Come in and see my computer configuration, what kind of memory should I change or use? Bonus points

Dual-channel memory technology is actually a memory control and management technology that relies on the chipset's memory controller to function, theoretically doubling the bandwidth provided by two memory of the same specification.

It would be a little better to change to a double channel. Especially for integrated graphics, because the memory width of integrated graphics is mainly derived from system memory, when it is assembled into dual channels, the performance will be improved by about 20% (as an exception: even a 100% increase is not a big effect, which is limited by integrated graphics).

But if 1G (521*2) dual channel, it is better to put a 2G directly, after all, when the memory is not enough, more memory is the last word.

If conditions permit, it is recommended to buy 1g*2 to form a dual channel!!

AMD's CPU has an integrated memory controller inside, and dual-channel is a chicken rib for it, dispensable, and you can do it again.

Add an ADATA 2G DDR2 800 memory,** around 200 yuan.

Preferably ADATA DDR2667 1G, which is your original.

Because the two brands of memory modules are prone to incompatibility.

Add a 2G 1G can also be used, dual-channel is better, just use ADATA I use ADATA 2G Don't use Kingston's can be, he is generally overclocked!

It's best to buy a 2G plug-in, and it's better to buy a discrete graphics card. Replaced the whole host for a better and better one.

Add memory on the basis of the existing one, generally to the same frequency of the memory module, otherwise it is easy to crash, it is best to be the same brand, the same frequency, the same capacity of the memory module. Two 1G dual-channel memory is better than a 2G switch, but the premise is that your motherboard supports dual-channel, and two 1G memory modules of the same brand, the same frequency, and the same capacity!

The following is quoted, and I personally think the explanation is better:

First, you need to add the same type of memory, that is, the original DDR is used, and the later added memory should also be DDR, if it is DDR2, it will not work, and the slots are different.

Second, if the current memory frequency on the board is 800, the added memory must also be 800, or higher frequency memory, otherwise the original memory will be reduced due to the lower frequency of the later memory.

Third, check the Internet to see how much memory the motherboard can support for the total capacity, the previous motherboard supports 1G or 2G, and then the larger one has 4G, if the memory you buy is too large, you may not be able to use it.

Fourth, it's good to be enough, now the 64-bit system can support a total capacity of tens of G of memory, don't think that adding memory can improve the speed of the system, the main thing is enough, don't waste it.

Just buy the same one.

It is better that all parameters are the same, and it is best that even the brand is unified.

It depends on the state of your computer, if your computer slows down, or restarts frequently, it means that there is a problem with the memory, and you need to change it. Now the general memory needs to be 2G, if your memory socket is now 1G, then your other one must be plugged in with the same specification, otherwise the effect is not good. If you still have any questions, you can continue to consult.

If your CPU is more advanced and the memory is too small, you can consider changing or expanding. It's best to change to the same model of the same brand, and the compatibility line is better (if you expand the memory, the memory parameters you buy can be higher than your own ones, but not lower than the parameters of your own memory), and if your CPU is too low-end, changing the memory will not improve the running speed of the computer much.

Very good, please first talk about all the configurations of your computer, and then talk about the requirements for your daily use, whether it is a game or browsing the Internet or watching movies or drawings, and I almost didn't have a nosebleed if I didn't know a word about this question.

Your setup is a bit outdated, and it's no longer enough to handle today's big games, so if you want to run 3D games smoothly, you'll have to upgrade.

Your motherboard chipset is an NVIDIA GeForce 6100 with Socket 939 support for AMD dual-core processors, so it's easy and effective to upgrade.

For example: AMD athlon 64 x2 4200+(90nm) 315 yuan.

AMD ATHLON 64 X2 3800+(939pin dual-core) 295Ԫ.

These dual-core CPUs are more than enough for your needs.

In terms of memory, Kingston 1GB DDR400 190 yuan Hyundai 1GB DDR400 125 yuan, I personally recommend upgrading directly to 2GB to form a dual channel. It is also possible to upgrade to, i.e. 1GB + the original 512MB.

In terms of graphics card, since your motherboard has PCI-E X16, it can be easily upgraded to the current mainstream graphics card, such as: Rainbow Radium Wind 3650-GD3 CF** Edition 256M H12 399 yuan.

Weconex R4650-512GD3 game master 499 yuan.

Ӱ 9600GSO Enhanced Edition 499 yuan.

Sapphire HD3850 512M Platinum Edition II Generation 599 Ԫ.

After upgrading in this way, your computer will reach the mainstream configuration, and you can basically play all the current games.

Personal suggestion upgrade method: AMD ATHLON 64 X2 4200 + (90nm) 315 yuan + Hyundai 1GB DDR400 * 2 250 yuan + Yingchi 9600GSO enhanced version 499 yuan = 1064 yuan.

480 is because part of it is assigned to the set display.

It's not cost-effective for your computer to add memory,Now DDR400's memory is much more expensive than DDR2 800,Buy 2 1G DDR400 It's better to replace the fast motherboard,Recommend Onda A79GS 128M and Jet Wave Hummer HA07-Ultra,These 2 boards of onboard graphics cards all support DX10,Play Red Alert3 The medium and low image quality is not a problem,**599 and 799 respectively,Plus 2G DDR800 (120 or so)。 That's about 700-900 in total.

