How does the Roewe 35O automatically shift gears, and what happens when the Roewe 350 automatic tran

Hello, automatic transmission cars are on the brakes and in gear, D gear when driving, R gear when reversing, and P gear when parking. If it helps you, please set it to.

You can change gears by stepping on the brakes, and then change after the car is very stable, and the normal driving is directly D gear, and you don't need to change.

Hello, the vehicle transmission failure, the relevant reasons and treatment methods are as follows: the first vehicle transmission oil is too dirty or the transmission oil loss caused by this phenomenon, it is recommended to check the transmission oil first, if there is a problem, you need to replace the new transmission oil. This phenomenon caused by the failure of the valve body inside the second gearbox, this is the need to use a computer to read the fault of the gearbox system, according to the fault ** further diagnosis and analysis, the valve body failure, if there is a problem, need to replace the new valve body. Third, the phenomenon caused by the problem of changing the gearbox shift logic belongs to the gearbox program garbled, which is the need to use a special computer to redo the upgrade of the gearbox program, or to match the reset!

Hope mine can help you! Hello, I wish you a happy family, if necessary, you can continue to consult, I will always wait for your reply Good luck, everything goes well, and a happy life! Kiss kiss kiss.

Roewe 350 automatic transmission w is snow mode, press the button, the place below the dashboard will display the gear will display a snowflake pattern, at this time the vehicle has entered the snow mode, driving the vehicle to control the throttle strength, remember not to step on the accelerator when driving on the snow.

Now the car will basically be equipped with the choice of "sport mode" and "snow mode", and then call the noise according to the requirements of the environment, choose the appropriate control mode to meet the driving pleasure and safety of the driver, choose the snow mode when driving on soft and easily slippery ground, the vehicle will start in 2nd gear and switch to high gear at lower speed, so as to ensure that the vehicle has a smoother, gentler torque output, reduce the probability of tire slippage on smooth snow.

Beckerel Chain At the same time, driving in W gear, the ABS's working range will also be relaxed. Under normal circumstances, ABS, which requires a hard press on the brake pedal to intervene, will also be turned on in the case of non-emergency braking, in short, everything is to ensure that the vehicle is safer when driving on ice and snow roads.

Summary. Hello, the automatic transmission generally can't be hung up either the gear line falls off, or the gear shift mechanism is stuck, but this possibility is very small.

Hello, the automatic transmission generally can't be hung up either the gear line falls off, or the gear shift mechanism is stuck, but this possibility is very small.

Stuck there won't work.

Hello. Hello, can't you hang the gear?

Yes. What's the problem.

Is there electricity in the car?

Can the car start properly?

This kind of fault needs to check whether the brake switch is normal, check whether the lead belt and check the gear line to clear the lock solenoid valve is normal, check whether there is a problem with the shift cable, and the locking mechanism is stuck and can not return, etc., there are many aspects involved, and they need to be checked one by one.

Yes. Is your car still under warranty?

Roewe RX5 automatic transmission has P (parking gear), R (reverse gear), N (neutral gear), D (forward gear), M (manual gear) five gears, when the gears are converted between them except DS, you need to first step on the brake, and then turn the gear lever to the gear you want to change, and finally release the brake, that is, complete a gear shift. The Roewe RX5 uses an in-line gear design, which has the advantage that the gear shift is relatively straightforward and smooth, but the disadvantage is that it is easy to hang the wrong gear when operating blindly.

Take P gear shift to D gear as an example.

1. Press the brakes.

2. Dial to D file.

3. Release the brakes.

4. The gear shift is completed.

When you need to park at the end of the car, you need to do it in this order: after parking, first shift the gear to neutral, turn on the parking brake, then push the gear to P, and then check whether the doors and windows are closed tightly, so as to turn off the lights and all discharge devices, and then turn off the engine.

Standard process: apply the brakes, D r n, pull the handbrake, n p, turn off, release the brakes.

Precautions: Do not push the gear into P gear first after stopping the car, which will cause the vehicle to shake slightly, and it is easy to damage the gearbox locking mechanism after a long time.

In addition, during driving, D gear and S gear can be switched freely, no need to step on the brakes, in addition to switching between the gears, be sure to step on the brakes, turn the gear lever to the correct gear, and then release the brakes. Release the brakes in advance, and it will shift into the wrong gear. The Roewe RX5 gearbox has an M gear "+ symbol on the left side of the D gear.

While driving, if the owner wants to use the manual mode, simply switch the gear lever from D to "M" or "S" gear, and then upshift and downshift according to the situation.

How to use the gears of the Roewe i5 automatic transmission? Roewe i5 automatic transmission, the correct use of the car's gears introduction:

1. P-parking gear, parking for more than 1 minute is recommended to hang this gear, N gear is neutral, 15 seconds -60 seconds parking can hang N gear plus handbrake;

2. R gear is a reverse gear, this use does not need to be solved, D gear is the forward gear, and it is also the most used gear in daily driving;

3. The S gear is an overdrive gear, which delays the upshift time in exchange for more abundant power, and at the same time will cause an increase in fuel consumption. When overtaking, you can use this gear if you feel that the speed is slow;

4. Push to the right in D gear. Enter the manual mode, push forward in manual mode, that is, the + direction, is the upshift, and push back (the - direction) is the downshift.

It's so easy, isn't it? You don't even understand this? P is neutral, R is reverse, D is forward, N is parking, and there is a 1st and 2nd gear respectively for climbing, do you know why you know so much?

I'm a Roewe car, and the 350 is equipped with a 3G network driving package, right? Hee-hee.

You can go to Huangpu to try it, Roewe RX5 automatic transmission has P (parking gear), R (reverse gear), N (neutral gear), D (forward gear), M (manual gear) five gears, when the gears are converted between them in addition to DS, you need to step on the brake first, and then dial the gear lever to the gear you want to change, and finally release the brake, that is, complete a gear shift.

Here are a few things to keep in mind:

First: Start only with P and N gears. When the gear is hung in P and N gears, most cars need to step on the brakes at the same time, because this is mainly a program set up to prevent accidents.

Second: Concentrate on using the "D" block. There are some differences in the automatic transmission of various models, some have "M" gear, which is the manual mode, and there are +, - to represent upshift and downshift respectively; Some have "S" gear, called Sport Mode, which delays the upshift position and can have enough torque power.

Some "L" gears, that's low-speed gears.

Whether these modes are sports mode, manual mode or low-speed gear, they generally don't need to be managed, and under normal circumstances, just use the D gear. Because I just played the automatic transmission car, I haven't figured it out yet, and I'm not familiar with it, so I can drive in D gear and let the car automatically shift gears! Once you're used to it, you'll get to know the special modes.

Clause. 3. Familiar with the characteristics of automatic transmission. The shift mode of the automatic transmission is refueling downshift, refueling upshift. In automatic mode, the idle speed is inherently high, and when you let go of the handbrake or footbrake, the vehicle can move forward without refueling.

In order to achieve the effect of fuel saving, it is usually only necessary to relax the throttle after the rev rises by lightly pressing the accelerator, so that the automatic transmission vehicle can intelligently enter a higher gear through the gearbox by means of oil collection. On the contrary, frequent deep throttle will cause the automatic transmission to drop into lower gear, and frequent operation will easily lead to increased fuel consumption and aggravated transmission wear.

Fourth: Do not slide in "N" gear while driving. Because when the gearbox is engaged in N gear, the oil pressure in the gearbox is not established in the system, and the moving parts in the gearbox will wear out quickly without oil film.