How do you cut a ball while playing tennis? I have a good angle, why do I always like to throw the b

The ball is in contact with your hand, and your racket is sure to be fine.

There is also the fact that the strength is not well controlled!!

Grip method: 1Match the paddle face with the point of impact of the backhand one-handed shot. 2.Hold the racket with your left hand (right-handed player only). 3.Grasp the paddle from above with your right hand.

Depending on the grip method, the face of the racket will change as a result, and the swing will also change as a result. The practice should first be started with the grip used when hitting the ball with a one-handed backhand. Basically, it uses the Oriental backhand grip method.

As long as it is a one-handed backhand shot, whether it is a chipping ball, a flat shot or a slam ball, it is basically advisable to use the oriental grip method.

Shooting method: In order to be able to cut out the spinning ball, the shooting method is actually more important than swinging the racket when hitting the ball. Whether you can swing the racket correctly and prepare for the chop determines the success of the chopping.

The key points of the backhand chipping technique are: the height and position of the racket after the backswing is introduced; The time to complete the backward lead shot is ready sooner or later; Then it's time to slice the ball.

In addition, it should also be noted that (1) the elbow joint of the right arm on the side of the racket should not be too low. (2) Do not use the wrist (3) When using the chipping ball, the position of the racket when the swing is completed (4) When the back swing is leading, only if the left armpit is not opened, can the swing action of the chopping ball be waved from the inside to the outside (5) The backward swing should be done so that the shoulder touches the jaw.

Swing back: Before considering the swing of the chipping racket, you must first concentrate on preparing for the swing of the racket and the racket. Only by doing a good job of leading the shot can you have enough time to cut the ball after the best time.

When slicing the ball, it is important to keep the racket in a straight line from top to bottom. If the swing of the racket is not very good on the shoulder, then the racket will inevitably swing along the arc of the ring during the chipping action, and it will not be possible to hit the spinning ball.

Whether it's a double-backhand shot, a one-handed backhand shot, or a chipping shot, the special thing to pay attention to is to swing the racket early and complete the preparation early.

Chipping: Big chipping, swinging the racket is"Go"A straight line from the shoulders to the waist. The first thing you should do is to concentrate on chopping the ball, rather than consciously swinging it.

The tennis backhand chipping technique does not use the rotation of the waist and the extension and flexion of the knee joint, as well as the movement of the center of gravity. People who hit the ball with both hands and backhands are especially easy to use the rotation of the waist to hit the ball, so be especially careful not to use the rotation of the waist to work.

In addition, if the chopping is that the ball does not fly forward, some people are trying to use body movements, or there is a pick-up movement when hitting the ball, which is not correct. In fact, the ball does not fly forward mainly because the swing arm is on the wrong track, and it is caused by the failure to swing the racket in a straight line.

Slice with two hands: If you hit the ball with both hands with your backhand on a tennis court, it is easy to do so with both hands. A two-handed player may not be able to handle a chase or a high ball well when slicing the ball with both hands, but the action itself is no different from a tie shot and a topspin ball, so you can cut the ball without feeling awkward.

Whether it is a two-handed or one-handed chip, the technical points required are the same, i.e. the movement must be horizontal until the end, not the body.

No matter how small the chipping angle is, there is no problem if the technique is incorrect. Once you have mastered the technique, there are a few tricks that you can use, such as if you hold the racket higher during preparation, or if you end the ball more forward after hitting the ball, you may be able to spin the ball more powerfully.

The main thing is the strength of the shot and the coordination of the angle. There is no way to rely on the angle alone, if the strength is relatively large, the angle is closer to 90 degrees, the ball will fly quickly, spin quickly, and bounce very low, but few people play like this, because it hurts the wrist. If the strength is relatively small and the angle is closer to 180 degrees, the ball will be arced in the air, but due to the small strength, if the opponent has good skills, it is easy to be attacked.

Chipping is basically used for defense in professional player competitions, and few people use it to attack.

Chipping can generally be divided into two categories, defensive (excessive) cutting and offensive cutting, and the latter should be the one you are asking.

Federer's cut ball is low over the net, flat in flight, fast, and has a particularly strong forward momentum after landing, which has the effect of attacking (sometimes, Federer will also adjust his technique according to different situations and use defensive cutting). Roddick "stomps" not enough to cut the ball, the cut ball has a tendency to float upward, so the speed will be affected, this kind of cutting is generally called defensive or transitional cutting.

If you look closely, you will find that Roddick and Federer's backhand cutting balls are significantly different in terms of technique and effect.

Essentials of Aggressive Cutting:

1 Pull the racket early, the wrist is fully flexed, and the racket wraps around the head more closely.

2 Before hitting the ball, make sure the head of the racket is higher than the point of impact and the center of gravity is forward to meet the ball.

3 When hitting the ball, the racket should be as perpendicular to the ground as possible, and the racket should be cut vertically down from the top of the ball, and the point of impact should be close to the body.

4 After the shot, the paddle remains nearly vertical and slides to the other side of the body, and the paddle ends up in a relatively low position.

Finally, it is also necessary to explain the difference in timing between the two types of cutting.

Generally speaking, when you're more aggressive and have enough time to take the shot, you can choose to create more trouble with your opponent's return with an aggressive cut. Many times, after an aggressive cut, it will be accompanied by the ball on the net.

On the other hand, if your opponent has a large return angle and you don't have time to return the ball, or if you realize that you are about to fall into passivity and need to adjust the pace of the game, you can take a defensive cut that flies slower and crosses the net higher, so that you can get more time to return.

The spin of the chipping ball is downspin, so it jumps very low and flat after landing, which is just the opposite of the topspin ball.

This is mainly the effect caused by the friction between the ball and the ground.

It's like cutting it in the video. However, if you can really be practical, you still need to practice. It's best to get someone to feed the ball.

Paying attention to the coordination of your steps is the best way to do this. Leaning forward to shoot the surface 10 40 degrees like this, I did this and the effect was okay. It would be helpful to look at the pro games more

Grip: Continental grip. Important: Try to relax the grip of the racket to ensure that the racket does not take off your hand when hitting the ball, so that you can give full play to the speed of the racket. Holding the racket too hard and hard will limit the speed of your headshot.

When you see the opponent coming to the ball, immediately turn sideways, the center of gravity falls on the back foot, and fully turn the shoulder. The power of the shot comes from turning the shoulders and fully relaxing the arms. When the preparation is complete, place the head above the shoulders and the side facing the net.

Shift your weight to your front foot when hitting the ball, keep your sideways, never rotate your body, don't deliberately shake your wrists, and don't deliberately keep them stiff. The key to the whole batting action is the forward swing of the racket head, that is, the head of the racket is behind the tail of the racket before the shot, and beyond the tail of the racket after hitting the ball (similar to the backhand action of a badminton ball), which is the key to playing a penetrating chipping ball.

People with high attributes in front of the net will have a large angle in front of the net.

The backhand is hit at the greatest angle.

When you make your character's body follow the path of the incoming ball in a straight line, that is to say, when your running position makes the ball fly towards you, you press J, and the system will automatically arrange for you to return the ball with your forehand, then you will see "automatic sideways forehand hit", and the person is a little slippery. The direction of this forehand shot is exactly the opposite of the direction of a normal forehand shot, that is, the right direction is large. Combined with the forehand hitting speed I mentioned above, which is faster than the backhand hitting speed under the same charging conditions, you can make full use of the above principles and flexibly use them to confuse your opponent.

Although the forehand is faster than the backhand, it does not mean that you should try to return with your forehand on any ball. In some cases, it is better to hit back with a backhand. For example, if the opponent hits a large angle ball to the left of your court, if you can choose a backhand or a forehand, it is recommended to use a backhand to fight back, because if you use an automatic sideways forehand, although you may be able to hit a high charge ball, but if you return to the left of the ball is also a straight line, and the opponent is blocked and then hit back a diagonal ball to the right of your court, because you use a sideways, the person has already slipped out of the left sideline, which will make you have to run more distance to the right to shoot back, At this time, it is easy to lose your original advantage.

And how you can directly hit back with a full charge of your backhand, there is no such problem. So we still have to be flexible on a case-by-case basis, and experience is very important here.

In general, the forehand return is large on the left and small on the right, and the backhand return is large on the right and small on the left.

When you can judge the direction of the opponent's ball in advance, run to the landing point in advance and press the arrow keys and charge the ball speed up at the same time, which can be seen in the training, people with backcourt attributes generally play large-angle return balls like this, and front-court attributes of volleying in front of the net, when the body and the ball almost become a straight line, you can hit a large-angle return ball according to the forehand and backhand.

This one is very simple, if you want to hit the right, press AS+K. Press SD+K to hit the left.