The whole process of the subject 2 test, the whole process of the driving test subject 2 test?

All the steps of subject 2 include reversing, side parking, fixed-point starting, and curve driving;

1. Reverse the warehouse, control the clutch speed, observe the rear through the rearview mirror, fine-tune flexibly, do not press the line, and do not hit the wrong direction;

2. Parking on the side, pay attention to the distance of the rearview mirror and the side line;

3. Start at a fixed point, pay attention not to hang the gear, and control the speed.

4. When driving in curves, pay attention to correct the steering wheel in time and do not press the line;

5. When turning at right angles, be sure to remember to hit the turn signal.

The five subjects of the subject 2 exam are much more difficult than the other three subjects, and the exam not only requires the students' skills, but also has requirements for their psychological quality.

1. Preparation for the exam.

Before the exam, students need to prepare relevant documents, especially the original ID card, without the ID card can not enter the examination room for the test, can not take mobile phones, backpacks, cigarettes, lighters, can not wear slippers, high heels.

2. Waiting for the examination. After entering the examination room, hand over the original ID card to the instructor, wait in the waiting hall, shout your name to line up outside, conduct iris verification, divide the test car, and then wait in the waiting area, and find your vehicle when you hear your name called.

3. Get on the bus and prepare.

After the commander verifies the ID card information, after getting into the car, first adjust the seat, wear a seat belt, observe the dashboard, brakes, gears, lightly step on the brakes and clutch to find a feeling, these preparations are very necessary, not in advance after the observation has an impact on the follow-up test, especially the brakes and clutch, different vehicle clutches and brakes are not the same, unfamiliar in advance, a little bad operation is easy to stall.

4. Subjects 2 or 5.

There are 2 chances for the exam on the day, students are required to pass all five items, with a full score of 100 points, 80 points to pass, after the voice prompt score is unqualified, the student needs to return to the starting point and retake the second exam, if the two times on the same day are not qualified, it needs to be separated by 10 days before the subject two can be booked for the exam, and there are a total of 5 computer-based test opportunities (there are 2 exam opportunities on the same day).

5. Signature of transcripts.

After the end of the test, you should leave the examination room quickly, and should not hinder other students from taking the test, after the voice prompt results are qualified, you need to go to the transcript signing place and sign on your own transcript.

Please take a closer look:The following is the full process of the Subject 2 exam:

2. Learn system operation: After entering the test vehicle, candidates need to understand the system operation, including the adjustment and use of seats, rearview mirrors, seat belts, steering wheels, etc.

3. Introduction of test items: Candidates listen to the introduction and precautions of the invigilator to ensure that they have a full understanding and mastery of the test content and process.

4. Fasten your seat belt and start: Candidates first need to fasten their seat belts, and under the instructions of the invigilator, carry out basic actions such as starting and stopping to test the candidates' operating skills and reaction speed.

5. Simulated community driving: Candidates carry out multiple items such as reversing and warehousing, side parking, right-angle turning, and curve driving in the simulated community to test the candidates' spatial perception and operation skills.

6. Road driving items: Candidates need to drive in a straight line, overtake, change lanes, pull over and other items on the specified roads according to the instructions of the invigilator to test the candidates' traffic safety awareness and actual driving skills.

7. Evaluation of examination results: After the examination, the invigilator will evaluate the examination process and results, and give corresponding results and suggestions according to the candidates' results.

In short, the whole process of the subject 2 test requires candidates to be proficient in driving skills and safety awareness, abide by traffic rules and test requirements, and carefully follow the instructions and arrangements of the invigilator to ensure that the test is passed smoothly. At the same time, candidates also need to pay attention to personal psychological adjustment and stress management, and maintain calm and self-confidence in order to cope with unexpected situations and exam pressure.

Here are some of the notes for the Subject 2 exam:

1. Familiar with the examination process of Zhichun University: Before the examination, you should be familiar with the examination process, precautions and scoring criteria in advance, and understand the content and form of the examination, so as to better cope with the examination.

2. Vehicle operation specifications: During the test, you need to drive in strict accordance with the vehicle operation specifications, including using seats, adjusting rearview mirrors, wearing seat belts and other routine operations.

3. Pay attention to the road conditions: In the simulated community driving and road driving projects, candidates need to pay attention to observing the road conditions, obey the traffic rules and signs, and ensure the safety and smoothness of driving.

5. Pay attention to technical details: In many projects such as reversing and storage, side parking, right-angle turning, and curve driving, it is necessary to pay attention to technical details, such as clutch control at start, steering wheel use when steering, etc.

