What is the purpose of having a small hole in the general refrigerator?

Drain the condensate inside the refrigerator. The condensate is finally passed to the compressor tray at the bottom of the refrigerator.

One: Causes of a lot of condensation:

1: When the food is stored, the temperature is too high and it is not cooled directly into the refrigerator, the hot air has a large water content, and cooling in the refrigerator will cause a large amount of condensation, and the generation of condensate is greater than the speed of discharge, which will cause water accumulation.

2: The number of times the door is opened too often, causing a large amount of hot air to enter the refrigerator, and the hot air will produce condensate in the condensation, and the generation of condensate will be greater than the speed of discharge, which will cause water accumulation.

3: The leakage hole at the back of the refrigerator is designed to drain the condensate in the refrigerator.

2: Condensate drainage hole blockage cleaning method:

1: Open the small lid at the back of the refrigerator, drain the pipe head, blow the pump against the pipe, and then pour some water from the drainage hole in the refrigerator to rinse it several times, which is very effective.

Three: condensate drainage hole blockage prevention method:

1: Put things until they have cooled to room temperature, and it is best to use a sealing device to reduce moisture in the refrigerator and reduce freezing.

2: The thermostat of the refrigerator can be adjusted to 2-3 gears in summer. In summer, the refrigerator temperature compensation switch should be turned off.

3: When picking up and placing food, it should be concentrated as much as possible to reduce the number of door openings. At the same time, after opening the door, it is necessary to take and release quickly to shorten the opening time.

4: Observe the condition of the refrigerator sealing strip, and repair or replace it in time if the seal is not tight.

The small hole in the refrigerator compartment is for the condensate drainage, and the water will pass all the way to the compressor tray at the bottom of the refrigerator, which is not large, and can be evaporated by using the heat generated by the compressor when it is working, and will not flow to the ground, which is normal.

Hello! It should be caused by the condensate not being discharged! There is a drain hole in the refrigerator compartment of your refrigerator (near the sink), and you can poke it down with a soft wire about a meter, and then pour a glass of water into it!

Open the back of the refrigerator with a few small screws to see the water pipe, the condensate of the water pipe will flow to the water tray above the compressor, if there is more water, you can clean it, usually the compressor will evaporate when it heats up!

If the ice on both sides of the sink hole is very serious, then it may be caused by the moisture of the insulation layer, and you need to open the back to replace part of the insulation layer to solve the problem!

Dredge it yourself, after dredging is completed, it still can't be used normally, it is recommended to find a manufacturer to operate!

Hope mine can help you! o(∩_o...

The hole in the circle is similar to the hole in the cold room mentioned in the title by 3354 people. The function of this hole is simply to drain the refrigerator and after the condensate is generated, the water adheres to the inner wall of the refrigerator and flows downward. The lowest end of the inner wall of the refrigerator is the slope, and this water is concentrated in the small holes along the slope, and then drained out of the refrigerator through the small holes to avoid water accumulation in the refrigerator.

The water draining the refrigerator will continue to flow along the rubber hose until it is concentrated on the sump pan under the compressor. Due to the high temperature here, the water on the sump also evaporates quickly. We don't need to clean the water collection plate when using the refrigerator normally.

This simple system is handled by itself, and I am asked to solve the problem raised by two users about the condensate in the refrigerator compartment.

Where does the water in the refrigerator freezer come from? It's like a source of frost in the freezer. When the freezer temperature is low, the water will frost.

The temperature in the refrigerator is high, but the water is still water. Direct cooling refrigerators are bound to encounter this problem. Chilled water is more likely to be generated under the refrigerator (the direction near the freezer, the stomach is more likely to be generated under the freezer), and the production site is usually the inner wall of the refrigerator.

Because the evaporator of the refrigerator is set between the freezer and the freezer compartment closer to the freezer. The evaporator is the key to getting a low temperature inside the refrigerator. As a result, the temperature will decrease in the place closer to the evaporator, the temperature of the inner wall of the refrigerator will change, and the closer you are to the evaporator part, the lower the temperature will be.

