Why does my BYD S6 sometimes not catch fire, and the new car has been bought for less than a month

The engine does not catch fire and is one of the most common faults in cars. There are two situations when the ignition is not ignited: one is that the starter can be heard, but the engine cannot start.

The other is that after twisting the key, there is no sound. The first case is when the starter works, but the engine does not. This is complicated by the fact that it can be caused by one of several failures.

It is rare for two or more failures to occur at the same time, but it cannot be said absolutely. (1) First of all, it may be a circuit or electronic fault. The phenomenon that occurs is very sudden and without warning.

The faults of the circuit are: fuse blowing, high-voltage coil breaking, low-voltage circuit breaking, center ignition wire falling off, splitter head leakage, and spark plug damage. Electronic failure mainly refers to the loss of function of the computer control board.

Oil pump failure, oil circuit failure, oil filter blockage, carburetor failure, nozzle damage, etc. Sometimes it happens that the fuel tank is empty and the owner doesn't know about it. Add a few liters of petrol and you'll be able to solve all the problems.

3) Finally, it can also be a mechanical failure. Common mechanical failures are: time band (chain) breakage, cylinder leakage without pressure, etc.

The second scenario is when even the starter does not work or works barely. At this time, the first thing that needs to be checked is the battery or battery. There are many ways to check, but it's best if you have a voltmeter on hand.

Connect the positive and negative poles of the battery, and then twist the key to ignite. If the voltage indication drops below 8 volts at the moment of power on, there must be something wrong with your battery. It doesn't hurt to have a voltmeter, you can replace it with a small 12-volt bulb and a small section of power cord.

The same is true for the method, if the bulb suddenly becomes significantly darker, it is also an indication of battery aging. In many cases, the battery has failed, but the headlights can still be lit. This is not surprising.

Only at the moment of ignition can the performance of the battery be truly tested. Because this is when it has the most load. There's an easy way:

If you look at the outer wall of the battery with the naked eye, if you find that it has expanded and deformed, it means that a new battery is absolutely needed. In addition to the battery, the reason why the starter does not work can be a damaged ignition switch, a damaged ignition relay, or a damaged starter itself. Also, check the ground line and fuse.

Then why don't you go to the 4S store.

BYD S6 The solution to the fire does not ignite: 1. Twist the key while shaking the steering wheel, and try to eliminate the fire quickly; 2. Adjust the correct gear, and then try to start the car; 3. Step on the clutch first and then ignite; 4. Replace the engine of the car; 5. Ask for help from surrounding car owners and apply for emergency measures such as taking electricity, borrowing fuel, and trailers.

There are many reasons why the BYD S6 can't catch fire with one button start:

1. The sensor in the car is difficult to sense due to the failure of the smart key;

2. The gear is not hung into the P gear;

3. The steering wheel is locked;

4. The battery voltage is insufficient, out of power or damaged;

5. The car cannot catch fire without oil;

6. Caused by engine starting system failure and other reasons.

BYD S6 one-button start can not catch fire may be caused by the following reasons:

1. The battery is out of power: you need to check whether the battery power of the car is enough, you can test the power by turning on the headlights of the car, if there is no electricity, it is recommended to replace the battery to solve the problem;

2. The key is out of power: For the vehicle with one key start, it may be that the key battery is insufficient or the car cannot retrieve the key, it is recommended to try after replacing the key battery;

3. Ignition failure: It may be the failure of the spark plug of the car, and it is recommended to replace and set a new spark plug to solve the problem;

4. Direction locking: It may be that the steering wheel is locked, it is recommended to return to the steering wheel and then ignite it;

5. No fuel: check whether the fuel tank has enough fuel, if not, you need to add gasoline in time; At the same time, it is also necessary to check whether there are external signal sources around the car that interfere with the start of the car, such as generators, pulse equipment and other machinery; If it still can't be solved, it is recommended that you contact 4S after-sales maintenance in time.

Photo by Q&A) @2019

Summary. Hello, dear, BYD S6 can't catch fire when there is electricity because the dashboard wire or connector is short-circuited. The dashboard is damaged.

