How to clean the plastic bucket of the water dispenser if it is dirty?

The plastic bucket filled with water can be cleaned with white vinegar and then rinsed with clean water.

How to clean the bucket:

1. For scale, it is recommended to take a special cleaning agent to soak it. Pour the limescale cleaner into a bucket of water, then fill it with water and soak it for more than 12 hours, and finally wash it with clean water.

2. Special detergents are more expensive, and the amount is not small, and some places may not be able to buy them, so in this case, it is necessary to choose alternatives. Consumption of citric acid.

Acidic substances such as food-grade hydrochloric acid (sulfuric acid) are also a good choice, which not only has a good soaking and descaling effect, but also has a lower cost.

3. If you have edible white vinegar at home, you can also use white vinegar to descale. White vinegar is more expensive, can not be diluted like detergent after soaking, do not dilute directly pour a little white vinegar into the soak, soak the place on the regular rotation and inversion, and finally rinse with water.

4. In some places, there are more microorganisms in the water quality, and it is easy to grow moss in the bucket, which is more difficult to wash off than ordinary scale. You can pour out the water in the bucket before cleaning, and dry the bucket or dry it, let it stand for a few days, let the moss lose water, so that the moss is easy to peel off, and then add detergent to soak it slightly, and then shake it, you can wash it off more easily.

5. In the case of no detergent at all, you can use sand to clean the bucket. Put a large handful of fine sand into the bucket, add a little water to it, block the mouth of the bucket, and then hold the bucket with both hands and shake the bucket violently back and forth, using the friction of the sand to wipe off the stubborn moss and most of the scale. For stubborn limescale, sand and detergent can be used together for better results.

6. Some families with cars have high-pressure water guns.

Dirt such as moss can be washed from the bucket with a water gun, and no other detergent is needed to wash away the dirt. It's fast and not as laborious as sand, and of course, there may be some dead spots that can be treated with sand. When rinsing, you need to pay attention to the skill, it needs to be operated by two people, one person holds the bucket mouth down, and the other person uses the water gun to impact.

You can put corn, rice or a slightly smoother pebble in it and add some water. Pick it up and turn it in one direction. The dirt inside will be washed off, and the place where the barrel mouth is not easy to clean can be bent and cleaned with a long-bristled brush. Will wash very clean.

Why do you need to wash this? Wouldn't sending another bucket of water give you a clean one?

If the water dispenser has a plastic smell, it may be due to the newly purchased water dispenser or the old water dispenser that has not been cleaned for a long time. Here are some ways to solve it:

Clean the water dispenser: Pour out all the water in the water dispenser, and rinse the water tank, water pipe, and water outlet of the water dispenser repeatedly with clean water until there is no odor. Some special water dispenser cleaners or white vinegar can be used to clear the mountains and fields.

Replace the filter: If you are using a water dispenser with a filter, you can try to change the filter, as the filter may accumulate some odor substances.

Place charcoal packets: Place some activated carbon packets near the water dispenser, which can adsorb some odor molecules and play a role in removing odors.

There is a plastic smell that means that your water dispenser is newly bought, and the newly bought products will have more or less some peculiar smells, and they don't have to care too much about Qingqing lead, but if you want to clean up, you basically put a bucket of water, and pour it out after a few cups, and there is not much peculiar smell. Poorly.

Summary: The water dispenser at home will have a layer of dirt in it after being used for a long time. The cleaning method is as follows:

Tools Ingredients: water dispenser, white vinegar.

Method steps.

1. First of all, for safety, you need to unplug the power of the water dispenser.

2. Remove the bucket placed above the water dispenser.

3. Clean the water in the water dispenser and let it flow out of the front water outlet.

4. Remove the cover plate of the water dispenser, clean the cover plate separately with detergent, and rinse it many times to avoid residual cleaning agent.

5. Pour half a bottle of edible rice vinegar into the water dispenser. It is not recommended to use detergent or disinfectant after it is afraid of residue.

6. Cover the lid of the water dispenser, turn on the electricity, and heat the rice vinegar for about half an hour.

7. After half an hour, put the vinegar in the water dispenser. Remember, in addition to opening the water valve, the water release valve behind the water dispenser should also be opened. The wash can be repeated several times. This way the water dispenser will be cleaned.

Notes:It is not recommended to clean the water dispenser with detergent or disinfectant. If it is not rinsed well, it is easy to leave residue.

It is easy to wash away water stains with vinegar (white vinegar or vinegar essence is preferred).

Pour some fine sand, add some water, seal the mouth casually, and shake it vigorously.

Companies that sell bottled water have liquids that specialize in disinfecting and cleaning.

Hire a professional cleaner, usually in companies that sell purified water.

Step 1: Start by disconnecting the water dispenser from power.

Step 2: Drain the remaining water from the water dispenser.

Step 3: Remove the plastic seat cushion from the water dispenser that is stuck in the tube. Pour about 250ml of white vinegar into the water dispenser, then turn on the faucet to verify that the white vinegar has entered the water storage tank.

Step 4: Put the plastic seat cushion back in, then plug it in and heat it for about 40 minutes.

Step 5: Put the white vinegar out of the tap and the water dispenser at the back of the water dispenser, then add water to the water dispenser, and repeat the above steps two to three times. Wash the remaining vinegar from the water dispenser.

Scale is mainly formed by the precipitation of salts such as calcium and magnesium contained in boiler feed water after being heated and sticking to the metal surface. The thermal conductivity of scale is very small, about 2 5% of ordinary steel, and the scale is formed on the heating surface of the boiler, which will greatly deteriorate the heat transfer effect and affect the efficiency of the boiler; It is easy to burn out the metal material due to local overheating, and even burst the pipe; It will aggravate the electrochemical corrosion, cause the scale corrosion of the boiler, and accelerate the damage of the heating surface. After the formation of scale, it should be removed by mechanical or chemical methods in time.

The effective way to prevent or slow down the formation of scale is to strictly control the quality of the feed water and take appropriate measures such as boiler water treatment and boiler blowdown.

You can remove the bottleneck of the bucket and use a scouring pad to reach inside for cleaning. Here's how:

1. First unscrew the cap of the bucket, and soak the cap in water to clean.

2. Then rotate the bottle of the bucket to the right until it loosens.

3. Take down the bottleneck of the bucket, which is also soaked in water for cleaning.

4. Then use a scouring pad and reach into a bucket with water.

5. Scrub the bucket wall of the bucket in the left and right circles, and you can squeeze some detergent into it to scrub it cleaner.

<> "1. How to clean the bucket of the water dispenser.

1. Empty the water dispenser.

2. Pour a small half bottle of white vinegar into the bucket, seal the bottle mouth with a plastic bag, and soak it overnight to soften the dirt.

3. Pour an appropriate amount of hard particles into the bucket, such as red beans and mung beans.

4. Seal the water dispenser barrel, and then shake the water dispenser barrel vigorously, so that the hard particles can rub against the inner wall of the barrel and remove a large amount of dirt.

5. Pour out the white vinegar and hard particles, and then wash the residual stains with water.

2. What should be paid attention to when using the drinking water machine?

1. When using a water dispenser, you need to ensure the quality of the water source, and try not to use bottled water with three nos, because the water quality of this kind of bottled water is not up to standard, which is not good for the water dispenser and has certain harm to the human body.

2. When using the water dispenser, it is necessary to observe and check the amount of bottled water, and it is forbidden to heat it without water, otherwise the water dispenser is in a dry burning state, and it is easy to cause fire for a long time, which is very dangerous.

3. If you have a child at home, you need to put the water dispenser out of reach of the child as much as possible to avoid the child accidentally unscrewing the hot water switch and causing scalding.

4. Because the water dispenser is easy to produce scale during use, it is necessary to clean the water dispenser regularly and disinfect the water dispenser during the use of the water dispenser.

1. Before cleaning, pour out the water balance in the bucket and dry or dry the bucket.

2. Let it stand for a few days and let the moss lose water, so that the moss will peel off easily.

3. Add detergent to soak it slightly, and shake it to wash it off easily.

4. In the case of no detergent at all, you can use sand to clean the bucket.

5. Put a large handful of fine sand in the bucket, add a little water to it, and block the mouth of the bucket.

6. Hold the bucket with both hands and shake the bucket violently back and forth, using the friction of the sand to wipe off the stubborn moss.

7. You can also use a water gun to clean the moss in the bucket, which will be faster and more labor-saving.