As a result, condensation is more likely to occur in this cooler environment, and if the refrigerator is set to a lower temperature, ice cube 3354 in the refrigerator may still occur near the evaporator. It turns out that this hole is called a drainage ditch, and as the name suggests, it is used to drain the condensate coming out of the refrigerator compartment. In the process of using the refrigerator, the food put in will bring a lot of hot air.

Especially when our food is not dry enough, putting it in the refrigerator will produce a lot of hot air, which condenses on the walls of the refrigerator chamber and becomes a lot of water droplets. That's the condensate. (

If you find that the gutter is frozen, communicate it in time. First of all, the commonly popular air-cooled refrigerator is cooled by cold air circulation, and has an automatic defrost function, but the functional structure is different, and the frost condenses on the internal evaporator, which we can't see. So most of them may not have drains.

If you look closely when you open the refrigerator compartment, there is a small hole inside, and the function of this small hole is very simple. It's about drainage. Many people wonder why does the refrigerator drain water?

The refrigerator compartment of the refrigerator generates condensation during use, and the resulting condensate flows down the inner wall of the refrigerator. We know that the lowest part of the inner wall of the refrigerator has a certain slope. So at this time, the condensate flows into the small hole along the slope, the small hole is discharged, and the discharged condensate flows along the rubber hose to the plate under the compressor.

This is the "drain hole" inside the refrigerator, and if this drain hole is blocked, the water vapor will not be able to escape, which will lead to freezing. If the refrigerator freezes for a long time, it not only wastes electricity, but also affects the service life.

Personally, I think the reason for preservation is that there is a hole, which is used to emit some flavor, after all, the air in the fresh-keeping layer is very important.

This hole is used for exhaust, generally speaking, the smell may be strong when the refrigerator is closed for a long time, so it is necessary to leave a place for exhaust, so that the smell in the refrigerator will not be bad.

Can I pour water into the hole in the refrigerator crisper? What will happen if you pour water?

The water draining from the refrigerator flows down a rubber hose until it is concentrated in a sump tray under the compressor. The temperature here is higher, so the water in the tray evaporates quickly – we don't need to clean the tray when using the refrigerator normally, this simple system takes care of it ourselves. Originally, this hole was called a drain hole, and as the name suggests, it was used to drain the condensate generated by the refrigerator freezer.

In the process of using the refrigerator, the food put in it will bring in a lot of hot air, especially when our food is not fully cooled, a large amount of hot air will be generated in the refrigerator, <>

The temperature of the refrigerator room is usually 5 6 degrees, and there will be condensation or frost on the indoor refrigeration wall when the refrigerator is working, and the water or frosted water will flow out of the box through the small holes, collect in the small box above the compressor, and use the heat of the compressor to evaporate the water. This hole must not be blocked, otherwise the refrigerator will be "flooded".

Since the fresh-keeping room produces crystallized water when it works, (just above the small hole). The crystallized water flows through a small hole to the water box above the compressor and evaporates. If the hole is blocked, the water in the fresh-keeping room will flow to the outside of the door and pollute the indoor environment.

With the development of society and the improvement of economic level, almost every household has a lot of smart devices and household appliances, and the emergence of these things has improved our quality of life and brought great convenience to our lives. The refrigerator, as a place to store food in our lives, plays a role in keeping it fresh and freezing.

The hole in the refrigerator compartment is the drain hole of the refrigerator, and the drain hole is in the back of the refrigerator. The function is: the cold condensate in the refrigerator room flows to the water tray on the compressor through the drainage hole, and the compressor evaporates the water when it heats up.

The drainage hole can discharge the water in the refrigerator in time to prevent the refrigerator from freezingThe refrigerator is composed of four parts: evaporator, condenser, compressor and thermostat.

This is used to drain water, and if you open the refrigerator often, there will be a lot of hot air in the refrigerator, and there will also be a lot of water vapor to atomize the reaction, so that the hot air can be discharged.

Drainage, because the current refrigerators are air-cooled, so they will not freeze, but there will definitely be water when the hot and cold air blends, so there is such a hole for drainage.

The main function is to release the air conditioner, because sometimes too much gas in the refrigerator will cause some bad effects, and it will also cause some damage to many things.

These two holes are used to drain the water in the refrigerator, and some condensation is often produced in the refrigerator, which can be discharged from these two small holes.

