Problems with GUNPLA making

Model scissors scissors] (gold pliers are very expensive, this one can be replaced with scissors, although the feel and effect are slightly worse).

Pen knife] (This is a must-have, mainly to sharpen the water spout, or do some delicate operations.) For example, paste-paper. For the prime, the pen knife will definitely leave a mark, and it will be better to scrape it vigorously with your fingernails, or use a marker to make up the color.

In order to achieve perfect trace-free, it is necessary to use 800, 1000, 1200 sandpaper and then continue to polish with coarse and fine sanding paste. But it's troublesome, and it's not suitable for the prime group)

Outline pencil (Ticking the outer armor of the Gundam can make the model more three-dimensional.) A general pencil is good enough to wipe the line with your fingers or an eraser. Wipe out excess ink to avoid lines that are too thick and unnatural.

The high-end ones can try to seepage, which is convenient and has a good effect, but it is not easy to get started, and you need to have a certain understanding of paint. You can take your time).

Marker] plastic hard nib, the first use of the pen needs to press down on the tip to produce paint. It is used for small areas of color complementing, such as the power pipe of the Gundam, metal spouts, etc. This thing is not meant to be used for a wide range of coloring. The pen marks are very noticeable.

Protective paint] This is the last step, whether it is spray paint or plain group, it can be sprayed or not. There are many types of protective paints. Varnish, semi-matted, matted.

The most commonly used is matting paint, which is oily and water-based, and is generally spray filled. The function is to make the model reflective and soft, eliminate the plastic feeling, slow down the oxidation of the plastic, protect the sticker, and protect the paint surface. But it's also not easy to get started, and novices are everywhere.

This is more demanding on the environment and techniques, the air humidity is greater than 60% and can never be sprayed, the distance of spraying is about 15cm, spraying too thick will cause white paint, too thin and ineffective. So you still need to watch more tutorials for this, and the main thing is to try it yourself. When you are not sure, do not spray the model directly, and the spray will basically be wasted.

It is recommended to use the runner for experiments, or if there is a model that has been broken in the past, it is also possible to use it as an experiment.

It's OK to say upstairs, but markers are also essential! , it's too cumbersome to paint, so the marker is good. My experience was similar to that of the landlord, but I didn't move a few boxes. Hope it helps the landlord. The detailed encyclopedia has better suggestions and is also easy to understand!

If you want to learn the tricks, go up here, it's enough for you to watch slowly!

Pay attention to the handling of the nozzle, be patient, especially when the vegetarian group, it is best to buy a nozzle pliers.