High scores, sincerely ask why every time you turn on chkdsk to run to 68, it can t move

It can be judged that the system is corrupted due to file conflicts, and reinstalling the system should solve the problem.

It is recommended to install Kaba if you try not to pretend to be other killing soft, including ice blades and other security tools, Kaba is relatively strong, so the compatibility with other software is poor, that guy has always been famous for destroying the system (I am one of the victims). Hehe. ，

Never format it, that will speed up the death of the hard drive!!

Your hard drive does have a bad track, you can look for tools on the Internet how to fix the hard drive and fix it yourself. It's best to make a copy of what's inside before repairing it. If you don't know how to do it yourself, you can find a professional to do it, but it can cost a lot of money.

It is best to repair it yourself, and some repair tools are generally easier to use.

Probably the hard disk has a bad sector! Try to get out the required information, format the partition, and try to fix it if it doesn't work.

If you can't enter safe mode, there is something wrong with your system!

How long have you been stuck? Wait patiently for a while, if it doesn't work, enter safe mode, and delete the program if this happens after you installed any program before.

Reinstall the system to fix the system vulnerability antivirus, and also like this, format the relevant disk right-click Properties tool Check for errors in the volume Select all two to try.

Hard disk bad sectors. Try it with a bad sector repair tool.

Find a professional computer and repair the hard drive.

Disk Check Tool to try.

I encountered this problem and reinstalled the system.

If you are in the lower right corner of the file corruption prompt you use the chkdsk tool, if so, with this tool is not needed, please see below.

This prompt is caused by too many temporary files in the system, or a disk problem, take a look at the following methods.

1) This prompt appears in the lower right corner of the taskbar (a file is damaged, please run to use the chkdsk tool to repair), it is generally caused by too many junk files in the system, mainly the junk files generated by the Internet, just clean it up.

Open a web page, click on the "Tools" menu on Internet Options under the "General" tab and click on "Delete cookies(i)", delete files in the "Delete Files" pop-up, click on "OK" (including offline files), and restart your computer (no need to use the chkdsk tool that prompts).

2) The system comes with the disk repair method: (If the fault is still there, that is, there is a problem with your disk, please repair the disk, and repair each disk).

The specific steps are as follows: select the drive letter in My Computer, right-click to select Properties, select "Tools Start Checking" in the pop-up drive properties window, and select "Automatically Repair File System Errors" and "Scan and Recover Bad Sectors", and then click Start, the scanning time will vary depending on the disk capacity and scanning options (after doing the above method, a box will pop up, the point is, automatically shut down and repair at boot).

3) If it still doesn't work, it may be that there is a problem with the hard disk, try to repair it with software. Bad sectors on the hard drive will lead to corruption or loss of computer system files, computer failure to boot or freeze. Hard disk bad sectors can be repaired using NDD Disk Utility or Scandisk.

4) If the fault persists, please restore the system or reinstall it (it is still not possible to format the hard disk and repartition and reinstall it, if it doesn't work, you will have to replace the hard disk, or overhaul it).

Select drive letter C in my computer, right-click to select properties, select "Tools Start Checking" in the pop-up drive properties window, and select "Automatically repair file system errors" and "Scan and recover bad sectors", and then click Start, the scanning time will vary depending on the disk capacity and scanning options (after doing it according to the above method, a box will pop up, the point is, repair after automatic shutdown at boot, win78 select the disk check button according to the plan).

Uninstall all the related software of 360 and delete the folder"c:\windows\csc"

This may be the boot optimization of 360 to shield.

360 itself also has tools to repair system files.

The tool in the C drive properties seems to have a disk to check the error, you can choose both of them to try.

Do not use chkdsk when there are files to open. Because chkdsk is designed to assume that the disk files are turned off. When a file is opened, the corresponding MS DOS will modify the file allocation table and directory structure.

This change is not necessarily immediate, and changes to the file allocation table and directory structure occur at different times. Therefore, if chkdsk is run while the file is open on disk, the inconsistency between the directory structure and the file allocation table will be interpreted as an error, resulting in data loss or file system corruption. Therefore, in running other programs, such as Microsoft

Windows, never run chkdsk.