What are some ways to turn off a car? What happens when driving causes the car to stall?

We all know that driving and turning off the car is very harmful, what are the ways in life that the car is easy to cause the car to turn off? What are the precautions to avoid turning off the car? "Rainbow I" is popularized for everyone today.

The main reasons why cars generally turn off are as follows:

1. The driving skills are not proficient enough.

Automatic transmission cars rarely occur the phenomenon of stalling, on the contrary, some novices open the manual transmission models early, the driver's driving skills are not proficient, improper operation will cause the car to stall, such as the clutch and accelerator are not well coordinated and easy to stall. The solution is to restart the vehicle, and the driver should also practice his driving skills more.

2. The engine itself fails.

If the car stalls because of driving skills, just start the car again, if it can't start, it is likely that there is a malfunction. There is a high possibility that the engine itself will fail and the car will stall, most likely due to the idle motor or the idle control module of the engine ECU.

3. Multiple cylinder failures at the same time.

There are many reasons for the failure of multiple cylinders, such as a clogged spark plug, or a faulty high-pressure pack, which can lead to flameout. So it's also important to replace the spark plugs on time.

4. Oil pump failure.

If the oil pump fails, it is likely that the engine will not be able to supply oil in time, and the insufficient oil supply is likely to cause the engine to fail to work and cause the vehicle to stall. At this time, it is necessary to check the pipeline from the oil pump, oil pipeline, etc.

5. Use low-quality fuel.

Long-term use of low-quality fuel, or fuel that does not meet standards, can lead to carbon build-up in the engine, which in turn can lead to engine stalling. The use of standard fuel is also the key to solving the problem of car stalling and avoiding excessive carbon deposition in the cylinder.

Finally, "Rainbow I" reminds everyone that no matter what causes the car to stall, you should deal with it calmly and not be impatient.

Reasons for the sudden stalling of the car while driving:

1. Circuit fault;

2. Flameout caused by short circuit of low-voltage line: intermittent flameout; 3. Device failure: it can start at first, turn off after a while, and then start again, and then turn off again;

4. Oil circuit failure; The gasoline pump was damaged, the oil line was ruptured, the carburetor inlet was clogged, and the fuel tank ran out of oil.

5. There is a problem with the ignition system and the explosion-proof system for engine overheating.

When it is found that after the ignition is turned off, according to the road conditions at the time, if there is no emergency, you can slowly step on the brakes to prevent the tail light, after the speed is reduced, slowly play the direction, drive to the roadside lane, pay attention, the brake should be stepped on all the time, the power from small to large, do not step on it and then loosen, and then go to the pedal, which will lead to the only remaining vacuum is also consumed, and then step on it can not be stepped on, park the car on the side of the road, turn on the four flashing lights, place the tripod, and hit the ** rescue trailer. Hope!

3. When stopping during braking, the disassembler will also turn off if you don't step on it. 4. When the vehicle is driving, especially when going uphill, towing will also cause stalling.

Only the chain Zen of manual transmission can be ridiculously defeated when driving.

In any case, as long as you are not in neutral and then do not pay attention to the clutch, the stable rises to the dust and turns off.

1. When the vehicle starts, the clutch is lifted too fast, which will cause a sudden increase in engine torque and cause the engine to stall.

2. In the case of the clutch not disengaged, the brake will be stepped on, and the failure will cause the engine to stall.

3. When the vehicle is driving in abnormally early dry road conditions, it does not reduce the gear in time, which will cause the engine to stall.

Automatic transmission cars are generally not properly supplied with fuel, and the engine will be turned off, such as the fuel injector and the bridge is blocked

There is also a situation that can cause the ignition to go out in both manual and automatic ways, and that is to run out of oil, hehe

When the car turns off, you only need to stop the car, and then put the gear in neutral, and the automatic transmission car puts the gear in the P gear, and then press the one-button start button to turn off, and finally pull up the hand brake, the specific operation steps are as follows:

1. Press the clutch pedal and brake pedal at the same time until the vehicle stops.

2. Hang the gear to neutral.

3. Press the key to start and turn off the vehicle.

4. Pull up the parking brake.

5. Release all pedals and complete the shutdown of the vehicle at this time.

Precautions for operation:

1. Do not directly press the brake pedal, otherwise the vehicle will be forced to shut down the engine due to the traction of the gear, which will damage the engine.