When repairing, you can first use a multimeter to detect the positive and negative voltage of the instrument and judge the specific fault: If the voltage is detected to be normal, the dashboard is damaged and needs to be replaced with a new one; If no voltage is detected, the wires or connectors of the instrument panel are short-circuited, and the cables and connectors need to be checked, re-wired, or replaced.

Still no response.

The battery is powered, the remote control key is powered, there is no response when the key is pressed to start, the alarm horn is sounding, and the meter is out of power.

Hello, dear, BYD S6 can't catch fire when there is electricity because the dashboard wire or connector is short-circuited. The dashboard is damaged. During maintenance, you can first use a multimeter to detect the positive and negative wax voltage of the instrument to judge the specific fault

If the test resistance is normal to the voltage, it means that the dashboard is damaged and needs to be replaced with a new one; If no voltage is detected, it means that the conductor or connector of the dashboard is short-circuited, and the cable and connector need to be checked, re-wired or replaced.

First of all, you can check whether the battery is "broken". In addition to the line fault, it may be the fault of the battery with a core open circuit, which mainly refers to the phenomenon that the internal connection of the battery is disconnected, so that the battery can not work effectively. The main manifestations are:

When charging, the charger is in a green light state, and when the vehicle is started, the instrument and the whole vehicle do not respond.

Short-circuit form Micro-open circuit: refers to the phenomenon of virtual connection in the internal connection of the battery in the process of driving, resulting in the failure of the vehicle to rent electricity and sometimes not respond, which is a battery quality problem. 0V Break:

It refers to the open circuit battery with the voltage at the measured end showing that it is not 2V or less, which is mostly caused by the current of Ochino and is not a quality problem.

Summary. Hello dear, I'm glad to answer for you, what is the reason why BYD S6 can't catch fire when it has electricity? , the battery has electricity.

The key fob has electricity. Dear, the reasons why BYD S6 can't catch fire when it has electricity are as follows:1

When the temperature is low, the viscosity speed of the car oil decreases by 2There was a problem with the ignition system, 3The car has less than 4 fuel

There is more carbon deposits inside the engine of the vehicle5Mercury damage to the fuel so that the fuel inside the fuel tank cannot be combusted**. <>

, the battery has electricity. The key fob has electricity.

Hello dear, very high Shuzhou Xing will answer for you, what is the reason why BYD S6 can't catch fire when there is electricity? , the battery has electricity. The key fob has electricity.

Dear, BYD S6 has electric beating and the reason why the shirt is on fire is as follows:1When the temperature is low, the viscosity speed of the car oil decreases by 2

There was a problem with the ignition system, 3The car has less than 4 fuelThere is 5 more carbon deposits inside the engine of the sail socks

Mercury damage to the fuel so that the fuel inside the fuel tank cannot be combusted**. <>

The remote key is a key that uses the wireless remote control function of the central lock, and can open and lock the door from a distance without inserting the key key into the lock hole. First generation: Conventional mechanical keys perform basic door opening and closing functions.

The second generation: you can press the remote control button to realize the opening and closing function of the door, but Linghui Roll car also needs a mechanical key to operate, and the two keys are used together, which is indispensable and somewhat cumbersome. Third generation:

The key and the remote control function of the two into one, open the door, close the door, the steam ruler and the car start are all completed by the active button, and the mechanical key is embedded in the remote control key, which has been prepared for emergencies. <>

It seems that the one-button start is not opened.

The gauge light is not on.

Kiss, check whether there is a problem with the smart key control module, and whether there is a problem with the line between the clutch tread crack town zhaoban switch brigade and the fuse box, if there is no problem with the line, the fuse box can be replaced.

SummaryHello, happy to answer your questions.

BYD S6 can't hit the fire case.

Hello, happy to answer your questions.

Hello, what is the reason why the vehicle can't start and can't catch fire? This question: first check whether the battery power is enough? In addition, the ignition system is not effective in high-pressure ignition, and the fuel system is not on the fuel, and if it is not ignited if it is not oiled, it will also cause the vehicle to not start.

The decoder decodes without faults, and the engine does not catch fire when it starts. The fuel is full, what is the reason why the spark plug power supply is electrified, and the start does not catch fire.

If the ignition is not ignited, check the ignition fuse, and whether the crankshaft position three-sensor has been replaced, if the crankshaft position sensor is damaged, it will also cause the start-up to fail.

The fuse is good.

In the case of a fuse box, you need to check the crankshaft position sensor.

The crankshaft sensor has a power supply.

Replace one with one.

The reasons why the BYD S6 battery cannot ignite: 1. The voltage of the battery is too low; 2. Battery failure; 3. Failure of oil supply system; 4. Ignition system failure; 5. The gear is wrong.

The car is generally divided into two parts: circuit failure and oil circuit failure. Personal suggestion: In addition to the lack of battery power, good insurance contact and check the air filter, it is better to find a professional maintenance personnel to deal with other problems.

1. Circuit failure.

1. Lack of battery powerLack of battery power is the most common cause of ignition, especially for cars that have been used for more than 2 years or have been parked for a long time. To judge the lack of power in the battery, you can use a multimeter to measure the voltage, generally the voltage is about 12V when the power is on, and the voltage is 10V when the ignition is ignited, which can eliminate the battery failure. If you don't have a multimeter, you can also observe whether the dashboard or lights are dimming when you are ignition.

The treatment method is also simple, charge the battery or change the battery.

2. Insurance contact is good, this is a method of 4S teaching. If the car is on fire, you can try to pat the fuse box with your hand or press the fuses in the fuse box one by one, if it can be ignited, it means that the insurance is caused by good contact.

3. If the starter is faulty, if the electric filial piety empty bottle has electricity, and the starter sound is not heard when pressing the start button to ignite (you can also open the hatch cover to see if the starter Qiaozi machine has turned), it may be a starter failure, and this can only be replaced by the starter in the repair shop. There is also a situation where the starter is rotating and the engine is turning, that is, there is a problem with the connection between the starter and the engine, and it can only be repaired. One trick is to look at the engine speed when the engine is igniting, if the engine shows revs (mine showed the engine at 200 rpm), but when the fire is on, you can rule out battery failure, good safety contact and starter failure.

4. Ignition system failureIgnition system failure includes ignition coil failure, spark plug failure and connection line failure. The S6 has two ignition coils, a spark plug. Comparison of several loss rates where the ignition coil or spark plug fails at the same time.

You can tighten the front and rear plugs of the live coil by hand to prevent the connector from loosening. The 4S inspection method is to pull out a pipe connected to the intake pipe (the net query is called the engine waste ** pipe), step on the accelerator while igniting, and spray combustible gas or liquid into the intake pipe from the pipe mouth (4S uses a combustible cleaning agent) to observe whether it can be ignited. It is advisable to leave this approach to professionals.

5. If the power supply of the gasoline pump fails, you can pull the plug of the gasoline pump, and measure the voltage or current of the plug when ignition.

Photo by Q&A) Model Y Model 3 Model X AION V Ideal One Xpeng P7 @2019

What is the reason why BYD S6 can't catch fire with one button start? What is the reason why BYD S6 can't catch fire with one button start? The reasons why BYD S6 can't catch fire with one key start are as follows:

1. The sensor in the car is difficult to sense due to the failure of the smart key; 2. The gear is not hung into the P gear; 3. The steering wheel lock is locked; 4. The battery voltage is insufficient, out of power or damaged; 5. The car cannot catch fire without oil; 6. Caused by engine starting system failure and other reasons. The following is the relevant information of BYD S6:1. Introduction:

The BYD S6 is BYD's first SUV, positioned as a mid-to-high-end independent SUV and launched in September 2010. Its length, width and height are 4810 U002F1855 U002F1680mm, and the wheelbase is 2720mm, which is second to none in its class of SUVs. The minimum ground clearance of 190mm makes the vehicle have excellent passing performance.

2. Power part: S6 has three displacements, divided into four styles: manual luxury, manual premium, automatic prestige and automatic honor, equipped with BYD483QB or Mitsubishi 4G69 engine. One-button start does not ignite, probably for the following reasons:

1. The gear is not in P gear. Nowadays, more and more models will be set to ignition when the gear is not in P gear, which is for safety reasons. The main purpose is to prevent the gear from igniting in D or R gear and the car from moving forward.

Solution: Hang the gear to P gear and re-ignite. 2. The reason for the key.

If it is the reason for the key, there are many reasons involved. For example, the radio waves of the key are interfered with, Key 2019