How to use the vacuum film drawing machine belt to extend its service life?

Please pay attention to the following matters when using the vacuum film drawing machine belt:

1.When purchasing vacuum film tape, pay attention to the neat surface of the product, the belt is not distorted and deformed, and the teeth are full.

2.It is strictly forbidden to twist and turn the vacuum film belt, so as not to damage the skeleton material and affect the strength of the belt.

3.It is strictly forbidden to scratch the belt to avoid early damage to the belt.

4.Avoid contact with chemicals, especially strong oxidizing acids such as concentrated sulfuric acid.

5.Synchronous belt products should avoid long-term contact with oil and water as much as possible. (Note here: now the environment is polluted, the rainwater is weakly acidic, and contact with rainwater will also accelerate the belt loss).

6.When replacing the vacuum film belt, the tension of the belt must be reduced to the lowest before it can be taken out, and it is strictly forbidden to use non-professional tools to pry off the vacuum film belt with high tension.

7.Vacuum film belt is a fragile and consumable item, the same batch of belts many customers with a few months are fine, some customers use half a month or even a few days and a little shorter or even a day, the new belt is broken, we should pay attention to the method of use.

To give you a suggestion, we have changed it before, but the vacuum belt must choose the right model and manufacturer, otherwise it is better not to change, at the beginning we replaced the belt is always broken, the vacuum belt before the improvement can be used for 3 months, only 1 month after the change, through our analysis and research finally solved this problem.

How to use the vacuum film drawing machine belt to extend its service life? The vacuum film drawing machine belt should be kept clean and tidy during storage, and the sun should not be exposed to direct sunlight and not let rain and snow get wet. Prevent corrosion of acid and alkali oils.

The temperature of the storage space of the vacuum film drawing machine should be suitable, not too low or too high. In this hot summer, the maintenance of the vacuum film pulling machine belt should pay special attention, the summer is the season when the vacuum film pulling machine belt is easy to be damaged, especially the rubber conveyor belt should pay special attention.

We recommend that you try the following methods:

1. During transportation and storage, it should be kept clean, avoid direct sunlight or rain and snow soaking, avoid contact with acids, alkalis, oils, organic solvents and other substances, and be one meter away from heating equipment.

2. When storing, the storage temperature should be between -18 and 40, and the relative temperature should be between 50-80% relative humidity.

3. During storage, the product should be placed in rolls and should not be folded. During storage, the product should be turned quarterly.

4. For different types of vacuum film drawing machine belts, the standard layer should not be connected with the vacuum film drawing machine belt to use joints, and glue should be used.

5. The type, structure, standard and number of layers of the belt should be reasonably selected according to the conditions of use.

6. Generally speaking, the running speed should not be too large, and meters and seconds are preferred. Materials with large blockiness, good wear resistance and the use of fixed plough unloading equipment should be selected for low-speed operation as much as possible.

7. The diameter of the transmission drum should be reasonably selected according to the planning of the conveyor, as well as the matching of the conveying roller, the replacement roller and the groove angle of the idler.

To give you a suggestion, we have changed it before, but the vacuum belt must choose the right model and manufacturer, otherwise it is better not to change, at the beginning we replaced the belt is always broken, the vacuum belt before the improvement can be used for 3 months, only 1 month after the change, through our analysis and research finally solved this problem.