How to set up an Alpha v3 router to access the Internet

The subnet mask and gateway are set to the same, and the IP addresses are different addresses of the same network segment. Now assuming that the IP address of the router is , then the gateway of machine A and machine B is the subnet mask, and the IP address of machine A is machine B.

One. The main line is moved to the port of the wan, and the others are placed in the lan port, (you should have a total of five ports, one marked with wan, and four marked with lan) the port of the main line cannot be wrong, you can try to see if yours is also the reason, or it may be that there is a problem with the network cable of the second computer two. The private domain name should be the same as the intranet IP address, 3 and 4 ,..

Each machine has a different last digit mask with a router in the intranet and a switch hub no different from three. Are the IP, DNS, and gateway settings correct? Try this in the Internet options in the IE toolbar, connect to the LAN settings below, tick before the auto-detect setting, and then remove everything else, see if it works Four.

Hardware configuration Compatible machine two + China Netcom with RJ45 interface broadband terminal equipment DSL modem (commonly known as: cat) + alpha router one Purpose Through the incoming line of China Netcom, the computers in the two rooms share the Internet through the router Implementation It is a very simple thing to set up a netbook through a router, but because the V4 router settings are very strange, it took a while to test it. First of all, connect the incoming line of China Netcom into the inlet port of the cat, and then connect with the WAN port of the router with a short network cable and the exit of the cat, and then insert the network cable interfaces of the two computers into the terminal port respectively.

The network configuration is complete, followed by the setup of the router. The steps are as follows: 1. Turn on the computer of any client, open the local connection attribute of the online neighbor, set the IP to the subnet mask Note:

Be sure to set the IP address of the client's computer before you can log in to the router. Since the factory set IP address of the broadband router is, and the scope of its built-in DHCP (dynamic IP allocation) server is,) 2. Open the IE browser, type, the router address of TP-Link is, prompt to enter the username and password admin (default) 3. After entering the point of quick connection, select the Internet mode, China Network is generally a virtual dial-up PPPOE mode, select, and then enter the username and password given to you by China Netcom, click OK. 4. Click Automatic IP Configuration (DHCP Bootp) and select Enable.

5. Click on the current state, select the connection, and wait for a few seconds to see that the connection is successful, which means that the settings are correct. Close the browser, go back to the client's desktop, open the local connection properties of the neighborhood, and set the IP address and subnet mask to be automatically obtained, and the other client is also set to automatically obtain. In this way, the purpose of sharing the Internet through the router is achieved.

Read the instructions to log in to the router management interface.

admin admin has a switch in it.

Setup wizard,If your home is adsl,Select pppoe,Put your account password up,The next step is to complete the restart,It's almost,The cat comes out and is connected to the router WAN port。

The manual is not written in detail, step by step according to his instructions to do it, here I recommend you to use 101 wireless communication, I use this myself, the only one to add a radiation protection chip, it can be sold in Europe and the United States, it is more assured to use, and the signal quality is very good. freewifilink also known as 101 wireless pass sales champion in the Middle East and European and American countries (the only high-power wireless network card with anti-radiation chip) As long as there is a router within 5 kilometers of your home, you can use 101 wireless communication to receive the data packets of other routers, to achieve the purpose of free Internet access forever (the password on the router can be cracked), notebooks, desktops, can be used, you can access the Internet in any corner of the city, and enjoy free Internet access for life.

We have seen through TV and newspapers that there are similar varieties such as card kings and card kings called rubbing network cards, 101 The difference between wireless communication and rubbing network cards is the difference between BMW and QQ, one flies on the ground, and one climbs on the ground.

I can't remember the address of the purchase. Search for "freewifilink" or "101 wireless" to find product information. This thing is also sold by many people on **.

You are setting up the manual IP to put the mask in the gateway as well, so that you can enter the routing interface to pull. Alpha's IP is: