Can I run long distances during the car run in period?

Vehicles should avoid driving at high speeds, long distances, and full loads. You need to pay attention to the following points during the run-in period of a new car:1

The engine speed should not be too high, preferably not more than 3000 rpm. 2.There should be a process of warming up the car during the cold start, and driving on the road after the water temperature changes, generally about 5 minutes.

3.The load must be reduced according to the load regulations of the model, and it is advisable not to exceed 70% of the specified load capacity. 4.

The impact damage of the sudden braking to the engine, braking system and chassis of the new car is very large, and the situation should be dealt with in advance during driving, and the deceleration and gear reduction should be reduced. 5.Avoid sudden refueling and braking, and try to maintain a constant speed.

The maximum speed within 2000 kilometers should not exceed 90 kilometers per hour, but it is not possible to drive at low speed for a long time. 6.According to the time and mileage specified by the manufacturer, go to the 4S shop for the first oil change.

It is generally not recommended to run long distances, mainly related to the top speed, and has little to do with distance. Because the maximum speed is recommended to be below 60km during the run-in period, Kendi should exceed this speed for long distances.

Hello, you can run, you need to pay attention to 1, the speed should not exceed 3000 rpm, basically the car as long as the speed does not exceed 100 yards 2, pay attention to the rest, people and cars are the same, it is recommended to rest once in 3-4 hours 3, the run-in period can not be full load and overload.

Hello, the car can run at high speed during the run-in period, as long as the speed does not exceed 100 kilometers per hour.

The break-in period is to allow the various parts of the vehicle to adapt to each other and rub against each other to achieve the best working condition. Generally, the run-in of new cars is about 1500-2000 kilometers. Your car is not designed for high speeds.

Hello. No problem. Just pay more attention.

Many friends who have just bought a new car will have such doubts: can the new car run at high speed during the run-in period? Let's talk about this in detail today.

It is possible to run long distances during the run-in period of the car, although there is no run-in period, but if the long-distance is to go on the high-speed, this must have certain restrictions, and the minimum cautious speed limit of the high-speed is 60 kilometers for a wide friend. So if you don't mind the new car, you can run at high speed at will.

New cars need a run-in period, so it is recommended that after the run-in period or the first warranty (generally 3000 kilometers or 3 months) before getting on the highway. If you have to run long distances directly, the new car can also run, but you need to control the speed and rotational speed.

Generally speaking, the speed of the car above 500 kilometers should not exceed 80 kilometers hour, 3000 kilometers should not exceed 120 kilometers hours, the engine speed should not exceed 3000 kilometers in the whole 3000 kilometers, and you can drive freely and safely after 3000 kilometers.

The most important thing for a car to limit the engine speed during the run-in period is to limit the speed of the engine. In the run-in, the engine speed is too high to increase the possibility of damage to the piston rings, so the general manufacturer will recommend that the speed limit of the new car is 80 90 km h in the 80 90 km h speed range.

Whether it is a manual transmission car or an automatic transmission car, according to the normal shift requirements of the automatic speed switching point, the engine speed in this speed range is about 2500r min, and the maximum will not exceed 3000r min. (Photo by Dong Peng) @2019

It is possible to run a certain distance during the break-in of the car. Although there is no run-in period, if the long-distance is to go to the highway, there must be certain restrictions. The minimum speed limit for highways is 60 km/h. So if you don't mind the new car, you can run at high speed at will.

All new cars require a break-in period. Therefore, it is recommended to speed up again during the run-in period or after the first warranty (generally 3000 kilometers or 3 months). If you want to run a long distance directly, the new car can also run, but the speed and speed should be well controlled.

Generally speaking, the speed of the above car does not exceed 80 kilometers within 500 kilometers, 120 kilometers within 3000 kilometers, and the engine speed does not exceed 3000 kilometers within 3000 kilometers. After 3000 km, you can drive the slim freely and safely.

During the break-in period, the most important thing is to limit the engine speed. In the run-in, high engine speed will increase the possibility of damage to the piston rings, so the general manufacturer will recommend that the speed limit of the new car is in the speed range of 80 90 km h and 80 90 km h.

Whether it is a manual transmission or an automatic transmission, it is an automatic speed switching point according to the normal shift requirements. The engine speed in this speed range is about 2,500 rpm, and the maximum speed does not exceed 3,000 rpm.

The run-in car can run long distances. But it is not recommended to run for a long time, because the new car needs to be run-in. When the new car leaves the factory, due to the error in the machining accuracy and assembly process of the parts, a certain mileage of running-in is required.

the impact of the break-in period on the car;

1.Running-in can have a significant impact on the longevity, safety and economy of a car.

2.The run-in mileage of cars is generally 1,000 to 2,500 kilometers, while the run-in mileage of imported cars is longer, mostly 1,500 to 3,000 kilometers.

3.The run-in period is divided into three stages, the initial 100km, the middle 200km, and the 3000km run-in period to form an oxide film.

4.In order to let the car pass the run-in period smoothly, check and maintain it at ordinary times, pay attention to the above problems, and improve the quality of the run-in.

Attention should be paid to the break-in period of the vehicle:

1.The engine speed should not be too high. It is best not to exceed 3000 rpm, and the speed of 60-90 km/h is ideal.

2.During a cold start, there should be a warm-up process. Once the water temperature changes, it's ready to hit the road. It usually takes about 3-5 minutes.

3.Don't rush to refuel or brake, try to maintain a constant speed. During the run-in period, the maximum speed of the vehicle shall not exceed 100km/h, but it shall not drive at low speed for a long time. Pay attention to shifting gears while driving, and do not drive in one gear for a long time.

4.It takes about 4 hours to drive at high speed. It is recommended to turn off the car and rest for half an hour.

1.Warm up before you start:

A new car needs to be warmed up before starting. If left for too long, the oil will flow back to the bottom of the case. If you start and drive away, the car may wear out excessively.

After a cold start, the car warms up for 30-40 seconds before starting. Don't rush to accelerate after starting, wait for the water temperature to be normal before accelerating.

2.Control engine speed:

Try to maintain a constant speed during the run-in period, control the tachometer between 2000-4000 rpm, and do not drive in first gear or high grade for a long time. Automatic transmission cars should also pay attention to shifting gears during use. Flexible gear selection can promote the break-in effect.

3.Don't brake suddenly:

Especially for new cars, try not to brake urgently while driving. Emergency braking not only strikes the braking system, but also the chassis and engine of the car. Therefore, during the run-in period, it is necessary not only to control the speed, but also to have an understanding of the surrounding traffic conditions.

4. Don't blindly pull up the speed:

High-speed traction should be carried out after the break-in period. Instead of increasing the speed of the vehicle, pulling at high speed increases the engine speed. The engine speed should be 2000-4000 rpm during the run-in period, which is not suitable for pulling the car at high speed during the run-in period. This is something that car owners should be aware of.