How to clean the tape of a watch, how to clean a rubber watch band

If the non-waterproof linked list is dirty, you can use a soft-bristled toothbrush to brush the stains; Waterproof linked watches can be brushed with neutral detergent mixed with water, and then wiped with a soft flannel cloth; Double canvas or rubber straps can also be prepared in the same way, but if the dirt has penetrated into the inner layer of the material, it should not be treated with chemical detergents to avoid deterioration.

The exhaust gas of the locomotive is easy to cause fading, gold plating and peeling, etc., air dust, sweat, rain, body dirt, etc. will also stain the watch, especially the gold-plated part of the watch, if it is a leather watch, it will cause the belt to mold, produce peculiar smell and even break, so it is best to wipe it with a soft cloth after each watch (especially in the hot summer).

Wash the surface of the strap first, then clean the stains in the crevices of the strap of the strap of the belted watch. These gaps are tightly connected, so it is difficult to clean the dirt inside. Now these gaps are stretched open by a cylinder made of books, and the dirt inside can be cleaned.

Let's clean the back of the strap again, again with the stains on the surface. Next, clean the stains in the crevices, and the stains in the crevices can be cleaned with a brush. Well, now the cleaning is done.

Finally, we need to scrub the strap clean with clean water.

Try it with toothpaste.

Brush with a shoe brush.

Soap is also fine.

1. Remove the tape first;

2. After the tape is removed, wipe a large area with a soft cloth, that is, wipe some obvious dust attached to the strap and the dirt of the connecting part first;

3. Take an old toothbrush that is not used, dip it in soapy water, moisten it as a whole first, then brush it quickly, and finally rinse it with water, dip it in water with a soft cloth, and let it dry naturally;

4. You can spray alcohol on the tape and wipe it clean. In this way, it can not only remove the odor from the tape, but also sterilize and disinfect.

To clean and maintain the rubber strap, you need to prepare: a glass of water, wet wipes, toothbrush, toothpaste.

1. First of all, you need to take out the items you need for later use.

2. Open the toothpaste and squeeze the toothpaste onto the toothbrush to use.

3. Take out another glass of water and put the toothbrush into the water to soak it.

4. Brush the rubber strap with a toothbrush below.

5. Next, take out another wet wipe and wipe the rubber strap clean.

6. Finally, the rubber strap is cleaned and maintained.