How to clean the dust of the Midea vertical air conditioner, how to remove the dust of the Midea ver

1. First of all, turn off the power supply of the air conditioner. This is very important, and electrical appliances must pay attention to safety.

2. Remove the front panel of the air conditioner, cut it directly, and lift it upwards, and you will see two filters. (Different models may not be consistent, read the instructions carefully, usually, there is a wrench on both sides of the product, and you can remove the panel by pulling it down hard.) After turning on the air conditioner panel, we can see that the filter screen is covered with dust.

When removing the filter, gently push it up and then pull it down slightly so that the filter is removed.

3. Remove the filter, and the small one is the medium (the function is to filter formaldehyde and bacteria).

4. The function of the filter medium is to remove formaldehyde and bacteria, which cannot be cleaned with water, and can only be exposed to the sun for three or four hours. 5. Use clean water and a soft brush to clean the filter with a water pipe, and do not use a hard brush.

6. Install the cleaned filter back into the air conditioner, and wipe it clean in advance if there is a dirty place inside the air conditioner. In this way, empty.

It is much cleaner and fresher when you use it again.

When dismantling, you must pay attention to observation, I took a long time to try to open, the main point is to start with the middle seam, loosen first, and then drag out.

Take the shell away, there are dust filters on both sides of the shell, pull it out, if there is a formaldehyde buster net on the Midea dust filter, you take it down, and then put it in clean water to clean it, wash it, and just do it on the original road

Remove the housing, wash the filter with warm water, and then use a brush or hair dryer.

If there are fixing screws on the cabinet inlet grille (i.e., both sides of the cabinet air conditioner), it can be opened after screwing; If there are no screws, they are magnetically attached and require a little force to open. After the inlet grille is opened, you can see the position of the filter, and the side air inlet filter is at the inlet and outlet position, and the filter screen is taken out. You can refer to your manual for details.

When cleaning the air filter, it should be rinsed under the tap and should not be cleaned with hot water above 40 to prevent shrinkage and deformation. After cleaning, shake off the water on the filter screen, insert it into the panel and install the air conditioner. That's it!

If you still have questions, you are welcome to ask questions to the company in the United States; I wish you a smooth work and a happy life!

Remove the case and use a brush or hair dryer.

Remove the shell and rinse with clean water.

The dust removal method of Midea vertical air conditioner is as follows:

1. Cut off the power supply: In order to be safe and prevent the risk of electric shock, we must first cut off the power supply of the air conditioner before cleaning, and before cleaning the air conditioner, it should run in a ventilated state for 2 to 3 hours before removing the air conditioner.

2. Clean the filter screen: In the process of long-term use, the air conditioner has a certain adsorption of dust due to the static electricity of its own electrical appliances, and the filter screen inside the air conditioner leaves the dust and other suspended particles in the air on the filter screen when filtering the inhaled air, so the filter screen is the key to dust removal;

3. Open the front panel of the air conditioner first, take out the filter screen, clean it with a clean filter brush, brush most of the dirt attached to the filter screen, the filter screen is best cleaned with clean water, if there is too much dirt on it, you can clean it with a small amount of neutral dish soap, soak the filter screen in the cleaning liquid containing special effect air conditioner or neutral dish soap, soak it for about 15 minutes, gently brush the filter screen with a brush, so that each filter hole is clear and transparent, no traces of dirty blockage, and finally wipe dry with a special cleaning cloth. Check that it is intact, install the filter to the body, and observe whether it is operating normally.

The dust removal method of Midea vertical air conditioner is as follows:

1. Cut off the power supply: In order to be safe and prevent the risk of electric shock, we must first cut off the power supply of the air conditioner before cleaning, and before cleaning the air conditioner, it should run in a ventilated state for 2 to 3 hours before the air conditioner is dusted;

2. Clean the filter screen: In the process of long-term use, due to the static electricity of the electrical appliances itself, it has a certain adsorption of dust, and the filter screen inside the air conditioner does not filter the inhaled air when it is dry, and the dust and other suspended particles in the air are left on the filter screen, so the filter screen is the key to dust removal;

3. Open the front panel of the air conditioner first, take out the filter screen, clean it with a clean filter brush, brush most of the dirt attached to the filter screen, the filter screen is best cleaned with clean water, if there is too much dirt on it, you can clean it with a small amount of neutral dish soap, soak the filter screen in the cleaning liquid containing special effect air conditioner or neutral dish soap, soak it for about 15 minutes, gently brush the filter screen with a brush, so that each filter hole is clear and transparent, no traces of dirt blockage, and finally wipe dry with a special cleaning cloth to check that it is intact. After installing the filter on the body, observe whether it is operating normally.

