The mobile phone screen has a watermark when it enters the water, can it be turned on?

If you are using a Huawei phone, we recommend that you do the following:

1. Please try to place your phone in a dry and ventilated place and use a paper towel to blot the water stains on the surface of your phone.

2. If the phone is turned on, press the power button to turn it off; If your phone is turned off, don't try to turn it on.

3. Please take out the SIM card and microSD card.

4. Take your phone to a Huawei customer service center as soon as possible to avoid unnecessary losses.

Precautions: 1. Do not move or shake the mobile phone frequently after entering the water, so as to avoid the spread of moisture inside the mobile phone.

2. Do not use a hair dryer to blow or bake at high temperature (including microwave heating) after entering the water, so as to avoid the liquid being blown into the inside of the mobile phone and damaging the mobile phone at high temperature.

3. The mobile phone is composed of precision electronic components, and there is a potential risk after water ingress, so please keep the mobile phone turned off.

4. If you don't have a backup data, there may be a risk of data loss during repair.

No, the screen is already very serious due to water ingress, so hurry up and send it for repair, don't turn it on, the boot loss will be greater.

If the mobile phone gets into the water, it is best not to turn it on, and turn it on at that time to put it in a ventilated place for drying treatment, and then turn it on after the water is thorough, so as to effectively protect the mobile phone from being burned.

If the phone gets into the water, don't turn it on. Put it on the balcony in a place where the sun is not exposed to the sun, and it will dry naturally for one to two hours. If you have tools, you can disassemble the machine and wipe it slowly with a blow plane or paper towel.

1. Turn off the mobile phone and take out the SIM card to avoid damage during operation.

2. Take out all the accessories that can be disassembled from the mobile phone, such as memory cards, mobile phone cases, removable batteries, etc.

3. Use a towel to dry the water on the surface of the mobile phone to avoid secondary damage to the mobile phone components.

4. Use a vacuum cleaner to suck out the moisture inside the phone, focusing on the watermarked screen to absorb the moisture.

5. Never use a hair dryer. Because the direct blowing of the hair dryer will cause water vapor to enter the deep part of the device and damage the components of the phone. If you use hot air mode, overheating will melt the phone case.

6. Finally, put the mobile phone in a bag filled with dried raw rice and seal it to absorb the remaining water vapor until the watermark of the screen disappears.

Hello, happy to answer your questions

1. Take out the SIM card, the SIM card is not easy to be damaged when exposed to water, but take the SIM out of the mobile phone during operation.

2. Take out other less important parts, such as earbuds, memory cards, phone cases, etc.

3. Use a towel to dry the water on the surface of the mobile phone to avoid corroding the internal circuit of the mobile phone or causing a short circuit.

Fourth, the use of a vacuum cleaner can also suck out the water vapor inside the mobile phone, and focus on absorbing the water vapor on the watermarked screen when using. 5. Don't use a hair dryer to dry your phone directly (even in "cold air" mode). Using a hair dryer to blow directly will cause water vapor to enter deep into the device and come into contact with the electronics inside.

If it is too hot, it can also cause the phone case to melt.

6. You can put the mobile phone in a bag containing dry raw rice and seal it, and the rice grains will absorb the remaining water vapor until the water vapor disappears.

If there is a watermark on the inner screen, it will not disappear automatically, you can use a hair dryer to blow the watermark off. In general, don't turn on your phone first after it gets into water. Go home and dry it with a hair dryer before turning it on, so that there will be no watermark on the inner screen.

For this question you asked, our system has assigned you the most professional answer, the next 5 minutes, he will answer your questions relatedly, because the current number of consultations is large, please be patient. You can review your question, complete the information, or add a description of your question.

1. First of all, pure water will disappear. 2. Take out the mobile phone from the water and turn it off immediately without hesitation, otherwise it may form a vortex current, which will burn the screen battery at least and burn the motherboard directly. 3. Use a towel or paper towel to wipe off the water on the phone case.

Then quickly unplug the SIM card and keep it somewhere else. Then use a paper towel to absorb the water in the headphones, Dock port and SIM card slot, and do not deliberately shake the body to avoid water droplets shifting. 4. Use the [cold air mode] of the hair dryer to blow towards the holes.

Then place the phone in an airtight container with the desiccant. 5. When you feel that the water has evaporated and cleaned for a few hours, turn it on again. If there is still a watermark caused by water stains on the screen, it is because water has entered the inner screen.

6. If there is still a watermark after the water is dried, the bottom light layer needs to be replaced. However, if the water soaking is serious, the process of changing the bottom light may cause the LCD screen to not light up. You need to change the entire screen.

7. If the watermark is serious, you need to go to the local after-sales store for disassembly in time. You can search for the nearest specialty store near you and come to your door. 8. There is a watermark after the screen is repaired, but it does not affect the use.

The screen can't be disassembled for processing, you can only wait for time, the water will evaporate, the watermark will evaporate over time and the heat generated by the device, the residual watermark will evaporate and dry, and then the watermark of the screen will be gone, the fast one may be 1 month, and the slow one will not exceed 3 months, so you will find that the watermark disappears after using it for a while.

1.First of all, turn off the mobile phone that has entered the water, if it is not turned off, it will form a eddy current, which will burn the screen battery lightly, and burn the motherboard directly if it is heavy. 2.

Then turn the hair dryer into a cold air and blow it towards all the holes in the phone, and after blowing, put the phone in a desiccant container and leave it for a while. 3.If you take out the phone and there is still a watermark, it may be that the base film behind the inner screen is corroded, generally speaking, you only need to replace the base film.

4.In the end, if there is still a watermark, we can only take the phone to a professional repair point for repair.

Dear, I hope it helps you.

Use a dry substance to absorb water first and see if it has any effect. For example, use a water-absorbing substance such as a desiccant and keep the mobile phone closed for a period of time to see if the water can be absorbed. Generally, it can solve the problem, but if it doesn't work, it can only be disassembled.

You can only find a professional to fix it, or you control the temperature to dry it at about 60 degrees Celsius.

After the mobile phone enters the water, it can be repented to turn on and use normally, in this case, you also need to go to the repair shop to disassemble and wipe dry, if you don't wipe it, there is water in the mobile phone, and the front of the digging tomb will be equipped with a virtual part.

In this case, it is best to bask in the sun, or use a hair dryer to blow it. It is best not to use it when it is wet to avoid short circuits.

This watermark will remain on it permanently, or Master Zhao will open it and wipe it!

It won't go away, it needs to be taken apart and cleaned up, if it is not cleaned it will always exist.

Probably not, it needs to be further dried to go away.

Wrap your phone in paper and put it in a rice bag overnight or blow it on a hair dryer.