-
First of all, after booting up, press a certain piece, generally the boot will be displayed, select the boot boot address, or you enter the BIOS to change to boot from the optical drive first. Put the disk into the optical drive and reboot,That's it,Follow the prompts,Install it will let you format the C disk,Then the system can be installed on the C disk,Only the things of the C disk will be deleted,So be sure to do a good job of the C disk backup before installation。
As for the driver, after you install it, you can go to the official website and download it yourself, or install a driver wizard or something, you can automatically install the driver with one click.
-
1, you have to back it up... drives, especially special. (If you change the XP, try if the driver can be used, you can't search for it).
2,It's better to carve an MSDN installation version than a clone version of the XP3 system (if the installed version of the installation integrates SATA driver,It's better,Don't be afraid) ((installed can't be used,That is, the desktop system can't be used normally to the notebook,It's miserable)
3,The notebook's built-in function (the driver is backed up,XP try,Some can be used)4,If you are a set display + independent display (even if the independent display has a driver,XP,But under XP can only be set display,XP does not support dual graphics card switching。
-
I heard that there are a lot of wise people here, thank you first!! Question added: back aiyinxiaoyan:
1. In the "My computer system volume information" folder, the Chinese name can be translated as "system volume information".
-
Check if the graphics driver is installed!
-
There is a problem with your current system, see if the driver is installed, whether the hardware acceleration is not turned on, and the hard disk partitions are sorted out.
-
flash also has the problem that the graphics card is too old, the second question? It's possible that it's something that's inside your computer.
-
There is a problem with your driver.,Shutdown and crash may be that the chipset is not installed well Or it may be that the power management is not installed well,As for the first situation you said, it is estimated that the driver is not installed.,It is recommended to reinstall the driver.,It must be fully installed。 There should be a corresponding driver between the hardware and the system, that is to say, a set of drivers corresponds to a hardware and system, for example, the same computer system is installed with different drivers. If you can't solve the above problems, you have to reinstall the system and install the new driver again.
-
If you don't have it before reinstalling, it should be a problem with the new system, you have a lot of problems with this system, and there is a problem with the graphics card driver before you install it, so change the system disk.
-
Hello landlord.
You're just memory poisoned, just put down the power and it's as follows.
First, take out one of the electrons in the motherboard, and then take out the memory as well, and second, let it sit for a few minutes before putting it back on.
-
The graphics driver is not installed.
Obviously your next driver wizard to see what the driver is not installed.
-
There are generally the following possibilities:
1: The problem of installing the disc may be that it is seriously worn and cannot be read out after reading;
2: The problem of optical drive is generally the aging of the laser head and poor disk reading! The solution is to disassemble the optical drive, clean the laser head with alcohol cotton, and increase the power of the laser head, the method is to use a small screwdriver to adjust the laser head clockwise a little bit, as long as a trace is enough, too much is easy to burn the laser head!
Also, get a brand new optical drive!
3: Memory problem. This has a lot of problems in the previous SD memory, because SD has a lot of grinding strips, how you use DDR or DDRII memory, just try another one!
In the early days, there were also a lot of grinding strips in the DDR, and there is also a possibility that your memory is not genuine!
I remember my wife asking me a question, "Do you have any friends?" I thought about it for a long time, and said, "I don't have many friends, just a few," my wife said confidently, there are many of my good classmates and those who are at home, and I know each other quite a lot of people who work in the society, and they are all my good friends! After a long time, we both had a hard time, and it turned out that it was my friends who helped us get through it. >>>More
In addition to repairing with a traceless real repair tool, there are two other ways to try:1Click "Start" "Run" Enter %systemroot% system32 OK "Open the traditional DOS command line window, enter the following commands respectively and OK: >>>More
Depending on the recipient of the gift, the relevant materials and procedures required for the gift will be different. For example, children, bequests, and gifts to others. What is it exactly? >>>More
There are ones in every district, so I'll just say my clothes. >>>More
love me,love my dog.Love me, love my dog.
like mother,like daughter.There is a mother and there is a daughter. >>>More