How many kilometers is the run in period of Octavia 2016 automatic Zhixing, and what are the precaut

The vehicle will have a cold run-in process before the engine is loaded. After buying a new car, you can use it normally, mainly because there should be no sharp acceleration and sudden braking in the new car stage, and the vehicle should not have too much weight. There is no need to deliberately control the speed, as long as it does not violate the traffic regulations and speed.

There is also running high speed, the so-called running high speed refers to running the speed of the engine, not the top speed of the vehicle. After a period of use of the vehicle, if the road surface conditions allow, pull the speed of the engine, do not deliberately do it, simply put, it is low gear and high speed, but the gear is not too low, I personally think that the speed can be kept at 4500, do not go to pull the speed, it is very dangerous.

The wear and tear of the new car is relatively large, try to step on the accelerator slowly when driving, the speed should not be too fast, do not exceed 100, must be the first to pull the high-speed, this high-speed is not how fast the car should run, but the engine speed, try to run a little harder, more than 2500 and then shift, so that the run-in period because of the low speed of the formation of carbon deposits, to achieve the purpose of "cleaning the cylinder"! The transmission has to run a section of each gear, which can avoid excessive wear and tear in individual gears, and the automatic transmission can be linked to D gear to run! [If you have a problem with the car, ask the car master.]

4S shop professional technician, 10 minutes to solve. 】

Regarding the run-in period of the Octavia hand self-integration you consulted, it should be 1500 kilometers, and after 1500 kilometers, you need to pull the high-speed. There is also the problem of running high speed during the run-in period, which is okay, as long as you pay attention to a point, no matter how many gears as long as the engine speed does not exceed 3000 rpm.

As for the problem of manual automatic high-speed, it should be noted that the key to pulling high-speed is to increase the speed of the engine in each gear, rather than simply increasing the speed, so the manual automatic car will put the transmission gear in manual mode, and maintain the speed at about 4000-4500 rpm in each gear, and insist on 3-5 minutes respectively. Then, go to the 4S shop for maintenance. If you change the engine oil before pulling the high speed, you have to change the oil again after you pull the high speed, because the oil has a stronger cleaning ability when the high speed is circulating, and the oil is the dirtiest after pulling the high speed, just change it during maintenance.

After these steps, your car's engine block, pistons, crankshaft, propeller shaft, transmission gears, and moving parts are more deeply connected.

1500 km or so. 1-500 km is the initial run-in, the speed should not be too fast at this time, generally below 70-80 km, and the speed should not exceed 2200 rpm; 500-1000 kilometers is the mid-term run-in, the maximum speed can be appropriately increased, generally can reach 90-100 kilometers, and the speed is still below 2500 rpm. Increasing the speed appropriately will not only not affect the engine, but can promote the running-in, and you can see if there is any abnormality when the speed is increased again; 1000-1500 km is the later run-in, and the speed can be increased to less than 120 km.

Because running-in is a gradual process, it must be gradually increased. The speed should not exceed 3000 rpm.

The processing technology level of the generation car is already very high, and the significance of the run-in of the car during the run-in period is greater than the significance of the run-in of the vehicle itself. There is not much difference between manual, automatic, automatic manual, DSG, CVT, AMT, etc.

Generally speaking, the first 1000 kilometers of the new car is counted as the run-in period, and the speed should not exceed 100 kilometers per hour during the running-in period, and the speed should not exceed 2500 rpm. Especially for the first 500 kilometers, it is better to keep the speed at 60-70 kilometers per hour.

The gasoline engine cars produced now basically do not need to be run-in, but considering that it is your own new car after all, it is better to pay attention to it at the beginning! In addition, the car run-in of the diesel engine is very important, so I won't say much about it here. A few tips for you:

Clause. 1. Don't let the engine speed be higher than 2000 rpm when driving. I feel that if the Octavia engine is higher than 2000 rpm, the speed must exceed 80 kilometers per hour, so it is not simple to control the speed over 80.

The run-in mileage is 500 km, but more is better.

Clause. Second, start a little slower, don't start in a hurry, don't accelerate in a hurry when driving, remember that the speed does not exceed 2000 rpm.

Clause. Third, when it comes to the first insurance, you must go for maintenance.

Clause. Fourth, it is recommended that the maintenance of the first two years be done in the 4S shop, because if you don't do it, the manufacturer is generally regarded as giving up the right to claim, so the car must have quality problems and the manufacturer will not repair it.

Clause. 5. After driving 2000 kilometers, it is recommended to pull the high speed on the highway to increase the engine speed to more than 3000 rpm, but pay attention to safety. The process doesn't have to be too long, just 10-15 minutes and then repeat several times.

My own car won't pull when it reaches 4200 rpm, I can't help it, the engine starts to roar, hehe. Remind yourself here and pay attention to safety.

