How to connect 2 TVs with one TV antenna

Two relatively simple methods for reference:

One is to buy a two-point distributor, first connect the TV signal cable to the input interface of the distributor, and then use the TV signal cable to connect the two output ports of the distributor to the two TV antenna sockets. This method is to distribute the TV signal evenly between the two TV sets, and the TV signal has a certain attenuation.

The second is to buy a one-point brancher, connect the main signal to the large-screen TV (such as the living room), and connect the other to the small-screen TV in the bedroom. This connection method can ensure that the reception quality of the large-screen TV is good, the signal attenuation is reduced, and there is no obvious impact on the viewing effect.

The TV antenna is connected to the input terminal (in) of the splitter, and the two output terminals (out) of the distributor are connected to 2 set-top boxes, and the 2 set-top boxes are connected to 2 TVs respectively. The programs of the 2 TVs can be controlled separately through the set-top box remote control.

Branchers are not OK, because they are digital signals, and general branchers are not OK.

Just buy a power divider!! Now I'm using !!

You can't look at it that way, you still have to buy a special high-frequency head! That's a hundred bucks! You might as well set up a cauldron.

Buy a brancher, and you're good to go.

The satellite dish needs to be connected to the digital set-top box before connecting to the TV (or TV box).

The specific connection method is as follows:

1. First of all, the satellite antenna should be connected to the signal input port of the back plate of the set-top box;

2. Then connect one end of the audio cable and the ** line [audio cable (red and white),** line (yellow)] to the "right channel", "left channel", "**" (red, white, yellow) port on the set-top box, and the other end is inserted into the audio ** input port of the TV box using the same method, and then connect the VGA from the output of the TV box to the LCD monitor.

One set-top box can't connect to 2 TVs.

Normally, a set-top box can only install one TV, but with different output interfaces, you can also use a set-top box to connect more than two TVs at the same time. After being connected,These TVs can only **one TV program,That is**one channel,You can't change other channels。

In addition to the images and sounds that analog TV can provide, set-top boxes can receive digital content, including electronic program guides, Internet web pages, and so on.

Precautions for using HDMI cables

During the use of HDMI cable, it is necessary to avoid excessive bending of the wire, such as frequent folding and winding, which may damage the core or shield of the line. It is generally bent along the arc and will not damage the cable.

Pay attention to the gold-plated brightness of the interface, and the high-quality HDMI cables on the market are all made of 24K gold-plating, which can effectively solve the problem of poor contact after the plug is plugged in and dialed many times, so as to avoid signal loss and affect the picture effect.

Before wiring, you must use the equipment to test the quality of the wire before it can be formally laid, wear a dust cap at both ends of the connection when laying out the wire, wrap the waterproof glue, try to slot the line, do not hard-pull through the tube, do not twist and knot, so as not to cause damage, resulting in the capacitance and characteristic impedance structure inside the HDMI, resulting in signal attenuation and distortion.