How to park an automatic car?

Find a parking space, stop the car, step on the brake, hang the P gear, pull the handbrake, release the brake, turn off the flame, and lock the door.

There are two types of automatic cars you are talking about, 1 is a pure automatic car, and 2 is a manual car with 1 body. Let's start with the automatic ones – they are P (Parking), R (Reverse), N (Neutral), D (Travel), 3-2-1 (Low, Long Climb and Undummy). The specific steps are:

1) Step on the brake pedal to start the ignition switch, the dashboard shows OK, the brake pedal can not be loosened at this time, pull the gear lever to D gear, release the brake to refuel, and automatically move forward according to the size of the oil you give, you just need to step on the brake or refueling pedal according to the road conditions OK, no need to change gears back and forth. It is also possible to coast from D to N while driving, but it is not very reliable because it can cause the brakes to soften and not save fuel. (2) There are also two kinds when parking, 1. Stop for a short time, step on the brake and put it into N gear.

2. When parking for a long time, step on the brake and put it into P gear, and pull the handbrake. (3) When reversing, step on the brake to shift to D gear and reverse, (according to the different car brands and models, there are two kinds of reverse locks without reverse locks, and some must hold down the button when hanging reverse gears in order to hang into reverse gear). 4) The use of 3 gears can be determined according to road conditions.

Let's talk about the manual self-1 body - the total and automatic ones are the same, but there are multiple manual gears. It can switch back and forth between D gear and manual gear, and when using manual gear, it can be increased according to the speed of the car, and when you press the brake, it will automatically downshift. The biggest advantage of automatic transmission cars for beginners is that there is no clutch, there is no need to change gears back and forth, and the road conditions can always be inspected, reducing the accident rate.

The start of the ramp is the most noticeable, and there is no rolling.

The correct way to park an automatic car is:

1. Brake and decelerate to the stopping speed; 2. Hang N gear after stopping; 3. Tighten the handbrake; 4. Release the foot brake to confirm that the vehicle is stopped; 5. Step on the foot again and hang the brake into the P gear; 6. Turn off the fire. There are N gear and P gear on the automatic gear, N gear is temporary parking, P gear is used for long-term parking, automatic transmission parking is only hung N gear car is easy to slip slope, so only when the car is stopped in a short time and the body is completely stopped, N gear can be used alone. The difference between P gear and N gear is also that there is a gear engagement in the gearbox when P gear, which is not only used for parking, but also helps the vehicle brake.

When the automatic car is parked, you need to press the brake to the end, and then you need to put the gear to the P gear, otherwise the vehicle will slip when parking for a long time, and the specific parking steps are as follows:

1. Press the brake pedal of the automatic transmission car.

2. Until the vehicle is smoothly parked on a safe road.

3. Place the gear of the automatic transmission car in the P gear.

4. Pull up the hand brake of the car.

5. Press the car's one-button start button to turn off the engine.

The correct way to stop in automatic transmission: 1. Step on the brakes and slow down to stop; 2. After stopping, hang into N gear; 3. Tighten the handbrake; 4. Release the foot brake to confirm that the vehicle is stopped; 5. Step on the foot brake again and hang into P gear; 6. Turn off the fire and leave.

First of all, we see in the automatic gear, there are N gear and P gear are provided for the driver to stop, where N gear is temporary parking, and P gear is designed for long-term parking. Automatic transmission parking uses N gear, because only N gear is hung, and the car is easy to slip downhill. So stop for a short period of time, and use N gear when the body comes to a complete stop.

Generally speaking, the usage given to us by the manufacturer is: direct P gear, pull the handbrake, turn off the engine and leave. All automatic transmission models support P gear to stop and pull the key, except for some automatic transmission models that cannot pull out the key when in N gear.

I believe that many car owners also park in this way, but if you park in this way, then it may feel very difficult when you drive away next time, which is related to the working principle of P gear.

Automatic car parking steps: There was a controversy before that the automatic car is first hung in the P gear and then turned off, or first turned off and then hung in the P gear, the correct parking steps for the automatic car are: you need to step on the brakes first and wait for the car to stop slowly, first hang the gear from D gear to N gear, then pull up the handbrake, and finally turn off the ignition, and then hang the gear to P gear after the ignition.

Nowadays, the automobile technology is very mature, and the automatic transmission of the car can be turned off in both N and P gears under normal circumstances, so that it will not cause damage to the car engine.

Photo by Pacific Automobile Network Q&A).

Here's how to park the automatic transmission:1. Turn off the electrical equipment in the car before turning off the ignition, so as to avoid the battery loss caused by long-term use.

2. Avoid obstructing other people in the parking position and affecting the next drive.

3. Turn signal before parking and observe surrounding vehicles and pedestrians.

4. After the car stops, return the gear to N gear.

5. After pulling up the handbrake, push the gear to P gear to turn off.

The starting steps for an automatic transmission car1. Step on the brakes and slow down to stop.

2. Pull the gear from D to N.

3. Tighten the handbrake and turn off the fire.

4. Release the foot brake, but don't turn off the power.

5. Press the foot brake and pull the gear from N to P.

6. Release the foot brake.

7. Turn back the key, turn off the power, and pull out the key.

Automatic Transmission Correct Parking Steps:

1. Step on the foot brake to stop the car;

2. Hang the gear from D gear to N gear;

3. Pull the handbrake and turn off the fire;

4. Release the foot brake, but it is recommended not to turn off the power at this time to ensure that the car can completely stop under the action of the handbrake;

5. Press the foot brake and pull the gear from N gear to P gear;

6. Release the foot brake.

7. Turn back the key next to the key, turn off the power and pull out the key.

The automatic transmission parking method is: step on the brakes, slow down to stop; After stopping, hang into N gear; tighten the handbrake; Release the foot brake to confirm that the vehicle is stopped; Press the foot brake again, engage in P gear, and turn off the ignition. This method requires first putting the gear in N gear, then tightening the handbrake, then putting the foot brake, pressing the foot brake and then engaging in the P gear, and then turning off the engine.

Introduction to automatic transmission:Automatic transmission usually refers to the automatic shift mechanism of the car, and the control system of the automatic transmission automatically selects the appropriate gear according to the speed and load of the engine when driving, thus replacing the subjective judgment of the timing and shift operation of people. Automatic cars have six gears, from top to bottom:

p、r、n、d、s、l。

Hello, the automatic transmission car parking steps have the following points:

1. When the car stops, slow down first, step on the brakes, and hang into N gear, here do not directly shift to P gear and then turn off the engine in order to prevent the gearbox from passing through R gear in the engine starting state, so as to reduce an impact.

2. Turn off the fire, the electricity will not be cut off at this time, because it is not hung into the P gear, and the key cannot be pulled out.

3. Tighten the handbrake, release the foot brake, here you can feel the force has acted on the handbrake, after the car is stable and stationary, and then change to the P gear, so as not to act on the P gear.

4. Turn off the power and pull out the key.

Hope it helps!