The master helps.,Ask for knowledge.,MMS about L7.

Just change your phone to factory settings.

1.First, call 1860 to make sure you have activated GPRS

2.Set up the access point: Settings - Connection Settings - Access Point. The licensed goods should have preset three access points, mobile Monternet GPRS, China Mobile MMS, and GPRS to connect to the Internet. The configurations of the three access points are:

a) Montnets GPRS: data bearer mode GPRS, access point name CMWAP, username none, prompt password No, password none, authentication ordinary, homepage.

Mobile IP address automatic, primary nameserver, secondary nameserver, server, port 80

China Mobile MMS: Data bearer mode GPRS, access point name CMWAP, username none, prompt password no, password none, authentication common, homepage.

Mobile IP address automatic, primary nameserver, secondary nameserver, server, port 80

GPRS to connect to the Internet: GPRS data bearer mode, access point name cmnet, username none, prompt password No, password no, authentication normal, homepage none, mobile phone IP address automatic, primary name server, secondary name server, **server none, **port 0

3.Once the access point is configured, you can use MMS, Monternet, and email.

a) MMS Settings: Info - Options - Settings - MMS.

The access point used by China Mobile MMS, MMS reception is always on and is extracted immediately when the information is received.

It should be a problem with the setting.,Go to a mobile phone forum to see it.,My classmate's machine is also water.,Later, you can send MMS.。

According to the third floor, set it up, and then call 10086 to activate the network, I am specifically setting up mobile GPRS in the business hall.

Mine also couldn't go up, and then called 1860 to ask. Asked several times.

I only set 4 steps.

1. Main Menu Monternet Web Settings New Entry Select Name Change Enter Name China Mobile WAP OK.

2. Homepage Change Enter the homepage.

3 **Server 1 Changes.

4. Access Point Name Change Enter CMWAP OK Done.

Set it up to see if it works.,If it doesn't work.,Just shut it down and restart it.。。 Mine is set up or not, it hasn't been restarted, and I'm ready to complain about it.,(*Hee-hee.......Later reboot, it's fine.

Parallel imports? If Mu Chop is licensed, then Xun Kuanchang does not need to be set, in the mobile phone set up in the smart posture, the initial setting, the main reset. Just do a factory reset and it's OK....

To be able to send and receive MMS, the requirement is that GPRS must be activated. The wallpaper does not move because it is not supported.

L7, L7i does not support live wallpapers, which is a common problem with Motorola's phones in this price range.

L7 does not support MMS! Upload via **! The access point must be CMWAP....It could be that you corrected the mistake.

Don't worry,,The traffic generated when sending MMS is included in the MMS fee,,I specifically called** asked So it's okay to have traffic

It's very likely that it's the wrong thing.

Internet settings for the Motorola L7.

GPRS settings.

1.Go to Access the Network - > Web Settings - > new entry.

2.Name: Monternets.

3.Home page. 4.Service type: WAP

5.Gateway: 6Port: 9201

7.Domain Name: Not specified.

8.Dial-up connection: 17266

9.Username: wap

10.Password: WAP

Access point name: CMWAP

MMS settings:1Access to the Internet" Web Settings" new entry.

2.Name: Mobile MMS.

3.Home: 4Service type: WAP

5.Gateway: 6Port: 9201

7.Domain Name: Not specified.

8.Dial-up connection: 17266

9.Username: wap

10.Password: WAP

Access point name: CMWAP

After the above is set, you have to enter the information to set it, information "middle function key" "select information settings" "multi** information settings" "server information" choose the first inverted "middle function key".

1.Service: Mobile MMS or your preferred name.

2.Server:

3.Web page settings: Select the mobile MMS 4Finish.

5.Select Mobile MMS in the current server page that is returned.

Grid machine! Put your phone back to factory settings.

Of course I supported it!!If you want to send and receive MMS, you need to turn on the GPRS function,,Generally, it is turned on by default.

GPRS settings.

1.Go to Access the Web - > Web Settings - > a new entry (or your existing one)2Name: Monternets.

3.Home: wap

4.Service type: WAP

5.Gateway: 6Port: 9201

7.Domain Name: Not specified.

8.Dial-up connection: 17266

9.Username: wap

10.Password: WAP

Access point name: CMWAP

。MMS Message Settings:

1.Access to the Internet" Web Settings" new entry.

2.Name: Mobile MMS.

3.Home: 4Service type: WAP

5.Gateway: 6Port: 9201

7.Domain Name: Not specified.

8.Dial-up connection: 17266

9.Username: wap

10.Password: WAP

Access point name: CMWAP

After the above is set, you have to go to the information to set it.

Info > Intermediate Function Keys > Select Info Settings > Multi ** Info Settings > Server Info > Select the first inverted "Intermediate Function Key".

1.Service: Mobile MMS or your preferred name.

2.Server:

3.Web page settings: Select the mobile MMS 4Finish.

5.Select Mobile MMS in the current server page that is returned.

Hit ** to 1860 to open GPRS!

Then set it up according to the parameters below!

Connection Name: CMWAP

Data bearer mode: GPRS

Access point name: CMWAP

Username: None.

Password: None. Homepage: The first time you want to send MMS content 1234 to 6666