What should I do if the electric pot has been burning for a long time and the plug can t be pulled o

The main reason is that the plug is heated during the power on, and the high temperature causes the plastic of the plug to stick to the plastic of the panel socket. The following solutions can be taken:

1.Gently shake from side to side to loosen the plug before pulling it out. 2.After turning off the main switch, use a gong wire batch to activate the plug and pull it out.

Hello, the electric pot has been burning for a long time, and the plug can't be pulled out, probably because the temperature of the electric pot will become higher when it burns, and the electric pot body will be a little deformed due to the burning time for too long, so the plug is stuck when it cools down, resulting in the inability to pull out. In this case, you can try blowing the plug with a hair dryer and then taking it out with force.

The power is relatively large, the temperature of the plug is very high after using it for a long time, it is easy to burn out the socket, or it cannot be pulled out, it is recommended that you pry it off with a suitable tool after the power is off, and if the socket is burned, replace it with 1.

The main reason is that the plug is oxidized if it is not pulled out for a long time, and the plug becomes thicker, so it gets stuck inside. You can turn off the power and slowly loosen it back and forth.

There is no other way but to pull it out, and if it really doesn't work, you can only turn off the power, disassemble the socket, break the contact piece and take the plug.

The electric pot burns for too long, and if the plug can't be pulled out, the power must be cut off first, otherwise it is easy to be electrocuted and dangerous.

You can turn off the power and slowly loosen it back and forth.

The plug has been deformed by heating for a long time. It is best to remove it and replace it as a whole, which is the safest, after all, it has been deformed and cannot be used.

What should I do if the electric pot has been burning for a long time and the plug can't be pulled out

You pick up the acacia well, dear, 1Socket panel problem Bad contact like yours is likely to be caused by a broken socket panel. Because the plug is plugged and unplugged for a long time, the copper clip inside the socket panel is loose or the copper clip is not elastic, which causes the plug to be plugged normally and the contact is poor.

In this case, Chunfan friends need to replace the socket panel, and it must be repeated often like this. 2.Power cord problem The power cord is also broken due to repeated plugging and unplugging, which is much less likely than the socket panel problem.

In this case, it is good to buy a power cord.