How should Tianyi Tewa 500G be set up to let the phone pass it wirelessly

1. First the power is turned on, then plug in the network cable, plug the incoming cable into the WAN port, and then enter the address in the browser after connecting, generally.

2, Then enter, enter the corresponding account and password, generally the new ones are admin.

3. After entering the operation interface, you will see a setup wizard on the left, Attack on the entry (generally pops up automatically).

4. Click Next, enter the Internet mode settings, you can see that there are three Internet access methods to choose from, if you dial then use PPPoE. Dynamic IP can be used by plugging the computer directly into the network, and there is a DHCP server on the upper layer. The static IP is generally a private line or something, or it may be a cell bandwidth, etc., and the upper layer does not have a DHCP server, or wants to fix the IP.

5. If you choose PPPOE dial-up Internet access, you need to fill in the Internet account and password, which should be understood by everyone, and there will be an account number to open broadband, fill it in.

6, and then the next step is to enter the wireless settings, you can see the channel, mode, security options, SSID, etc., generally SSID is a name, you can fill in at will, and then the mode mostly uses 11BGNFor wireless security options, we need to choose WPA-PSK WPA2-PSK, which is so safe that it will not be hacked and rubbed by the network.

7. The next step is to set it successfully, click Done, it will automatically restart, wait patiently at this time.

Connect to the PC Suite, the first row of the kit icons, the second one, you just look at the prompt, and immediately replace it after connecting it, and turn on the PC Suite, the Internet Fee Traffic is on, so Exit, there is an N78 controller in the network connection, and use that network connection.

Online Neighbors Right-click Select Properties Key No Right-click Broadband Connection Select Properties Advanced Internet Connection Sharing the First Two Ticks Disconnect the Network and Reconnect... After the hunger finger, the phone turns on the wifi search! The password is behind your router...Hope!

You have to log in with a superuser to enable the routing function to meet your application needs.

Superuser: telecomadmin Fill in the password field: ne7ja%5m (case sensitive).

This brings you to the cat's internal superuser page.

Then set up the routing function of the cat. This is usually in the Network tab. Create a new connection in the mode of Routing The route mode is PPPOE VPI and VCI depending on the local area, and then fill in the broadband and password in the username and password.

Add it and you're more than half done! The last step is to select Enable SSID broadcast in the WLAN tab, in order to be safe, so as to prevent others from rubbing the network, set the WEP wireless password. If you're not afraid of rubbing, don't worry!

On your diagram on the Enable Wireless checkbox.

Go to the broadband settings, turn the activated PVC, share the Internet to SSID1 (WiFi), and change the bridge to Router mode.

Of course, you must first make sure that your mobile phone is connected to your modem, encryption method, and password must be selected correctly.