally, it is because the earphones are connected to the jack, and the mobile phone will not be able to play sound by default, otherwise it will cause a bad user experience and a great waste.

The Apple phone has to be plugged in with headphones to make sound.

1. First of all, check whether the Bluetooth function is turned on and the ** device connected to the Bluetooth is connected, and the sound output will switch to the output of the wired headset after inserting the headphones, so it is recommended to turn off the Bluetooth and then try to turn it on.

2. It should be a micro switch for the headphone jack.

The failure is caused by the earphone has been pulled out, but the switch has not been disconnected in time, you can use a toothpick to poke the jack twice to let the micro switch recover.

3. You can try to quickly plug in the earphones several times to see if you can make the earphone logo disappear, or restart the phone.

4. If you have tried all the above methods and cannot help you solve the problem, you can directly take the mobile phone to Apple's after-sales service personnel for repair, which is also the best solution.

The above is the solution to the sound problem when the Apple phone is plugged in with headphones, hope.

This is because your phone has clicked on the headphone function on the settings, so you will have sound when you put on headphones, and there will be no sound if you don't have headphones.

The headphone volume and speaker volume are separated, you have a sound with the headphones is turned on the headphone volume, and after unplugging the headphones, turn up the volume button + if there is no sound, and it should be OK.

Because the current adjustment on the mobile phone is the headphone mode, the sound will only appear when the headphones are plugged in, otherwise there will be no sound.

Why do you bring me on your Apple phone, there is a sound, there is no sound without headphones, this should be your Apple phone, and the reason why the sound is turned on is relatively small, so I can't listen to it when I play it outside.

There is a problem with the headphone port. By default, it is output from the headphone port.

Whether it is the interface or the state of the linked headphones.

Hello friends! Check your phone settings first; Try to adjust the sound volume again, if it's okay, it may be a problem with your phone's speaker...

Hello, I am very happy to answer for you: the information you have queried here shows that the lack of sound when plugging in the headphones may be caused by the damage of the headphone plug or headphones.

2.The remaining areas where problems can occur are the headphone jack and the headphones themselves, damage to the contacts of the headphone jack may cause the headphones to have no electrical signal, but it is unlikely that the reason is that the phone can recognize the headphones plugged in. 3.

The most likely cause is a disconnection of the headphone cable near the headphone plug, which can cause both headphones to be silent at the same time.

Summary. Hello, I am helping you to inquire about the relevant information and will reply to you immediately.

Hello, I am helping you to inquire about the relevant information and will reply to you immediately.

Hello, I am helping you to inquire about the relevant information and will reply to you immediately.

Hello, is it that the speaker of your phone is broken, this speaker is broken, there is no sound at all! Well. Well.

Hello, you can replace this** not expensive!

No. No.

Everything else has sounds.

Everything else has sounds.

Hello, there is no need, please refer to it yourself!

Hello, I'll take a look!Well. Well.

Hello, hands-free has a voice, it's a call, you can't hear the other party's voice!

Hello, hands-free has a voice, it's a call, you can't hear the other party's voice!

Hello, if I said that I can't hear it from the earpiece, it's a handset problem!

Summary. Apple speaks without headphones, there is no sound, and there is a problem with the phone's built-in radio, solution: use a toothpick to pass through the speaker speaker, if it still doesn't work, restart the phone or restore the factory settings.

If it doesn't work, you can only send it for repair to prove that the speaker is damaged.

You will. Apple doesn't have headphones to speak, there is no messy sound, and there is a problem with the phone's own radio, solution: use a toothpick to get through the speaker speaker hole, if it still doesn't work, restart the phone or restore the settings of the virtual training factory.

If it doesn't work, you can only send it for repair to prove that the speaker is damaged.

Why can my apple shout siri, but I can't send WeChat voice, I can't hit Changcha and can't touch the tomato WeChat**, that is, there is no sound on the other side, and I can't hear the sound of my own voice.

The reason may be that the permission is set for the WeChat voice function, or the mobile phone is set to mute. Solution: 1. Check the security software installed in the mobile phone to see if the permission of WeChat is prohibited.

2. Check whether the phone is silent. 3. Check whether the WeChat voice is in the earpiece mode, the new version of WeChat, you can directly press and hold the voice, and there is an option to switch the Kaisan number earpiece. 4. Update the version, sometimes the mobile phone brushes the system or the version is incompatible, resulting in incompatibility between the software, if the above methods do not work, you can try to update WeChat.

It's the same with the phone** that the other party can't hear my voice, I can hear the other party's voice, and I have to bring headphones to solve the problem.

This is obviously a problem with the hardware of the mobile phone, which is caused by the insensitive earpiece and needs to be replaced.

What about the price? **It's around 150-280.