What do you need to pay attention to when driving a sanitation sweeper?

The precautions for driving a sanitation sweeper are as follows:

1.Sanitation sweeper workThe operator should pay close attention to the working status of the road sweeper owner and auxiliary engine, and once an abnormality is found, it should be stopped in time for inspection, find out the cause and solve it before continuing to use.

2.When the sanitation sweeper is reversing, the nozzle and suction cup should be put away first.

3.When dumping garbage, the back door of the bin should be opened first, and then the bin should be tipped over.

4.Overhaul after the dustbin is jacked, be sure to support the safety ejector pole, for a long time to jack, should also add triangle wood.

5.After the bin is jackedIt is strictly forbidden to drive on the road with street sweepers.

6.When the tank is filled with waterThe operator should control the flow of water, and closely observe the water level of the tank displayed by the water label, and turn off the water in time to avoid damage to the water tank due to excessive water addition.

7.The chassis and auxiliary engine are maintained and maintained according to the manufacturer's requirementsand replace the air filter and oil filter in time according to the requirements of the road sweeper manual.

.The acceleration and deceleration of the engine of the sanitation sweeper should be relatively gentle and slowto avoid sharp acceleration and deceleration.

I hope that the above sanitation sweeper safe driving and correct operation skills will be kept in mind by drivers and friends, and know how to learn how to control the vehicle more safely.

1. When cleaning the sanitation sweeper, you should know the area that can be cleaned at a time, and clean back and forth to pay attention to the cleaning of the edge line to prevent blind spots.

And the problem of unclean ground cleaning that the roller brush and side brush of the sanitation sweeper cannot take into account.

2. For the sake of safety, we should reasonably control the speed of the sweeper when using the sanitation sweeper, not too fast or too slow, and the sweeper can not be used on the ground with water, snow or potholes on the road.

3. When using the sweeper, we must always pay attention to the power of the battery, charge it in time, and prevent the sanitation sweeper from running on low electricity.

4. The sanitation sweeper should regularly check the dust removal box, dump it in time, keep the inside of the sanitation sweeper dry and clean, and regularly check the wear and tear of the roller brush and side brush, and make appropriate adjustments and replacements.

The street sweeper is a kind of car used to sweep the road, and we can often choose his figure in the city's cleaning work, and it does play a very important role, so its use can be said to be more and more extensive.

The use of road sweepers is very widespread, but many times, his service life is not very long, and most of these are caused by bad operating habits, so here I will say that in the driving of street sweepers, it is also necessary to have a good driving habits.

The formation of good habits first requires you to treat this road sweeper as your own car, you need to cherish such a car, not to be unscrupulous when using it, and then ignore anything that may happen, which is obviously not conducive to the overall condition of the car, so you need to pay attention to this problem.

The other is the problem of driving habits, some people have some bad habits in the process of driving, and they will naturally introduce these into the driving of the road sweeper, and this is not a desirable method, so this is a problem that the driver needs to avoid.

If we want the street sweeper to have a longer use time, then we have to get rid of these bad habits and do the right driving, which will be good for the car and more helpful for your work.

This is mainly: 1. The driving sweeper has a dust collection system, and a large amount of dust will be sucked into the filter element to achieve the effect of dust reduction when the sweeper is working.

2.When the sweeper is working, it is cleaned by the brush, so pay attention to the brush not to be entangled by ropes and other garbage in the work, so as to avoid affecting the cleaning effect of the brush, and also increase the load of the brush motor, which needs to be noted.

Walking on the streets of the city, there are very few cleaners on the street with a broom to clean the hygienic posture, everywhere you can see the figure of the driving sweeper, clean up the dust and then no secondary dust, so what should you pay attention to when using the driving sweeper?

1.If you are using it for the first time, you will be familiar with the functions and uses of each button.

2.The car must stop working and lift the main brush before passing the speed bump.

3.It is strictly forbidden to clean ribbon, linear, excessively large, flammable and explosive products.

4.When working in rainy weather, the vacuum suction motor must be turned off when cleaning puddle areas.

5.It is forbidden to make quick turns at high speeds, and it is forbidden to coerce quick turns and make U-turns.

6.It is strictly forbidden to touch the shafts and linkages of the various mechanisms that are in operation.

7.Work for 30 minutes must be stopped, start the dust vibration for 3-5 minutes.

8.Check and maintain, press the emergency stop button under the socks and disconnect the power supply.

9.Forklifts cannot be used for transportation, and they should be stored in a rainproof, sunproof, and ventilated place.

10.The battery is charged for 8-10 hours, and it is forbidden to overcharge and overdischarge frequently.

