The method of ramp fixed point parking, the most accurate method of ramp fixed point parking point

First of all, the person sits upright, there is a small square in the right corner of the car, some are plugged paper, probably at the position of the second screw of the wiper, when parking, the sight, the paper, and the stick outside are almost in the same line. (Mine is like this, everyone will sit in a different position will be a little off, adjust it yourself.) You see when you're getting to the position, brake a little bit earlier and press the clutch all the way down.

That's it. There are also 30 centimeters that I forgot right. Continue, don't let go of the brakes, slowly loosen the clutch, feel the car shaking, don't care about it, loosen a little, at this time the car seems to be panting, shaking badly, here is the key, to practice more, at this time stabilize the clutch and do not move, slowly release the brakes within 2 seconds, do not let go at once.

As long as you stabilize the clutch, you'll be fine. Remember that the second subject is that you can run by stepping on the clutch, stepping on the clutch, and controlling the speed as slow as possible, but you can't stop, so that you can do it slowly, and if there is a problem, you can correct it in time.

Interpretation of ramp fixed-point parking steps to help you go uphill easily!

Half-slope starting fixed-point parking is one of the test questions for the driver's license, this skill is more difficult, and there are more requirements, so it is necessary to practice more for beginners.

Here's a look at some of the tips.

1. After getting into the car, first of all, you should adjust the inclination of the front and rear seats and backrests, so that you can start practicing in a more comfortable posture. In addition, it is necessary to fasten the seat belt, adjust the rearview mirror, and only by developing good habits can you pass the exams more smoothly.

2. The vehicle should be in the right direction before entering the ramp, and the vehicle should be straightened, which is the key to half-slope parking, because it is more difficult to adjust the vehicle after entering the ramp, and it is often easy to deviate.

3. After the car, hang up a gear and move forward slowly, then you have to keep to the right to play a little direction, because the ramp fixed-point parking has particularly high requirements for the sideline, and only the margin reaches 30cm, which is qualified. Therefore, try to move the vehicle slightly to the right before going uphill, about 30cm away from the sideline (the solid white line on the right in Figure 1 below) before returning to the wheel and continuing to climb the hill.

4. After climbing to the slope, look at the benchmark and parking dotted line sign at the ramp parking place. Be sure to concentrate, don't go too fast, and climb slowly up by aligning with the slope top signs.

5. When the vehicle is getting closer and closer to the ramp parking starting line, it is necessary to step on the clutch and brake to reduce the speed, and the car will be stopped at a distance of 20-30 cm from the parking line. Tighten the handbrake while pressing the brake, and if you take off gear (i.e., the vehicle is in neutral), you don't need to press the clutch. In this way, the ramp parking is basically completed.

6. The following is the key ramp to start, the driver should hold his breath and pay attention to the cooperation of hands, eyes and feet. Release the brake with your right foot and tap the accelerator, press the clutch with your left foot and then hang the first gear with your right hand, and release the handbrake while tapping the accelerator. Note that the clutch of the left foot must be controlled when releasing the handbrake, and ensure that the clutch goes out in a "semi-disengaged" state, at this time the vehicle is a little shaky, so that releasing the handbrake can ensure that the vehicle does not roll backwards.

Uphill fixed-point parking is always aligned method: first semi-linkage flat start, completely release the clutch before going uphill, and immediately step on the clutch foot brake at the point.

Ramp fixed-point parking and starting is one of the subject 2 exam items, which seems simple, but the link where students lose the most points in the subject 2 exam is the ramp fixed-point parking.

Subject 2: Ramp fixed-point parking and starting operation steps:

1. Drive in the middle of the road, there are generally arrows, and you can use the steering wheel to drive on the arrows, and you can lift the clutch uphill slightly.

2. After hearing the command of "uphill fixed-point parking", immediately turn on the right turn signal, and lean on the right side of the field.

3. When you are about to reach the side of the road, the direction is half a circle to the left, and then quickly to the right, so that the right side of the car is parallel to the side of the road, and the distance is within 30 cm (it is best to press the white dotted line, or use the left rib to align with the standard line).

4. After starting, you can completely release the clutch pedal to go uphill, and during the uphill process, if the vehicle shakes significantly, you can slightly dismiss the clutch pedal to prevent stalling.

5. When you are about to reach the parking point, the bead clutch pedal, let go of the speed, when you see the parking mark to the right, the bead brake pedal, the bead clutch pedal stops, or from the left rearview mirror along the edge of the positioning parking line to see the edge of the parking line, that is, stop, tighten the parking brake handle, turn off the turn signal, put the gear lever in neutral position, and lift the clutch pedal.

6. Stop for 10 seconds, wait for the results to be reported, prepare for half-slope start, bead clutch pedal, bead brake pedal, hang 1st gear, hit the left turn signal and press the horn, and release the parking brake handle.

7. Lift the clutch pedal lightly, when the body has a shaking feeling or makes a gear run-in sound, completely release the brake pedal, light bead accelerator pedal, the car is moving forward, if the car shakes when the brake pedal is released, the car does not go, the idle speed drops rapidly, it is necessary to bead the clutch pedal and brake pedal in time, keep it not off, do not slip, and then start again, note: the starting time should not exceed 30 seconds.

8. After passing the top of the slope, you should use the brake to control the speed of the car, just tap it, keep the left rib and the side line 10cm, and the car will almost not press the line.

9. When going downhill, you can use semi-linkage to control the speed, or you can completely release the clutch pedal and control the speed with the brake pedal.