This hole is used to drain the gas in the refrigerator, so that the gas in the refrigerator can circulate, and if it is not circulated, the refrigerator will freeze to death.

The hole in the back of the refrigerator compartment of a household refrigerator is usually used for ventilation, and its function is to keep the air circulating in the refrigerator and prevent the accumulation and deterioration of the air in the refrigerator. Specifically, the holes in the back of the refrigerator can do the following:

1.Keep air circulating: Holes in the back of the refrigerator allow fresh air to enter the refrigerator while expelling stale air from the refrigerator compartment to keep the air circulating and prevent food from spoiling.

2.Prevents mold growth: Holes in the back of the refrigerator allow air to circulate and prevent moisture build-up in the refrigerator, which can reduce mold growth.

3.Improve refrigeration efficiency: The hole at the back of the refrigerated compartment allows air to circulate, thereby improving the refrigeration efficiency and making the temperature in the refrigerated sedan banquet room more stable.

It should be noted that the hole behind the refrigerated closed silver compartment should not be blocked or obscured, otherwise it will affect the ventilation effect of the refrigerated compartment and cause food to spoil. Therefore, when using the refrigerator, the hole at the back of the refrigerator should be kept unobstructed and balanced.

The hole in the back of the refrigerator compartment of a household refrigerator is a vent that allows air to circulate and dissipate heat inside the refrigerator.

1. Air circulation inside the refrigerator: The hole in the back of the refrigerator is used to promote the circulation of cold air inside the refrigerator. This can help maintain the stability of the refrigerator temperature and better maintain the quality of refrigerated and frozen goods.

2. Refrigerator heat dissipation: In addition to promoting air circulation, this hole also helps to dissipate heat. The space behind the refrigerator is often associated with the compressor and condenser, which are components that constantly generate heat and can cause the freezer to malfunction if not dissipated in time.

As a result, manufacturers often incorporate vents in the back of the refrigerator to help the cooling and temperature regulation system maintain the correct operating temperature.

3. Maintain the refrigeration effect: The location and size of the ventilation holes are to achieve the best refrigeration effect. If the ventilation hole is too small and the internal air circulation is insufficient, it will cause uneven refrigeration in some areas and affect the working effect of the refrigerator.

If the vents are too large, too much cold air will be lost, which may increase energy consumption.

Expand knowledge: 1. When moving the refrigerator, you should be careful to avoid damaging or blocking the ventilation holes, otherwise it will affect the working performance of the refrigerator.

2. At present, the ventilation holes of some refrigerators adopt more complex designs, such as using sensors to monitor the flow of cold air and automatically adjust the size of the holes. This can further improve the efficiency and use experience of the refrigerator.

Many people may find that there is a small hole in the back of the refrigerator when using a household refrigerator, and they don't know what the purpose of this hole is. Actually, this hole is the drain hole inside the refrigerator, also known as a self-picking drain device. The purpose of this hole is to drain the moisture inside the refrigerator and prevent the moisture from accumulating into ice cubes, which can affect the operating efficiency of the refrigerator.

When the temperature in the cold room rises, some of these substances turn into ice cubes, and after some time, these ice cubes melt, producing moisture. This moisture is discharged out of the refrigerator through a self-collecting drain, which keeps the inside of the refrigerator dry and hygienic, making it safer and healthier to store food in the refrigerator.

When using the refrigerator, we should pay special attention to cleaning the drain holes. Because if the drain hole is blocked by debris or other substances, it will affect the drainage effect, cause stagnant water and odors, and increase the growth of bacteria inside the refrigerator. Therefore, it is very necessary to regularly check and clean the leakage and drain holes inside the refrigerator.

In short, when using household refrigerators in daily life, we should pay attention to this small drainage hole and keep it smooth and clean, so as to ensure the dryness and hygiene of the inside of the refrigerator and escort our health.

This belongs to the sewage outlet, generally speaking, when we have to disturb the operation of the refrigerator, this key Chadan side will produce water droplets or frost and snow, he will go down this small mouth after it melts down, there is no dust below There is a water tray connected to the water, after the long-term operation of the refrigerator, the water will automatically evaporate.