CICSO switch configuration command translation

One is the mark before login.

The slogan banner login is the banner login after the connection, and one is the name displayed after login, that is, it is displayed to the user, which is used to explain what the route or exchange is used for, what are the consequences of illegal login, etc., all of which are displayed when telnet is in the past.

Mess around, post a picture from Weibo.

Well, I'll give you a picture back too.

Sorry, it should be sysname xdjsc-5700, but I know you don't mind ha.

Trunk (port aggregation) refers to port aggregation, which is to combine two or more physical ports into a logical path by configuring the settings of the software to increase the bandwidth between the switch and the network node, and combine the bandwidth belonging to these ports to provide a port with an exclusive high bandwidth that is several times that of independent ports.

A trunk is an encapsulation technology that is a point-to-point link where both ends of the link can be a switch, a switch and a router, or a host and a switch or router.

Based on the trunk function, it allows switches to switch to switch, switch to router, host to switch or router to transmit simultaneously through parallel connections of two or more ports to provide higher bandwidth and higher throughput, greatly providing the entire network capability.

In the line of voice-level applications, trunk generally refers to the "backbone network, trunk line", that is, the connection circuit or channel between two switching offices or switches, which is the transfer between the devices at both ends as the transmission link of signaling and terminal equipment data.

The 1st floor is actually right, but the corresponding ios version may be different, I don't have a command that can configure the packaging protocol when I configure it on the c2960-lanbasek9-m version of the machine, and I can do it with the configuration on the 1st floor.

You don't know how to do it, the encapsulation protocol is only required by the Layer 3 switch or router, and the Layer 2 switch does not need the encapsulation protocol.

The command to manually specify a neighbor in the NBMA environment is.

Asking this kind of question is like asking "Who are the Chinese historical figures?"."Same.

There are a lot of switch commands , not sure what you want to know.

For example, VLAN link aggregation and so on.

Hello!show runing-config in privileged mode (as shown below).

Press Enter to show the next line and the space to show the next screen.

Hope it helps!

Port configuration, and access control show run routing protocol show ip route