How to install a flush toilet

There are occasional surprises in the delivery drawing, so after receiving the goods, it is necessary to accept the toilet in person and confirm that there are no problems with the toilet before you can start the installation. So.

This? Now let's find out.

Flush toilet installation points.

1. Check the levelness of the ground where the toilet is to be installed, if it is found to be tilted, it can only be installed after adjusting to the level;

2. Check the sewage pipe of the toilet before installation, and clear the sediment, waste paper and other sundries in the sewage pipe;

3. The height of the drain is 2-5 mm above the ground;

4. After debugging and installing the water tank accessories, connect the tap water, fill the water tank into the water tank, and then observe whether the water tank or water inlet hose is leaking for a few minutes;

5. The water pressure of tap water is generally relatively stable, and the water tank is filled with water. Test the drain effect of the toilet bowl and whether the flush is strong. If the water vortex is fast and rushes quickly, it means that the water is unobstructed, and conversely, check for blockages.

How to install a flush toilet.

Make all kinds of preparations before the installation of the toilet, especially the installation points should be in place, so as to ensure the smooth installation.

1. Check the levelness of the ground where the toilet is to be installed, if it is found to be tilted, it can only be installed after adjusting to the level; Check the sewage pipe of the toilet before installation, and clear the sediment, waste paper and other debris in the sewage pipe;

2. Fixed toilet (choose one of the fixing methods according to the fixing method of the toilet).

Method 1: Pull and burst bolt fixing method, this method is designed for toilets with mounting holes at the bottom. Place the toilet bowl on the installation position, use a pencil to draw the position of the need to open the hole and the bottom corridor on the ground according to the position of the installation hole, then remove the toilet, open the hole in the marked position and insert the detonation bolt, apply the adhesive at the joint between the toilet discharge outlet and the ground sewage outlet, put the toilet smoothly, pull the burst bolt firmly, and finally seal the toilet foot with cement mortar.

Method 2: Cement bonding method, this method is designed for toilets that do not have installation holes at the bottom. Put the toilet bowl in the installation position, use a pencil to draw the bottom corridor of the toilet, lay a circle of 30mm wide and 15mm high cement mortar inward along the contour line, apply adhesive at the junction of the toilet outlet and the ground sewage outlet, wipe the bottom foot of the toilet, place it smoothly in the installation position, make it firmly bonded, wipe off the overflowing cement mortar.

3. After the toilet is fixed, wipe the excess cement adhered to the toilet bowl and the ground immediately;

4. Connect the toilet tank and the tap water pipe;

5. Check whether the water tank is leaking, and then flush to check whether the sewage pipe is unobstructed;

How to install a toilet at home.