X6 Searching for phone Not found

1. The official website does not provide relevant information such as mobile phone flashing (fastboot mode factory** engineering mode ROM baseband recovery parallel import modification Chinese).

2. Due to the risk of flashing and writing the system by yourself, if there is a problem with the mobile phone system, it is recommended to bring the repair card, purchase invoice and mobile phone to the nearest electronic service center to solve the problem by the engineer.

3. It is not recommended to operate by yourself to avoid unnecessary losses.

It's still the same searching for phone....not found!!!I heard the PC ringing too.

Mobile is not connected with the PC. When the previous set of English appears, press the mobile power button, and let go after hearing the PC "ding".

Hurry up and find a RM-552 firmware to flash back.,Also use JAF to flash.,If it's still like that after brushing.,Send it to the hospital.。。。

That's right, the tragedy of scheming, 552 and 559, 551 can't be brushed together.

Thank you 4th floor oil, I almost died of torture! Infinite thanks is to keep pressing ... Makes sense!!

Press it and the driver will be automatically installed, and the landlord will be calm (in fact, I've been doing it for a long time, hehe).

This problem seems to have been completed! Then he said something like he wanted to reinstall or something! I think I had that problem at the time!

After brushing, a yes or no pops up, and I click on yes and the prompt appears! I've been waiting for a long time! Just unplug the data cable!

The result is a perfect flash!! Sweat drops 1

“press power on now！！Press the power button when prompting this sentence. The landlord obviously knows English.

It's okay, this sentence probably means that the phone is not found, please make sure that the phone can be properly connected to the computer when flashing, whether the various drivers are installed normally, and the phone must be in a shutdown state to flash the phone. The possible reason for this phenomenon is that the time of pressing the shutdown button is not in place, you can try a few more times, I believe you will succeed.

Oh, and it's clear that your phone needs an upgrade! As long as this kind of fault is upgraded, it's OK, don't listen to the maintenance personnel fool you about what the motherboard is broken, what to replace or something, just upgrade to the designated maintenance point, your own flashing stability is poor, easy to crash.

In this situation, I have two suggestions for you! 1 Re-brush! Heavy first step to start brushing!

Remember to flush the battery of your phone to more than 80% first, this is relatively safe! Anyway, the power must not be less than 50%, otherwise the risk will increase! Remember to be careful when re-brushing!

2.Go to the after-sales service center of the mobile phone (not a place to repair the mobile phone) The address is on the official website of your mobile phone! You show your invoice and warranty card when you buy your phone!

You won't be charged! You can just fix it! Hope it helps!

Wrong people's children, there is a problem with the information, or the version is too high, re-order.

Try again with a different version.,I did the same when I brushed 5230.,Later, the change version was successful.。

You have to make sure that you have turned off the ovi suite and antivirus, and at the same time you have to make sure that you have your data cable driver, if not, go to the next one, and finally control the time, about a second I don't know hi me.

Generally, novices will encounter this problem with JAF flashing, and it's no problem to try a few more times, and generally press it immediately when it appears, and release it when JAF reacts for a while

Calculate the time, for example, if you press the power button to turn on the computer for 5 seconds, then you click the "yes" of the flashing machine in the third second. So it's basically the same time.

Try a few more times and you'll be successful, don't panic.