What should I do if the branch network made by wifi on my home computer is slow?

Wireless routers send signals across the board, and the closer the router is to obstacles, the more easily the signal is suppressed. Therefore, you should choose a high and spacious location in your home to place the router so that the signal can radiate downwards and reduce the blocking of obstacles and signal blind spots.

Routers transmit data information in the form of data packets. Electrical appliances, glass, and metal items will cause obvious interference to the signal, resulting in transmission blockage. Friends can keep the router away from the above categories of items to reduce interference.

1. If the router version is older, then regularly updating the firmware can ensure that the software of the router is in a good and efficient operating state.

2. If the wireless router at home has been used for too long, it will be a good choice to replace it with a new dual-antenna or multi-antenna router.

1. Buy a wifi repeater: plug the repeater into the socket at home, and the signal range and strength can be enhanced after debugging.

2. Reuse of old routers: Set the old router to AP mode, and then connect to the existing main router through the LAN port to expand the signal.

3. Adjust the antenna: Most router antennas are placed in a "ring", and in the vertical direction, the signal coverage will be wider. The antenna can be adjusted appropriately according to the distance and angle.

Usually the router is factory set to mixed mode with a set rate of 75%.

1. Adjust the rate: The partner can enter the security settings and adjust the rate of the router to the maximum.

2. Select Single Protocol: Set the mode to use only protocol.

Open the browser, enter the router address and username and password, check whether there is an unfamiliar device in the corresponding menu, and compare the IP address with your own hardware.

Then send the friends three magic weapons to prevent rubbing the net.

1. Set a complex password.

In the Tab or Security, select the WPA-PSK WPA2-PSK password and set a complex, easy-to-remember, and hard-to-guess password.

2. Disable the DHCP function.

In the Local Area Network (LAN) settings, disable the DHCP function to prevent automatic IP address assignment to wireless clients.

3. Change the default IP address.

If it defaults, it can be changed to prevent easy guessing.

If the wifi network is very slow, you can replace the gigabit router. Of course, the bandwidth of its own broadband must also be increased. In this way, with a higher configuration router, coupled with the increase in broadband bandwidth, the wifi speed will not be scolded.

The wifi network at home is slow. You can restart the router and plug in all the connectors at home, if it is still like this, it proves that there is a problem with your internet speed. You can call broadband maintenance**, please ask the maintenance staff to help you test the network speed to see if there is any poor contact in the line, or the optical power of the optical modem is too low.

With the popularization of smartphones and home appliances, our lifestyles are gradually changing, and WiFi is simply indispensable. Playing games, the slow wifi speed is already a major event that affects the quality of life. Do you often feel that the wifi speed at home is too slow, but you can't always find a solution?

I'm going to teach you a few tricks today, help your wifi speed up, and try the feeling of flying!

First, the route position should be correct.

The coverage and signal strength of a router are closely related to where it is placed. It is usually recommended that the home router be placed in a relatively open and slightly higher position, which will help to cover a large area of the signal and avoid dead spots. At the same time, because there are fewer obstacles at height, the signal strength will be better.

2. Set a timer to switch on and off.

Every time the Internet speed at home is too slow or the network is disconnected, the first suggestion you hear must be: "You unplug the power of the router and try it". In daily life, our routers are usually on standby 24 hours a day, so using a router can really cause the problem of slow network speed.

In fact, the router is also processing data all the time, just like mobile phones and computers, if it is not turned off for a long time, his memory data will be stored more and more, the speed of processing data will be slow, and the speed of Internet access will naturally be slow.

Now everyone uses home routers, can be controlled by mobile phone clients, and many of them have the setting function of timing power on/off. You can set an automatic power off time for the router according to your own life and usage habits, so that the router can rest properly, so that it can better serve you.

3. Signals and 5G signals are used alternately.

Today's home routers usually have signals with two frequencies of 5G, each with its own advantages and disadvantages, and is a pair of complementary brothers. You can choose the right frequency to use at different times according to their characteristics, and the effect of wifi will be better.

According to the characteristics of the two frequencies listed above, we can connect to 5G when we are close to the router and there is no wall or other object to block us; Back in the bedroom, when there is a wall blocking the signal, you need to connect a penetrating one.

4. Select a mesh router.

If the house you live in is a large house, or even some friends who "have mines at home" live in a multi-storey or villa with a complex house structure, then the signal coverage capacity of an ordinary router cannot meet your needs.

In this case, you need to choose a mesh router. A mesh network, also known as a "wireless mesh network", is a "multi-hop" network. Users can add routers in different places according to their needs, **signal is not enough**, these routers automatically generate a grid, forming a set of wifi system, which solves the problem of wifi signal coverage in a large area.

The computer is connected to the wifi at home, and the network speed is very slow, which may be due to your network speed. It's too slow, resulting in a slow computer network, and the computer may be stuck.

What should I do if the wifi speed is very slow?