TP LINK cannot connect to 50

Hello! 1. Which service provider does your broadband belong to?

2. Is it a dial-up network? If yes, what is dialing software? Is it possible to dial up with the dial-up connection that comes with Windows?

3. If it is a dial-up network, can your laptop and desktop be dial-up to connect to the Internet normally?

4. If it is an IP network, do I need to verify it twice?

Hope it solves your problem, good luck!

Hello! Keeps connecting, indicating that the web server cannot be found. (DNS, DHCP)1 Check the information of the router's WAN port to see if the information of the remote network server can be obtained. If it's empty or all zero, then there's something wrong.

2. Two aspects of the problem are possible: the server of the broadband provider prohibits routing; Your router is set up incorrectly. Above.

Is the router IP set right? After using the router, you need to set up each port of the router, remember to set it to something like that, different routers may be different, you can just look at the manual.

Take a look at VPI VCI. You can find it on the Internet!

If the working status of the router shows that the IP address of the WAN port is several lines, it means that the broadband external line has not been dialed. If it doesn't work, you need to go to the system log in the system tool to see, what error prompts, whether there is a password or password error, if so, it means that your broadband PPPOE dial-up password is wrong, after verification, modify and save and restart the router to try!

If a broadband fault occurs, you can use the following methods to troubleshoot the fault:

1 Use stand-alone dial-up, if you are using a router, please temporarily disconnect the router for testing;

2 Restart the modem and the computer;

3 Re-create the broadband dial-up connection and try to dial again. How to do it: Start the Program Attachment Communication New Connection Wizard.

If the self-troubleshooting still does not recover, you can log in to the mobile phone business hall Customer Service Broadband Fault Report for feedback, and we will get in touch with you as soon as possible.

After the router is installed, it cannot be connected to the Internet, and there are many fault points, so it is necessary to test it for a period of time to accurately find out the fault points and solve them in a targeted manner

1. Set up the dial-up connection according to the requirements of the operator, connect the stand-alone device to the operator's optical modem, and ping the operator's gateway or DNS server address after dial-up the Internet;

2. If the ping is not working, it means that the operator's external network network is not connected, just call ** to find the operator to report for repair;

3. If the ping means that the external network network is normal, it has nothing to do with the operator's network, and the fault is on the router, restore the router to factory settings, and then reset it to eliminate the fault.

4. If the router still fails after step 3 above, you can judge that the router hardware is faulty and you can only replace the router.

Are you broadband (dial-up) or leased (static IP) Internet access?

If it is broadband, set ---the WAN port in the router network parameters--- set the WAN port connection type--- select PPPoe, and enter the user name and password.

If it is a private line, you can also see the type of WAN port connection--- select static IP --- enter the fixed IP and local DNS assigned to you by the network operator (you can find it on the Internet), try it.

Hope it helps.

This is a router, right.,You need to set it up in it.,Follow the setup wizard step by step.,Don't worry about the port.。

In the browser, there is a wireless setting in the input, and the frequency band in the wireless setting or the band broadband is set to 20, and that's how my Dell computer is done. You can try.