The rules for ramps and destruction points are: 1. Ramp fixed-point parking scoring standards: after parking, the right side of the body is more than 30 cm away from the curb line and 100 points are deducted for more than 50 cm; 100 points for pressing or sweeping the line; After parking, the front bumper is not set on the pile line, and the front and rear do not exceed 50 cm deduct 10 points, exceed 50 cm deduct 100 points; After parking, 10 points will be deducted for not tightening the parking brake; 2. Scoring criteria for half-slope start of ramp:

If you do not complete the start within 30 seconds, 100 points will be deducted; 10 points will be deducted for turning off the engine at a time; When starting the engine, if the spare gear is not placed in neutral or parking gear, 100 points will be deducted; 10 points will be deducted if the vehicle is less than 30 cm backward when the first step is taken, and 100 points will be deducted if the vehicle is more than 30 cm backward; 3. Key emphasis: In the subject 2 exam, most of the deductions are in the project of "ramp fixed-point parking and starting"; I haven't seen five exams, and all ten chances are wrong in reversing; But I have seen five exams, and ten chances are all wrong in the ramp fixed-point parking and starting this project, this project is not 100% sure, do not take the exam.

The tips for starting and stopping at a fixed point on a ramp are as follows:

After hearing the voice command, hit the right turn signal to control the speed of the vehicle through the clutch semi-linkage. Slightly hit the steering wheel to the right side of the field, observe the point of 1 3 on the right side of the hood, when it coincides with the roadside, that is, when the distance between the body and the roadside is 30cm, continue to clutch semi-linkage to control the speed of the car, and slowly approach the parking point.

When the lower edge of the left rearview mirror is flush with the second thick yellow line, first press the foot brake, then press the clutch, stop the car steadily, and turn off the right turn signal. After parking the car, wait for the voice prompt, and you need to complete the ramp start within 30s after hearing the voice backup prompt. When starting on a ramp, slowly lift the clutch and hit the left turn signal.

When the front of the car is upturned and the body is shaking, the left foot remains clutched and the right foot releases the brake. The vehicle starts smoothly and drives up the ramp, turns off the left turn signal, and finally goes completely uphill and smoothly descends. First of all, pay attention to the curb distance (30cm), which is the same as pulling over, and slowly push the wheels to the right.

The front 1 3 places look at the side of the road (that is, the roadside is 1 3 places from the right of the front of the car), about the judgment of this imitation stool land, you can also look at the position of the white line on the ground in the right side of the reflector, the right side of the car is pressed through the white line, and then the direction is correct. During the climbing process, you can give oil or not, control the speed, and make it easy to find your own positioning.

Slope attack answer cong road set shot cherry spot parking skills.

When you adjust the distance between the yellow and white lines on the right side of the steering wheel, stabilize the steering wheel and stop moving. At this time, the right foot applies the brake and the left foot presses the clutch pedal. When the car dealer walks to the front, he sees the parking lever in the upper right corner of the middle console of the car and the upper right corner (the upper right corner of the Poussin car console) 3:

1 When you're in a straight line (when the parking lever and console top right corner are in a straight line with you), quickly apply the brakes and clutch. Note: Be sure to sit up straight and not miss.

Otherwise, if you find the wrong point, you will press the right line and stop accurately.

The operation steps of fixed-point parking on ramps.

There are eight steps to complete the entire fixed-point parking process. Eight-step driving skills: After hearing the fixed-point stop command.

The first step is to quickly turn on the right turn signal, and observe whether there is a following car behind the vehicle through the right rearview mirror, and judge whether it can turn into the right lane;

The second step is to step on the brakes, slowly turn the steering wheel to the right, so that the right front wheel is level with the white solid line on the ground, adjust the body, and return to the positive direction;

In the third step, when the speed of the vehicle drops to about 20 km/h, press the clutch pedal, and then release the foot brake slightly to allow the vehicle to coast forward using inertia. When the datum slides past the right side mirror and aligns with the cab, gently press the brake pedal to slowly stop the vehicle.

The fourth step is to pull the handbrake;

In the fifth step, turn the gear lever to the empty position;

Sixth, release the clutch with your left foot;

Step 7: Release the foot brake of your right foot;

Step 8: Turn off the right turn signal.

Generally speaking, these eight steps are the steps for ramp parking. Candidates can take the exam strictly according to this method. Of course, they should make appropriate adjustments according to their own situation.

Millions of car purchase subsidies.

It is required to stop at a fixed position on a ramp with a slope of 10% and a slope length of 30 meters, and the coordination of direction, braking, and clutch is investigated.

Precautions. 1. Before going uphill, the direction should be adjusted in the shortest time.

2. When going uphill, you should turn right to the right side of the field, so that the right side of the car is parallel to a solid line on the right side of the road, and the distance between the side of the body and the solid line shall not exceed 30 cm, and it cannot be pressed to the solid line.

3. Pay attention to the coordination of the clutch, accelerator pedal and parking brake lever (handbrake lever), and relax the timing of the parking brake lever (handbrake lever).

Evaluation criteria. 1. After the vehicle is stopped, the front bumper of the car or the front axle of the motorcycle is not set on the pile line, and the front and rear exceed 50 cm, which is unqualified;

2. After the vehicle stops, if the front bumper of the car or the front axle of the motorcycle is not set on the pile line, and the front and rear do not exceed 50 cm, 10 points will be deducted (20 points in the original regulations);

3. After the vehicle stops, if the body is more than 30 cm away from the edge of the road, 10 points will be deducted (20 points according to the original regulations); If the body is more than 50 cm away from the curb line, it will fail the examination;

4. After the vehicle starts, if the body slips 30 cm and does not exceed 50 cm, 20 points will be deducted;

5. After the vehicle is started, the body slides back 50 cm, and the test is unqualified;

6. If the ramp is turned off, 20 points will be deducted;

7. After the vehicle is stopped, the vehicle is not started within 30 seconds, and the overtime is unqualified.