The left mouse button is not easy to use, why is the left mouse button not working

Here's a good idea:

Open Control Panel-Mouse-Mouse-Button-Mouse Button Configuration, tick the box in front of "Toggle Primary and Secondary", and then you need to right-click "OK".

At first, it was a bit unaccustomed to switching the left and right buttons, but it will soon get used to it.

By the way, this feature is mainly for the convenience of "left-handers".

Since the left button is not flexible, it is recommended to buy a new one, if you don't want to buy, you can also use the mouse settings in the control panel to slow down the double-click speed of the mouse.

I just fixed my mouse.

Left mouse button on me.

One click is two.

Bad contact. I'll just use someone else's bad mouse.

Remove the micro switch button inside and replace it with your mouse.

Soldering with an electric soldering iron is OK.

The micro buttons are all universal.

Feel relieved. If there is no anti-static soldering iron.

Then heat the soldering iron and unplug the power to solder.

Be fast!

Dismantle the mouse,Replace the micro switch under the scroll wheel with the micro switch under the left button.,Don't want the wheel.,You can still slide.,Just can't click (who clicks with the wheel,I guess don't have that habit),You shouldn't use the buttons of the scroll wheel.,But you need an electric soldering iron,Tin wire,

The most frustrating thing in the world is that the mouse doesn't respond when you press it, and it doesn't respond when you press it again. Hehe.

Buy a new one, you said you really don't have the money, take it apart and take it apart.

Your mouse. I've been using it for a few years, and it's quite cheap to buy a mouse now, so get a new one!

The old ones are not good to make.

There is a mouse setting in the control panel, double-click speed or something, is it a setting problem?

Double, this stuff is the cheapest.

No repairs are required.

You see if there is garbage in the left button or any small particles stuck in it. Clear it out.

1. Analysis and solution: According to the fault phenomenon of the mouse, you can hear the clicking sound, which means that there is no problem with the mechanical parts inside the mouse, but the reaction of the mouse is not normal, which should be caused by the poor contact of the micro switch.

2. The mouse may be in poor contact, if you find that the moving ruler can not be shaken, you should shake the mouse line first, if the mouse occasionally moves when shaking, it means that the contact is poor. If the mouse falls to the ground or is damaged by a collision, if Lingcha does not respond, it needs to be repaired or replaced with a new one.

3. Software setting problems; Caused by viruses; The micro switch of the mouse button is malfunctioning.

4. Because the system is busy, the system cannot respond to the will of the mouse in time, and it may also be because the system has been installed for too long, or the software is too much, resulting in the failure of the left mouse button. The line is broken.

Computer. 01 Click "Start" on your computer and select "Control Panel".

02 Click on "Printers & Other Hardware".

03 Click the Mouse, as shown in the figure below.

04 Check "Toggle between primary and secondary buttons", then the right mouse button will replace the function of the left button.

05 After checking the box, click OK, as shown in the following figure.