-
To open the SAIC-GM Buick GL8 commercial vehicle water tank cover, you need to open the hood of the SAIC-GM Buick GL8 commercial vehicle first, and then the SAIC-GM Buick GL8 commercial vehicle water tank cover can be unscrewed directly, the specific operation steps are as follows:
1. Open the driver's door of SAIC-GM Buick GL8 commercial vehicle.
2. Pull the hood switch on the left side of the driver's leg of the SAIC-GM Buick GL8 commercial vehicle.
3. Lift the engine hood of the SAIC-GM Buick GL8 commercial vehicle upwards.
4. Use the support rod to support the engine hood of the SAIC-GM Buick GL8 commercial vehicle, and ensure that the support is firm to avoid danger during operation.
5. Find the water tank cover of SAIC-GM Buick GL8 commercial vehicle, and you can unscrew it directly.
-
Press down hard, and then twist counterclockwise, it will open, and the water tank cover of this car has two locking devices, so it is not easy to open. [If you have a problem with the car, ask the car master.] 4S shop professional technician, 10 minutes to solve. 】
-
Cool car open the water tank lid to avoid burns, this other water tank cover and other cars are twisted counterclockwise, but it is very laborious, and this car can not be unscrewed by ordinary people. [If you have a problem with the car, ask the car master.] 4S shop professional technician, 10 minutes to solve. 】
-
Hello. Press down hard to drive Be careful not to burn [If there is a problem with the car, ask the car master. 4S shop professional technician, 10 minutes to solve. 】
-
The switch of the Buick GL8 trunk is located in the rear tailgate of the vehicle, directly above the photo, in the middle of the two license plate lights, is a button covering the rubber grinder, the surface is raised, and the trunk will open when pressed, the specific operation steps are as follows:
1. Open the door on the side of the differential wheel cab.
2. Press the brake pedal.
3. Press the one-button start button to turn on the power.
4. Press the trunk switch.
Fifth, at this time, the trunk will slowly open the empty travel letter.
-
The hood of most sedans has an opening handle at the lower part of the dashboard in the direction of the driver's left calf to the front of the car, and the hood will bounce up about 1cm after pulling, and then lift the cover with one hand, and the other hand reaches in from the top of the net to find the lever to open the cover.
-
The Buick GL8 fuel cap opening method and steps are as follows:
1. First enter the cockpit, find the open switch button of the fuel tank cap in the main driving place in the car, and the button style is shown in the following figure:
2. Pull this button down, and you will find that the fuel cap of the car is popped open.
3. Then get out of the car and walk to the position of the fuel tank cap, and unscrew the inner cover of the fuel tank of the Buick GL8 business car counterclockwise by hand.
4. After unscrewing, hang the inner cover of the fuel tank on the hook on the inside of the outer cover of the fuel tank to prevent accidents.
5. After refueling, tighten the fuel tank cap in the Buick GL8 business vehicle clockwise.
6. Finally, press the Buick GL8 commercial vehicle fuel tank cap and retract.
-
Pull up the handle of the engine compartment cover and the engine compartment cover will bounce up slightly.
Reach your hand into the front end of the engine compartment cover, touch the auxiliary hook handle of the engine compartment cover, lift the paddle up and hold, and at the same time lift the engine compartment cover to the slag tank, open the engine compartment cover and take out the engine compartment cover support rod, and put one end of the engine support rod into the support notch to support the engine cell beam round cabin cover.
-
2. Then pull the fuel tank turn switch of the Buick GL8 business car, and the fuel tank cap of the car will pop open.
3. Then unscrew the inner cover of the fuel tank of the Buick GL8 business car in a counterclockwise direction.
4. At this time, you can hang the inner cover of the fuel tank of the unscrewed Buick GL8 business car on the hook on the inside of the outer cover of the fuel tank.
5. After refueling, tighten the inner cover of the fuel tank of the Buick GL8 business car clockwise.
6. Finally, press the fuel tank cover of the Buick GL8 business car and retract it.
-
The fuel tank cover of the car is divided into the inner cover and the outer cover, the outer cover is mostly the electronic control wire control cover door, there is also a key to open, the electronic control button wire control lever is generally located on the left and right sides of the driver's seat, there is a fuel gun pattern on it, as long as you press or pull it, the fuel tank door will automatically open. The inner cover can only be seen when the outer cover is opened, and the inner cover is made of glue, and the right-hand is closed, and the left-hand is open.
-
The switch of the Buick GL8 trunk is located in the rear tailgate of the vehicle, directly above the photo, in the middle of the two license plate lights, is a button covered with rubber, the surface has a bulge, press the trunk will open, the specific operation steps are as follows:
1. Open the door on this side of the cab.
2. Press the brake pedal.
3. Press the one-button start button to turn on the power.
4. Press the trunk switch.
Fifth, the trunk will slowly open at this time.
-
The GL8 key is unlocked first, and then there is a soft material like silicone under the Buick mark above the license plate, which can be opened by pressing it. There is a button on the back, press it to turn on automatically. If the interior of the car is opened, the top of the car is pressed on the rightmost button of the sunroof switch (rear door opening switch), and the trunk door can also be opened. Hope to adopt.
-
The electric one is not easy to open, and my sister has one too. If it's a big suitcase, then it's really no way, there is a handle on the back of the third row of seats, pull it, the third row of seats will be put down, pull any of the strap seats can be put on the side alone, you can also put down 2 seats. My sister is in her seat.
1. Check the lock block of the back box, there is a lock motor contact is not real, you can open the door in the back box, and there is a place to open the door urgently.
2. Park your car on flat ground.
3. Hang the gear on the P gear.
-
Press and hold the back box button on the key for a while, and there should also be a switch in the cab.
Buick GL8 to adjust the time, you can use the instrument setting key to adjust, through this button to achieve time adjustment, the specific operation steps are as follows: >>>More
GL8 is a bit better.
1. The armrests on both sides of GM8 are fixed, which looks more advanced, but it is not easy to get on and off the car. However, the GM8 second-row seats are manually adjusted for the front and rear positions and backrest angles, and the GL8 has more electric backrest angle adjustments than it. >>>More
The reasons and solutions for Buick GL8 suddenly not catching fire are as follows: >>>More
Causes the fault light to turn on:
Poor gasoline quality will cause the mixture to burn inadequately in the cylinder, resulting in a fault light and carbon deposits. >>>More
In foreign countries, commercial vehicles are mainly used for family purposes, because business vehicles have more space, more complete internal facilities, and are more comfortable and safe than sedan cars and SUVs. >>>More