Philips Fax Machine Manual, Philips TV Manual

Click the "Receive" button on the main interface to run the Receiving Manager first, or you can select "Automatically load the Receiving Manager when Windows starts" in the receiving settings, or you can run it directly. 2. Manual receiving: refers to when the response mode is set to "manual receiving" in the receiving settings.

When the other party asks for a signal during a call with the sender, click "Manual Receiving" in the "Job" menu of the Receiving Manager to send a fax signal to start receiving. 3. Automatic receiving: refers to the setting of the response mode in the receiving settings"Fax Only Fax Voice Fax voice data"Time.

When the other party calls**, the receiving manager will automatically send out a fax signal according to the set number of ringing times to start receiving. 2. Send fax 1, click print in any software, select "Bitware Fax Driver" to start the transfer dial fax window, if there are other different types of documents to add, click the "Attachment" button to operate. 2. Fill in the fax number of the other party in the fax number column, click the "Start Fax" button to send it automatically, and click the "Manual Transmission" button to pop up a window to remind you to pick up the microphone and pull the fax number (you can use an IP card to save money!) After the call, ask the other party to give a signal, and press "OK" when you hear the signal, and you can send a fax.

There is no electronic version, go and check it out.

Summary. There are usually the following reasons for this phenomenon: one is the poor contact of the pin soldering points of the power board components inside the TV, the second is the poor performance of the power board components, the third is that there is a problem with the CPU switch control circuit, and the fourth is that the protection circuit is faulty; In addition to the above reasons, it is also necessary to consider whether there is poor contact between the soldering joints of each component of the output circuit and whether there is poor performance of the components.

There are usually the following reasons for this phenomenon: one is the poor contact of the pins of the power board components inside the TV, the second is the poor performance of the power board components, the third is the CPU power switch control circuit is problematic, and the fourth is the protection circuit has a rubber barrier; In addition to the above reasons, it is also necessary to consider whether the soldering points of the pins of each component of the output circuit are in poor contact with pure plums, and whether there are poor performance of components.

How to solve this kind of problem?

System problems:There are bugs or errors in the system itself that cause automatic boot,It is recommended to restore the system of the Eggplant TV to factory settings or upgrade to the latest version,You can enter【Set Lu Na Yuanzhi】-System Configuration】-System Restore] or [System Upgrade] to solve the problem;

See what kind of problem it is, and then prescribe the right medicine.

Uh-huh. A factory reset is also possible.

Unplug the power.

Turn it back on and try it.