6. Overall coordination: During the examination, candidates are required to have a certain degree of overall coordination, such as flexible steering wheel control, timely acceleration and deceleration mastery, etc., in order to better complete the examination items.

7. Stay calm: During the test, candidates need to stay calm, concentrate, and try to avoid nervousness and anxiety in order to better play their driving skills and practical operation level.

In conclusion, in the Subject 2 exam, candidates need to pay attention to details, follow the rules, stay calm, and fully cooperate with the invigilator's instructions and arrangements to ensure a smooth passage of the exam. At the same time, candidates also need to pay attention to personal psychological adjustment and stress management, maintain self-confidence and calm, and prepare for the next step of the Subject 3 exam.

The whole process of the driving test subject 2 test is as follows:

Identity Verification: Candidates are required to present valid identification for identity verification.

Vehicle Visual Inspection: Candidates are required to conduct a visual inspection of the test vehicle to ensure that the vehicle meets safety standards.

In-car operation inspection: Candidates need to check the operation of the controller, lights, horns and other equipment in the car as required.

Reversing and side parking: Candidates need to complete the two operations of reversing and side parking in the designated area in accordance with the regulations.

Right-angle turning and curve driving: Candidates need to complete two operations of right-angle turning and curve driving according to the requirements.

Uphill start: It refers to mastering the correct methods and techniques to ensure that the vehicle can start smoothly when starting on the uphill road.

<> the whole process of the subject 2 exam operation to see how much you have mastered?

Get in the car

1. Adjust the seat, front and back, up and down, and adjust the backrest.

2. Adjust the rearview mirror, the left rear door handle is on the top, the rear wheel can be seen, and the rear wheel cannot be seen on the right side (just keep it the same as the usual practice).

3. Fasten your seat belt, step on the clutch brake, hang up the first gear, and release the handbrake.

Reversing into storage1. About a meter away from the left sideline, drive to the shoulder and the dotted line, and stop.

2. Hang the reverse gear, look at the left rearview mirror, and the dotted line is in line, and the right is killed.

3. Look at the right rearview mirror, the body is parallel to the yellow line, and the steering wheel is back to the right.

4. Look at the left rearview mirror, the angle of the rearview mirror and the dotted line are two fingers, and stop.

Reversing into storage5.When leaving the library, which side of the wide steering wheel to which side to play half a circle, with 3 seconds, hang a gear, the rearview mirror to see the rear wheel of the car and the corner of the library coincide, the left killed.

6. Look at the front of the car, the body is positive, back to the right, and the shoulders and the dotted line are parked.

7. Hang the reverse gear, guess the slag rearview mirror coincides with the yellow line, and the left is killed.

8. The body is parallel and correct.

Curve driving1. The shoulders are in line with the yellow line, the left is killed, and the middle is entered.

2. Go straight to the car approaching line, turn left, and stick to the line.

3. Back to the right, the wiper sticks the line, the right circle, and sticks the line.

Right-angle turns1. Turn on the turn signal and align with the turn word.

2. Hit the left with a line between the handle and the corner.

3. Turn off the turn signal and return to the center.

Ramp fixed stop and start1. The shoulder and the yellow line were killed on the left.

2. The steering wheel is aligned with the word car and goes.

3. The bottom of the rearview mirror coincides with the two lines of the first dissipation, and stops.

4. Pull the handbrake and release the handbrake.

5. The steering wheel is 45° on the left

6. Slowly loosen the clutch to shake and release the brake.

7. Downhill press the clutch and brake.

The full process of the Module 2 exam is as follows:1. Pile test: correctly judge the position of the driving space of the body, and control the vehicle to complete the reversing or advance through the space limit obstacle at low speed. Hundred.

2. Reversing and warehousing: correctly judge the reversing trajectory of the vehicle and control the vehicle to complete the reversing and warehousing.

3. Ramp fixed-point parking and starting: accurately judge the parking position; The accelerator pedal, parking brake and clutch are used in harmony for a smooth start.

4. Side parking: Manipulating the vehicle to park correctly into the parking space (garage) on the right side of the road during the movement.

5. Curve driving: Operate the steering device in motion to control the curve driving of the vehicle.

6. Right-angle turning question: Correctly control the steering device in motion, and judge the difference between the inner and outer wheels.

Subject two, also known as the road test, is a part of the motor vehicle driving license assessment, is the abbreviation of the field driving skills test subject, the car C1C2 test items include reversing into the garage, side parking of the car, ramp fixed-point parking and starting, right-angle turning, curve driving (commonly known as S bend) five compulsory tests (in some areas there is a sixth high-speed card).

