Who can help me ... Correct partitioning and row of bars for hairdressing standards...

Standard Bar Partition On the standard bar, the hair must be partitioned first. First of all, along the center line, take 40% of the length of the bar on the left and right, and the total width is 80% of the length of the bar, make two lines parallel to the center line, and the width narrows to the neck point, about 60% of the width of the bar, and the middle part is the middle area. In this area, the hairline from the hairline to the apex is zone 1, the apex to the ** point is the 2 zone, the ** point to the back point is the 3 zone, the lower part is the 4 zone, and the hair on both sides of the middle zone is arced from the apex to the middle of the ear point and the back of the ear, so that it is divided into two areas.

The thickness of the hair piece is about the radius of the bar is less than the ground diameter, and the first hair piece can be slightly thinner The whole middle area has a total of about 20 upper bars, and the stretching angle of the first five bars is between 105-120 degrees, and the last five are between 90-105 degrees, and the rest are basically kept at 90 degrees. And then the upper back area, starting from above, the first piece is triangular, the front end of the bar is sloping, the second piece is still triangular, the third piece is oblique, and the fourth piece is basically horizontal. This area has about 10 bars, and there is less hair at the bottom, which can be curled at one end of the bar to prevent the bar from squeezing with the bar in the middle.

Finally, the upper anterior area. Generally, there are about 7 bars. The total number of bars on standard bars is about 50.

Most of the hairpins on the standard bar are horizontal. The characteristics of the standard bar The pattern of the standard bar is generous and the texture is strong.

Rubber bands are recommended for novices as long as they are fixed, and it is recommended to look at their heads to determine the area

1. When the standard bar is on, the width of the hair piece should be 8 minutes wide;

2. The thickness of the hair piece should be greater than the radius of the bar and less than the diameter of the bar;

3. The partition should be symmetrical, the thickness of the hair piece should be uniform, and the hair should not be squeezed or pressed;

4. The tension should be tight, and it should be evenly left and right, and the ends of the hair should not be broken;

The hairdressing standard bar is an essential tool in the perm process, and through different types of bars with different curling techniques and perm potions, you can make a variety of styles of curls. It is a basic tool that hairdressers must be proficient in. There are ten models of the hairdressing standard bar, and its length is about 8 cm (there will be slight differences due to different manufacturers' processes).

This, first of all, you have to practice more, don't put down the comb when you put it on the bar, otherwise it will waste a lot of time to pick it up and put it down, and you have to form a chain action, such as distributing pieces, cotton paper, adding bars, rolls, rubber bands, 、..Cycle,Probably you know the way you can The main thing is to practice more When I started, the teacher had to roll dozens of doll heads every day.,The hands made the rubber bands grind and bleed., Although because my personality is relatively slow The speed has not improved much.,But it's definitely helpful.,This is definitely a thing where practice makes perfect.,As long as your movements aren't too problematic.,The rest is only practice and practice.Of course, there is practice.。

The whole end of the standard bar is 50 reels, the thickness of the hair is half that of the reel, and the width is two-thirds of the reel! 26 in the middle and 12 on each side!

The standard bar is generally 40 hair sheets, and the trick is 1, first partition 2, and the hair should be kept at a certain humidity.

45 bars, angle 90 degrees, full head.