2. After parking, try to hit the direction correctly and then extinguish the car, or many cars with steering self-locking protection, and then you think that the car key may not be able to be screwed, and the driver will panic. The solution is to turn the steering wheel back and forth when you twist the key, and that's it. A common mistake made by newbies.

3. Try to use overdrive as little as possible. It's not an emergency, try not to overdrive. This gear is forced to downshift the gearbox, so as to increase the torque to achieve the purpose of rapid acceleration, so in exchange for high fuel consumption.

4. It is recommended to take a scratch insurance for a new car, because it is impossible to drive without a small bump, but it is not a big problem, and the insurance company will not compensate for it. Therefore, with scratch insurance, you can repair the scratches in time, after all, it is a new car.

5. When the wiper is used, it is recommended that it is best to spray some water, not dry scraping, which is easy to damage the wiper blade. In the future, if the wiper blade is broken, it is recommended to buy the rubber strip online and come back to change it yourself, which is much cheaper than the 4S store.

Just think of this silver first, and if you have any questions, you can ask me again.

The run-in period of the car refers to the initial operation stage of the new car, which is generally 1500 to 3000 kilometers, which is the basic mileage to ensure the full contact, friction, adaptation and finalization of the parts. During the run-in period, the car has the characteristics of fast wear and tear of parts, easy to fail, easy deterioration of lubricating oil, and large fuel consumption, the driver should pay attention to load limit, speed limit, selection of high-quality lubricating oil, "cold shake and slow rotation, low speed heating", slow start, slow refueling, timely shifting, slow braking, strict control of water temperature, and frequent inspection of the temperature of the transmission, drive axle and wheel hub.

Although the car has been run-in according to the regulations, the surface of the parts is still rough, and there are more metal particles falling off between the new parts, which aggravates the wear. There are certain deviations and hidden dangers that are difficult to find during the processing and assembly of the parts, and it is very likely that the parts will be stuck, heated and leaked during the running-in period. Due to the small fitting gap of the parts during the running-in period, the quality of the oil film is poor, the temperature rise is large, and the oil is easy to oxidize and deteriorate.

In addition, more metal particles are mixed into the engine oil, which reduces the quality of the engine oil. In order to ensure the operation of small load during the running-in period, at the same time, the large friction resistance between the parts also increases the fuel consumption. At the expiration of the run-in period, the lubricating oil should be replaced, and the vehicle should be fully adjusted and tightened to achieve normal technical status.

Another one does not read the manual, the new car run-in is divided into 2 stages, the first stage of the main run-in engine is 0-1500 km, automatic transmission model engine speed is not higher than 4500 rpm; The second stage is a run-in of 1500-5000 kilometers for the whole car, and the engine speed of the automatic transmission model is not higher than 5800 rpm.

My manual, the manual only writes 1500 kilometers.

The run-in mileage of new cars is generally 1000 km to 3000 km. The run-in period has a great impact on the service life and fuel consumption of the car, because the wear and tear during the run-in period will cause scars on the surface of the parts, and the rough scars will increase the friction resistance, and the scars will also accommodate metal filings, oil sludge and other particle-containing debris, which will continue to expand the wear and tear in the movement, and eventually cause failure, so the run-in quality determines the life of the vehicle. 6 major contraindications during the run-in period1

Avoid emergency braking: emergency braking not only makes the braking system in the run-in impact, but also increases the impact load of the chassis and engine, in the first 300 kilometers, it is best not to emergency braking. 2.

Do not overload: If the new car runs at full load during the run-in period, it will cause damage to the parts. Therefore, within the first 1000 kilometers, the general load capacity should not exceed 75%-80% of the rated load.

3.Avoid running long distances: If the new car runs long distances during the run-in period, the continuous working time of the engine will increase, which is easy to cause wear and tear of parts.

4.Avoid high-speed driving: there is a speed limit during the run-in period of the new car, the domestic car is generally within 40-70 kilometers, the imported car is generally within 100 kilometers, when the throttle is fully open, the speed can not exceed 80% of the maximum speed, and pay attention to the engine tachometer and speedometer while driving, to ensure that it works at medium speed.

Under normal circumstances, the engine speed should be 2000-4000 rpm during the run-in period. 5.Do not change the oil too early:

The initial oil of the car is a special lubricating oil for the run-in period, which requires low viscosity, good heat dissipation, superior cleaning and oxidation resistance, and some car factories have also added abrasives that are conducive to running-in, so the oil during the run-in period only needs to be changed according to the time specified by the manufacturer, and should not be replaced too early. 6.Don't start without hot cars:

The so-called preheating is actually to give the engine a full lubrication time, especially turbocharged models, which must be warmed up before starting, and the lubrication time should be at least one minute or more.