After entering the car, the trainees adjusted their seats, fastened their seat belts, adjusted their reflectors, and entered their fingerprints in accordance with the regulations. When the voice prompts you to take the test, drop the hand brake and take the test. During the test, the order of reversing into the garage - side parking - ramp fixed-point parking and starting - right-angle turning - half-slope parking and starting will be carried out one by one (there will be differences in different areas, and banquet friends can mainly ask the instructor of the driving school).

1.Upside-down storage: Upside-down storage is a subject that is practiced a lot during the subject 2 exam, and it is also a subject that middle school students find the subject 2 exam more difficult.

When reversing into storage, the most important thing is not to stop halfway. If you stop, you'll fail the exam.

2。Side Parking: Side parking is a commonly used technique in everyday driving.

Drive your vehicle to the front of the garage parallel to the direction of travel and drive right back to the warehouse. There can be no pause in between. If the side parking within this range does not cross the garage edge line, it will pass.

Pay special attention. If you give up halfway, you will fail the exam.

3。Right-angle turn: When making right-angle turns, you need to control the speed of the vehicle and make a low-speed sharp turn of 90 degrees according to the prescribed driving route to pass the right-angle turn.

If you don't make a U-turn or turn off the engine halfway through, you will be deducted points. Pay attention to the angle of the car when turning at a right angle, and try to stay on the side of the road so that it is easy to pass. Fixed-point parking on the hill:

When going up the hill to stop at a fixed point, students are most worried about the problem of turning off the engine. When the car is parked on a slope, the handbrake will be tightened to prevent the car from skidding, and then the process of starting on the slope and accelerating through the slope is the half-slope start test. There are also penalties for driving.

4。Fixed-point parking at uphill start: When starting at fixed-point parking uphill start, students are most worried about the problem of slowing down the burial.

When the car is parked on a slope, the handbrake will be tightened to prevent the car from skidding, and then the process of starting on the slope and accelerating through the slope is the half-slope start test. There are also penalties for driving.

5。After the ramp stops at a fixed point and starts, a voice prompt will appear in the car. If you pass, the system will prompt "Passed the exam, please print the score at the test center"; If you fail, it's a "failed exam".

Millions of car purchase subsidies.

Subject 2 Exam Process:

1. Sign in. Bring your original ID card and admission ticket for the exam, and arrive at the waiting hall in advance according to the date and session of the exam you have booked.

2. Waiting for the exam. After entering the waiting hall, follow the instructions of the staff, do not make loud noises or move, and if you really need to leave, please say hello to the staff.

3. Get on the bus and prepare.

After getting in the car, adjust the seat, fasten the seat belt, and then adjust the rearview mirror to the right position for you, and then verify your fingerprint after all this is ready, and enter the corresponding test path according to the prompts.

4. Take the exam.

There are two chances for each exam, and you need to pass all five elements to pass the whole subject two, otherwise you have to retake the exam. If you still don't pass the test after running out of two test opportunities, you need to practice again to make an appointment for the test.

5. The end of the exam.

After the test, you should leave the test venue quickly, do not interfere with others to take the test, bring the sign-in number to the printing window to print your results and sign them.

Subject 2 Exam Note:

1. After the test starts, it should be noted that there can be no parking, no slipping, no shifting, no stalling, no turning off, no crossing and pressing the line during the whole test.

2. Reversing and warehousing: pay attention to the body and do not press the line; When reversing, pay attention to the point and carefully observe the direction of the rearview mirror body; After the car enters the warehouse, the wheel must be corrected, and the car must not be too much after storage; Pay attention to the control of time.

3. Side parking: adjust the position between the body and the storage location, not too close, which is not convenient for the candidate to operate; Look at the line when playing the direction; When leaving the warehouse, it is also necessary to observe whether the body has a crimping line.

4. Right-angle turning: right-angle turning is the simplest of the five, when you are about to reach the right-angle point, you should quickly kill the steering wheel when you see the point, the body turns slowly, and you can return to the right when you go out of the line, and the students can not relax their vigilance because of simplicity.

5. Precautions for fixed-point parking and starting of ramps: pay attention to control the distance between the body and the edge to be 30 cm; Drive slowly and find a designated point to stop; When starting, pay attention to finding the right semi-linkage.

6. Precautions for curve driving: the speed of the vehicle should be controlled, each curve should be found at the right point, and the timing should be accurate.