11.Those who are not trained must read and understand the instructions before operating.

If you do the above, your ride-on sweeper will last longer.

1.High work efficiency: more than 3,000 square meters can be cleaned per hour, and the working time of the same working area is greatly shortened.

2.Low cost: Ride-on sweepers can replace 5-10 manual cleaning, saving a lot of labor wages, benefits and coping with the problem of salary and treatment;

3.Good effect: The ride-on sweeper adopts a combination of sweeping and suction, which is much cleaner than the traditional manual cleaning of the wolf.

4.High safety performance: keep the cleaning workers in a safe environment (there are too many fast-moving vehicles on the road, manual cleaning is not safe).

5.Economic code and high return: the cost of only a dozen yuan per day (charging, consumables, wear and tear), if it is more than 10 people, at least nearly 1,000 yuan in wages and benefits, but also to invest in basic cleaning tools and operating costs.

Advantages of ride-on sweepers.

From the perspective of environmental protection, the electric operation of the ride-on electric sweeper has no noise, no dust, zero emission and zero pollution, and is green and environmentally friendly;

In terms of work efficiency, small size, flexible turning, easy to drive, convenient maintenance, suitable for most manual cleaning environment, a sweeper can work uninterruptedly, large sweeping area, fast cleaning speed, clean cleaning, convenient and fast;

From an economic point of view, a sweeper can be worth 12-15 cleaners, which can save 3-40,000 yuan per month.

1. In the operation of the road sweeper, the operator should pay close attention to the working status of the road sweeper and the auxiliary engine. Once the engine fails, the operator should stop the car in time to check, find out the cause, and solve the problem before continuing to work.

2. When the sweeper is reversing, the nozzle and suction cup should be closed first.

3. When dumping garbage, open the back door of the garbage bin before dumping the garbage can. After the trash can is jacked up for repair, the safety jack must be supported. If the garbage is lifted for a long time, it should be added to the triangular digging wood.

After the garbage can is raised, it is strictly forbidden for the sweeper to drive on the road.

4. When filling the water tank, the operator should control the flow of the water added, and closely observe the water level in the water tank indicated by the water tank, so as to close the water in time to avoid excessive water filling and damage to the water tank.

5. The chassis and sub-engine of the automobile should be repaired and maintained according to the requirements of the manufacturer, and the air filter and oil filter should be replaced in time according to the instructions of the road sweeper. The acceleration and deceleration of the sweeper engine should be gentle to avoid rapid deceleration.

The sweeper should do the following when driving safely:

1.In the work of the sweeper, the operator should pay close attention to the working status of the cleaning owner and the auxiliary engine, and once the abnormality is found, it should be stopped in time for inspection, find out the cause and solve it before continuing to use;

2.When the sweeper is reversing, the suction nozzle and suction cup should be put away first;

3.When dumping garbage, open the back door of the garbage bin and then dump the garbage bin;

4.After the garbage bin is lifted and overhauled, the safety ejector rod must be propped up, and the triangle wood should be added for a long time to jack;

5.After the garbage bin is lifted, it is strictly forbidden to drive the road sweeper;

6.When the water tank is filled, the operator should control the flow rate of the water added, and closely observe the water level of the water tank displayed by the water mark of the water tank, and turn off the water in time to avoid damage to the water tank due to excessive water addition;

7.The chassis and auxiliary engine are maintained and maintained according to the requirements of the manufacturer, and the air filter and oil filter are replaced in time according to the requirements of the sweeper manual;

8.The acceleration and deceleration of the sweeper engine should be gentle and slow to avoid sharp acceleration or deceleration.

As with driving, don't go too fast, avoid hitting people, charge in time, etc.

Driving a sanitation sweeper should pay attention to the following points:

1. Before starting or operating the working device, should observe whether there are people and obstacles around the vehicle, carefully observe whether there are vehicles and pedestrians before and after, close the door, turn on the turn signal, whistle to start.

2. When the engine is runningBetween the front and rear tires of the vehicle, between the boom and the front frame, the front and rear positions of the sweeper are strictly forbidden to stand people.

3. The water temperature should not be lower than 50 at the startto start in low gear and avoid acceleration.

4. When the sanitation sweeper is driving, prohibit anyone from getting on or off the bus.

5. It is strictly forbidden to drink and driveSmoking, eating, drinking, chatting, playing and listening to headphones are not allowed while driving a vehicle.

6. Keep the driving speed for 15 h.

7. When the vehicle is driving on rainy, icy and snowy, muddy and oily roads, the vehicle should pay attention to anti-skid, avoid rapid acceleration and emergency braking, so as not to lose control and cause accidents.