If you buy 2 DDR400 1G, it will cost about 400, and add a piece of independent graphics (300-400), it will also cost so much. A total of 700-800

Of course, you can also 2GDDR800 (120) + low-end AMD non-integrated graphics motherboard (300 400) + discrete graphics (300-400), which adds up to a little money. A total of 700-1000

Therefore, it is highly recommended to have Onda A79GS 128M or Jetwave Hummer HA07-Ultra, especially the latter, the performance is outstanding, and it is convenient for future upgrades, and then add a piece of 3470, 3650 and other groups of firefights, and then play games are not afraid, of course, you can also change the CPU, add 4830, play high-end games, and overclocking is also very good.

Add memory to 2G, the original two 256 or 512 memory are disposed of, replace 2 1G, 512-480 = 32, your current graphics card is only open 32M, the graphics card video memory is not the maximum open to the maximum (motherboard boot setup settings) Preferably more than 128M, because of integration, so the graphics card will eat the memory, ps1 floor said to change the graphics card.

GF6100 is good, you don't need to change the graphics card, this machine also adds a discrete display that doesn't match, and it can't fully exert the performance of the discrete display.

That's good.,There's no need to change to anything else.,It's no problem to double open World of Warcraft with all special effects.,It's not much of a card to open the main city of Warcraft alone.,I'm also using GF6100 now.

Except for the monitor and the case, everything else has to be replaced. The power supply also had to be replaced.

cpu amd 8450

Motherboard ASUS MZN-E

Memory: Kingston 2G DDR2 800

HDD Seagate 320g

Graphics: Sapphire HD4850

Display Samsung 953BW

Optical drive ASUS***

Keyboard ASUS Optical Case.

If there is money. Buy a piece for 4650, about 400 online. Computer City is about 450. Add another DDR400 512M65 yuan brand new.

If the money is not much. Buy a piece of 8600GT or 9500GT. More than two hundred online if the money is very small. Buy a piece of 7600GT, more than 100 attention on the Internet to pay attention to the memory can only buy DDR generation 400 graphics card interface is PCI

512 RAM shows the usage of public memory. Integrated graphics cards don't work well to play.

It is recommended to install a discrete graphics card.

Add a discrete graphics card. Add DDR 4001G memory to one piece.

According to the configuration of your computer, you can install the 32-bit operating system of win7. It is also strongly recommended that you install the 64-bit operating system of Win7, you only need to add a 2G equivalent model and memory module of the same frequency, you can install the 64-bit operating system of Win7.

The Windows XP operating system has been working continuously for 13 years, making it the longest-lived operating system to date. On April 8, 2014, Microsoft will officially end service support for Windows XP. You can continue to use it after the XP stops service.,Just like the mobile phone you bought.,The official website says that you don't update the flashing package!!

For the safety of the computer in the future, please upgrade the system of win7 or later.

3.Open the unzipped folder, double-click "autorun", and in the window that opens, click "Install".Can.

4.In the window that appears, the ghost image file path will be automatically added, select the partition that needs to be restored to, the default is the C drive, and click the "OK" button to install it automatically.

This configuration belongs to the mainstream configuration 7 years ago, if you want your computer to be smoother, it is best to add a memory of 2 GB ( Hynix DDR3 1333MHz ). This allows the computer to run on dual-channel memory, which will give you some performance gains.

This computer has been in use for at least 5 years. It doesn't matter if you add memory or not.

You don't have to do it at all, you pretend to be an XP and you can't use it with 4G.

Up to 3G, 32-bit XP is useless.

However, it is not recommended to add memory, which is effective for performance improvement.

If you want to save money, you can use it first, and if you have the money to change it, the computer is not expensive now.

Depending on what you need to do, you can add it or not. If you have money, add it.

The configuration of memory depends on the motherboard parameters, and the motherboard parameters are provided! If your CPU is E5800, it should be DDR2 800 Gen 2 memory. Select two 2GB memory sticks from the DDR2 800.

How much memory is the original, single root or two? The motherboard is estimated to have only two memory sockets).

Hello, your 945 chipset motherboard.

This motherboard only supports DDR2 memory at most, so the current DDR3 memory is unusable, this motherboard, up to DDR2 1066 specifications, you are drawing, I am too, with CAD or Maya, this kind of design software, the CPU and memory requirements are very high, and the graphics card is almost OK.

Then, your CPU is dual-core and four-threaded, supporting a 64-bit operating system! Therefore, it is recommended that you change the operating system to 64-bit, so that you can recognize the large amount of memory, otherwise your 32-bit system can only recognize the memory.

So, suggested.

First, the memory should be increased, and the system should be replaced with 64 XP, so that it will be replaced with a 4G 1066 DDR2 memory, brand Kingston, **300, so that 4G memory is enough for drawing design.

Second, the graphics card should be replaced, yours is an integrated graphics card on board, if you run large-scale mapping software, some are not enough, because it consumes system memory, reducing the overall performance of the system, it is recommended that you change a separate graphics card, HD6670 can be, ** at 400 yuan, brand Jaws.

After the above upgrades, the graphics performance of your computer has been greatly improved, and it is enough to cope with the graphics software.

If the budget is limited, just add a memory, it is recommended to change to a 64 system, and then change to a 4G memory, so that the integrated graphics card is enough, and your own graphics software is also enough.

Add a 1G memory to improve the running performance by about 20%.

If you just want to change the memory, Kingston's is relatively good, and most of the mainstream computers are 4G8G now. You can choose freely, if you can, it's best if your CPU and graphics card are upgraded, so that the whole machine is more coordinated to use.

Add 1G, 2G depends on your economic situation.

Add the same brand and the same frequency.

Buy a Kingston, DDR800 or DDR667, plug in the 2G one, don't pull this one.