How can the air of the Aili brand lighter not be charged

1. Whether the steering wheel is in a deadbolt state. The solution is simple, as long as you hit the steering wheel hard and twist the key at the same time, you can generally unlock the steering wheel lock quickly, and the ignition is an instantaneous thing.

2. Did you not return the gear to P gear when you parked? Think about it, if the D or R gear can be ignited, the jump of the vehicle at the moment of ignition is undoubtedly a huge safety hazard. Therefore, for automatic transmission vehicles (AT, CVT, AMT), manufacturers will preset this mode, and repeatedly inform in the manual:

Make sure the gear is in the P position when ignition.

3. One-button start sometimes encounters the trouble of power loss of the smart key, obviously the key is in the car, but the instrument always shows 'key matching error', this situation is likely to be the power loss of the smart key, and the start system can not sense the weak radio waves emitted by the key. Therefore, it is recommended to pick up the smart key and put it on the start button, and then press the button to start.

4. Check whether the battery has electricity. If the ignition is not ignited, it may be due to the loss of power or the expiration of the battery life due to the long-term headlights have not been turned off, and the battery is generally replaced in time according to the maintenance manual.

5. See if there is oil. If the fuel gauge shows that it is below the red line, it will not ignite. At the same time, pay attention to the quality of the oil. There have been car owners who found that there was water and mud in the fuel tank after disassembling the car, and with such oil, it is impossible for the car not to break.

6. No antifreeze is added.

Some car owners add water or inferior antifreeze to the car, resulting in a particularly cold winter, causing the entire waterway to be frozen, the engine to be frozen and cracked, resulting in the car water pump can not operate, can not catch fire, and injure other parts of the engine.

See if the lighter switch is turned on normally, and then check that the size of the lighter is not adjusted. Then look at the ignition port to see if there is any foreign object blockage.

2. Because the inflator port is not aligned or the model does not match, it is not filled at all but the gas inside is discharged.

After the lighter is just inflated, the pressure inside the lighter is relatively low due to the low gas temperature, so the flame will be relatively small. Generally, after a while, it will return to normal. If it still doesn't work, you can only disassemble the lighter and readjust it.

Definitely didn't fill it in. Here I would like to ask you, did you deliberately adjust the screws during the previous use???

If you have adjusted it before, then before inflating, turn the screw towards a low heat (the symbol is "—", do not screw it to the end at once.

If not, then please run out of gas, do not inflate by feeling. Otherwise, don't light the fire and run out of gas.

Note: If the lighter has gas, you go to inflate, it has a backflow, there is a buffer. Maybe the original gas in the lighter will be released, and no matter how much you charge, it will be in vain. Therefore, it is better to wait for the air pressure in the lighter to be zero (normal atmospheric pressure) before inflating.

Inflatable, bottom up, when liquid comes out, it is full. There shouldn't be much else to pay attention to.

What brand, each brand-name lighter must use the corresponding brand of special gas, such as Dunhill to use Dunhill special gas, Dupont to use Dupont special gas, even zippo has blue fire gas fire machine to use zippo special gas, these gases are expensive, Dupont and Dunhill gas are disposable, each bottle of gas can only be flushed once for 50 yuan, a time can only be used for less than a month, equivalent to more than 50 yuan per month.

You must not have misaligned it correctly when filling the gas, so that the air filling hole part is leaking, so use a knife to pluck it with a flat mouth.

A windproof light machine will not be outgassing like a one-yuan light machine. You must have pushed too hard to bend the gas port more or less or something, (you hear the slightest sound). It doesn't matter, pick a change to change the size of the gas outlet and it should be fine.

The middle one can adjust the size of the fire, you use a knife or a screwdriver to rotate in the opposite direction, slowly adjust not too much at a time, it should solve your problem.

The quality of the gas tank of an inflatable lighter determines whether it can be inflated smoothly. The quality of the gas is the condition of whether it burns smoothly, and the pyramid card is better, so you can give it a try.

The Dupont lighter is to see what color paint is inside the inflated nut, and then go to the specialty store to buy the same color gas canister. Because his gas nozzles are all different. The special gas for the Dupont lighter is too expensive, and a bottle of gas is disposable, ** between 25 and 35 yuan.

And it can only be used for about 20 days at a time. It is recommended to buy the American "Ellie" brand (generally sold in shopping malls), a bottle ** between 20-30, can be poured n times, and can be used for more than a year. If you are saving, why waste it.

When filling the gas, it is enough to add a rubber ring.

Brother, your professional is professional, I originally used that 28 yuan disposable, in fact, there are a lot of fake ones even in shopping malls, and the quality is not very good, look carefully at a lot of scum!! I suggest that you just buy the cloak of the gas, in the mall, 38 yuan, okay!!

When buying a gas cylinder, there is a multi-change mouth, you go to buy a bottle of Hong Kong-made Aili brand gas cylinder with a multi-change mouth to flush.

After the gas lighter is filled, it will be used again after a while. About 5-10 minutes.

Or, deflect all the gas and wait a while before re-inflating.

It is recommended to use the brand, Hong Kong Aili brand is good, it is recommended to use.

Your situation is called fire shrinkage, and there are two kinds of problems, 1There is a problem with the fire sponge, 2The lower temperature of the weather will also cause the lid to be opened several more times before adjusting to the appropriate size of the fire head, which is not a big problem.

Specializing in the repair of all kinds of high-end lighters, Dupont, Cartier, Dunhill, ZIPPO, Givenchy, all kinds of electronic windproof, direct lighters.

I didn't rush to breathe. Or the quality of the gas is too poor!