8. Pay attention to the working condition of the vehicleWhen the brake, steering, lights and other parts that affect safety occur, when there is a breakdown on the way, it must be stopped for inspection, and it is not allowed to drive dangerously.

9. When the sweeper is cleaningWhen the bucket is full, the material should be poured out in time, and the opening and closing of the bucket cover should be slow and uniform to avoid large impact.

10. When there are entanglements on the sweep roll of the sweeper, it should be cleaned up in timeto prevent the normal operation of the cleaner.

1. The low height of the sweeper roller adjustment is that the sweep roller substrate cannot be in contact with the bucket, should be checked and adjusted in a timely manner, and the cleaning cover plate should be adjusted in time when it is found that there is an inclined phenomenon, so as to prevent the deflection angle from causing damage to the sweep roller.

12. Before the vehicle is turned offIt should be idle for 3-5 minutes, and the turbocharger speed can be turned off only after the speed is reduced.

13. After parking, each joystick is placed in neutral position, cut off the power supply, pull the handbrake, slowly move each joystick, reduce the residual pressure of the hydraulic system.

14. Close doors and windowsLock the door, park neatly, and fill in the usage record.

According to the normal standard, this kind of vehicle does not belong to the special car, but it is best to find a B certificate.

Sanitation sweepers can generally be driven with a B2 driver's license.

Read more

There are three types of driver's licenses: A1, A2, and A3

A1: Permitted vehicles are: large passenger vehicles.

That is, passenger cars with more than 20 seats and a body of more than 6 meters, and quasi-driving types include A3, B1, B2, C1, C2, C3, C4, and M. In other words, with an A1 license, you can drive large buses, city buses, medium-sized buses, large trucks, small cars, small automatic cars, low-speed trucks, three-wheeled vehicles, etc.

A2: Permitted vehicles are: tractors, including heavy-duty, medium-sized full-trailer, semi-trailer vehicles.

Full trailer refers to the total weight of the trailer borne by its own car, semi-trailer refers to a part of the total weight of the trailer borne by the tractor, this tractor can only be driven by the driver with an A2 driver's license, and the driver with an A1 driver's license can not drive the tractor. At the same time, holding an A2 license can also drive medium-sized buses, large trucks, small cars, small automatic vehicles, low-speed trucks, three-wheeled vehicles, etc.

A3: The vehicle that can be driven is a city bus, that is, a city bus with more than 10 seats. At the same time, the quasi-driving models that are allowed to be driven are C1, C2, C3, C4, and M.

In other words, with an A3 license, you can drive city buses, small cars, small automatic cars, low-speed trucks, three-wheeled vehicles, etc.

There are two types of B photos: B1 and B2.

B1: The permitted vehicle is a medium-sized passenger vehicle, that is, a passenger vehicle carrying more than 10 people and less than 19 people, in addition.

There are also C1, C2, C3, C4, and M models. In other words, if you have a B1 license, you can drive medium-sized passenger cars, small cars, small automatic cars, low-speed trucks, three-wheeled vehicles, etc.

B2: Vehicles permitted to drive are heavy-duty and medium-sized trucks; Large, heavy and medium-sized special operation vehicles are required to drive vehicles with a length of more than or equal to 6m and a total mass greater than or equal to 12,000kg. At the same time, the models that are allowed to be driven are C1, C2, C3, C4, and M, that is, holders of B2 licenses can drive heavy and medium-sized trucks; Large, heavy and medium-sized special operation vehicles, small cars, small automatic vehicles, low-speed trucks, three-wheeled vehicles, etc.

C illumination is divided into C1, C2, C3, and C4

C1: It is the most common type of driver's license to apply for the examination at present, and the vehicles allowed to drive are small and micro passenger vehicles and light and micro trucks; Light, small and micro special operation vehicles. It can not only drive cars with a total mass of no more than tons, no more than 9 passengers (including drivers) or less than 6m in length, but also small automatic cars, low-speed trucks, three-wheeled vehicles, etc.

C2: The permitted vehicle is a small automatic transmission car, and it can also drive a low-speed truck, three-wheeled vehicle, etc. The difference with C1 is that C1 can drive small cars with manual and automatic transmissions, but C2 can only drive small cars with automatic transmission.

C3: The permitted vehicle is a low-speed truck, such as a four-wheeled agricultural transport vehicle in the countryside, a C3 driver's license is required, and a C3 holder can also drive a three-wheeled vehicle.

C4: The permitted vehicle is a three-wheeled vehicle, and a three-wheeled agricultural transport vehicle is this type of driver's license.