How many ways are there to use car running lights?

When driving at night, everyone's biggest headache is to meet the driver who turns on the high beam to the end. This kind of behavior of not turning on the lights is common in driving at night. Harsh high beams can not only make your eyes sore, but they can also seriously affect your vision.

When driving in the city at night, the lighting on the road is good in most cases, so there is no need to turn on the high beams at all. However, when the road lighting is not ideal, the high beam is on is an important factor that induces a car accident. However, no matter what accidents occur during the day or at night, a considerable part of them are caused by not knowing how to use light signals correctly.

The most common example is when you suddenly change lanes while driving without using your turn signal, or when you turn signal at the same time, catching the vehicle behind you off guard. Therefore, it is self-evident that learning to use light signals correctly is important.

It is understood that the "Regulations for the Implementation of the Road Traffic Safety Law" has made very detailed provisions on the use of lights for motor vehicles.

Article 47. When a motor vehicle overtakes, it should turn on the left turn signal, change the use of the high and low beam signals or sound the horn in advance.

Article 48. On roads without ** separation facilities or center lines, motor vehicles should be observed when coming from the opposite direction: when coming from the opposite direction at night, traffic lights should be used at a distance of 150 meters, and when encountering non-motor vehicles on narrow roads and bridges, traffic lights should be used.

Article 51 When a motor vehicle passes through an intersection controlled by a traffic light, it shall observe: when turning left, turn left from the center of the intersection of Kaijichai. Turn on your turn signals when cornering and your low beams when driving at night.

Article 57 When a motor vehicle turns left, changes lanes to the left, prepares to overtake, leaves the parking lot or makes a U-turn, it shall turn on the left turn signal in advance; Turn right, change lanes to the right, drive back to the original lane after overtaking, stop on the side of the road, and turn on the right turn signal in advance. Article 59. When a motorized lead collapse vehicle passes through a sharp bend, steep slope, arch bridge, pedestrian crossing or an intersection without traffic signal control at night, it shall alternately use the far and near lights to indicate it.

Article 61. When towing a faulty motor vehicle, it should be noted that both the towing vehicle and the towed vehicle should turn on the hazard warning flashing lights.

Millions of car purchase subsidies.

If you encounter such a problem, you may suggest the following:

1. If it is indeed a high beam, the examiner shouts high beam, there are two ways to deal with it.

1) Change the high beam to the low beam first, and then change the low beam to the high beam.

2) Tell the examiner directly that it is now high beam (but ask weakly, do you want me to become low beam).

2. If it is already a low light, the examiner calls low light, there are two ways to deal with it.

1) First the low beam becomes the high beam, and then the high beam changes to the low beam.

2) Tell the examiner directly that it is now low beam (but ask weakly, do you want me to become high beam).

Just pull the light control up and down.

I dare to go on the road before I understand the lights.