2. Be sure to pull up the hand brake to avoid slipping.

In fact, there are three common reasons for car shutdown in our daily life, one is automatic shutdown, automatic start shutdown, and idle shutdown.

For novice drivers, the most common misoperation mode of car stalling should be the start time. The driver of the new pendulum driver, who had just received the driver's manual, was unfamiliar with the clutch and throttle, which often caused the engine to stall halfway through. In fact, in the exams of subject 2 and subject 3, this kind of flameout is relatively common.

The clutch and throttle are not well scratched. As soon as the clutch is released too quickly, the auto-start shuts off immediately. The correct way to operate should be to lightly press the throttle with the right foot and lift the clutch slightly slowly with the left foot.

When the car starts, pause a little and the car will stabilize and then lift it all up. When driving, the throttle is not well coordinated, and the throttle is slightly increased. When parking, you can only brake, not clutch.

The common causes of car stalling are empty air leakage in the intake pipe, poor work of fuel pump relays, EFI relays, ignition relays, etc. To solve these problems, we can first use fault self-diagnosis to check whether the vehicle has a fault code, if there is a fault code, according to the fault code it displays to find the fault before the fault code is identified.

In the process of driving, the reason for the idle shutdown of the car is generally insufficient oil pressure or poor oil supply: for example, the electronic oil pump is easy to stall due to open circuit, short circuit, or poor contact, poor conductivity, combustion, etc.; Air intake system: such as blockage, air leakage, etc.

It may be easy to cause flameout, etc. In this case, the defect should contact the repair shop in time to eliminate the cause of human operation and find out the cause of the failure, which shall be subject to the actual vehicle test results.

Millions of car purchase subsidies.

1. Depress the clutch and shift into first gear, one is to start the flame-out, and the other is to stop the flame-out halfway. When starting to stall or the clutch is loosening too quickly, press the clutch and shift to first gear, then slowly lift the clutch. When the clutch is in semi-linkage, the front of the car shakes.

At this point, drop the handbrake, keep your left foot steady, wait for the car to move for a second or two, then slowly lift all the clutches, refuel and shift gears. As for the stall in the middle, most people are obviously in third gear, and if you want to stop, hit the brakes. The speed does not match the gear.

The correct way is to depress the clutch and then the brake. When the car comes to a quick stop, return to neutral and pull the handbrake. 2. Pressing the clutch or shifting to neutral is not like a self-chain stopper.

The power of the bike comes from the pedals. When pedaling, they move forward. When they are tired, they can't pedal.

If they have inertia, they will move forward. The engine of a car is not as flexible as that of a foot. It can be said to stop and open.

Starting the canopy by ignition is actually using an electric motor to drive the engine to rotate, just like manually spinning the motor before starting the tractor. Therefore, when ignition, the clutch must be depressed or shifted to neutral to start the engine with no load. Once the engine is started, there is no need to stop if you don't wait on the road for a long time because it is cumbersome to start.

Automatic transmission models: After parking, pull the handbrake first, then put it into the P gear, and then turn on the foot brake to turn off the engine (turn the car key counterclockwise to turn off the engine, and for models equipped with the "one-button start" function, press the "one-button start" button once to turn off the engine). Manual transmission models:

At low speed, press the clutch to engage to neutral, stop, pull the handbrake, and turn off the engine.

Note: It is important to pull the handbrake before lifting the foot brake, whether it is P or N, before the automatic stop closes the Zishi. As long as you tighten the handbrake, you can basically turn off the engine by hanging it in P or N gear, but if you want to remove the key, you must hang it in P gear to turn off the engine.

Even if the engine is turned off in D gear, it will not necessarily cause damage to the car; At present, many models are basically equipped with automatic engine start-stop technology, which is turned on by default; When waiting for a red light, the engine will automatically turn off after stopping with the foot brake, and the gear is exactly in D gear at this time.

There are several situations that are often encountered when the car has to turn off: waiting for a short time on the side of the road, stopping for a long time, and when the car is refueled; The first thing to go to the gas station to refuel is to turn off the fire first, when refueling, although the car has moved, but the internal engine, the motor is basically running, and they are basically accompanied by the current in the operation process, once the circuit leakage, it will lead to combustion, ** and other serious consequences. In addition, during the operation of the car, the exhaust pipe will still continuously emit exhaust gases.

On the one hand, the temperature of the exhaust pipe is very high, and on the other hand, the exhaust pipe may also carry sparks when it is exhausted, so this becomes a safety hazard through development and change.

Millions of car purchase subsidies.