Dear, I'm glad to answer for you: How to remove dust from Midea air conditioner Filter cleaning: Use special tools, cover cloth (placed to prevent dust from falling when cleaning the air conditioner) to clean the indoor unit, filter cleaning.

First of all, open the lid of the air conditioner room and take out the filter. Use a clean filter brush to brush away any dirt attached to the filter. Rinse with tap water and wipe the filter dry with a soft, dry cloth.

Evaporator fin cleaning: Wipe off the dirt inside the air conditioner with a damp cloth first. Then shake the special air conditioner cleaning agent and spray it evenly on the air inlet surface of the air conditioner evaporator to ensure that the cleaning foam completely covers the surface of the evaporator.

Air conditioner shell cleaning: First wipe off the dust of the air conditioner shell with a damp rag, apply a little toothpaste, and then wipe it with a dry rag to make the air conditioner shell white. end Outdoor unit cleaning:

First, test whether the current of the air conditioner is normal, and then rinse the condenser fins directly with clean water.

Summary. Hello dear, when cleaning the air conditioner filter, you need to cut off the power of the air conditioner first;

When disassembling the wall-mounted air conditioning panel, there is a dark handle on both sides of its indoor unit, and the panel can be lifted with a little force with both hands, and the lower part of the cabinet needs to be disassembled when opening the panel of the cabinet, and the air conditioning filter can be taken out and cleaned after the air conditioning panel is opened;

When cleaning the air conditioning filter, its cleaning method is very important, when using water to rinse, you can not directly rinse the dusty side, and at the same time, when cleaning, the scrubbing tools it uses should be cleaned with a soft brush, and when using a soft brush, you should brush and shoot along the lines.

After the air conditioner filter is cleaned, shake off the moisture on the filter and place the filter in a cool and dry place to dry.

How to remove dust from Midea air conditioner.

Hello, I have seen your question and am sorting out the answer, please wait a while

Hello dear, when cleaning the air conditioner filter, you need to cut off the power of the air conditioner first; When disassembling the wall-mounted air conditioning panel, there is a dark handle on both sides of its indoor unit, and the panel can be lifted with a little force with both hands, and the lower part of the cabinet needs to be disassembled when opening the panel of the cabinet, and the air conditioning filter can be taken out and cleaned after the air conditioning panel is opened; When cleaning the air conditioning filter, its cleaning method is very important, when using water to rinse, you can not directly rinse the dusty side, and at the same time, when cleaning, the scrubbing tools it uses should be cleaned with a soft brush, and when using a soft brush, you should brush and shoot along the lines. After the air conditioner filter is cleaned, shake off the moisture on the filter and place the filter in a cool and dry place to dry.

Cabinet machine, how to disassemble.

Look at what I sent you.

Cabinet machine, can not be opened.

The cabinet can't be opened, why?

1. Disassemble the lower part of the cabinet machine; If it is hang-up, there are two hidden handles (grooves) on both sides of the indoor unit, and you can lift the panel outward with a little force with both hands. If it is a cabinet machine, there are two plastic decorative caps on the plastic fence of the air inlet panel at the lower part of the machine, and the fixing bolts will be exposed when the decorative caps are removed, as long as the fixing bolts are removed.

2. Attention! It is said that the air inlet filters are made of nanomaterials, so it is necessary to clean them properly, and use a soft brush to brush and shoot along the lines, and it is best not to wash with water.

3. Find the screw position or some of them are through a card position to strengthen the shell, and you can see the dust filter after disassembling the shell;

4. Remove it, clean it with water, dry it and put it back on.

How it works:

Disconnect the power supply: For safety and prevent the risk of electric shock, we must first disconnect the power supply of the air conditioner before cleaning. Before cleaning the air conditioner, it should be operated in the state of air supply for 2-3 hours.

Clean the filter: In the process of long-term use, the air conditioner has a certain adsorption of dust due to the static electricity of its own electrical appliances, and the filter screen inside the air conditioner leaves the dust and other suspended particles in the air on the filter screen when filtering the inhaled air, so the filter screen is the key to dust removal.

First open the front panel of the air conditioner, and pull up the two sides of the air conditioner with your hands to open it. Take out the filter and brush it with a clean filter brush to clean most of the dirt attached to the filter. It is best to clean the filter with clean water, if there is too much dirt on it, you can use a small amount of neutral dish soap.

Soak the filter in a special air conditioner cleaning liquid or neutral dish soap, soak for about 15 minutes, and gently brush the filter with a brush to make each filter hole clear and transparent, without dirty blockage. Finally, wipe dry with a special cleaning cloth, check that it is intact, install the filter screen on the body, and observe whether the operation is normal.

Use a vacuum cleaner to absorb dust: Some fine dust on the skeleton of the air conditioner or evaporator can be adsorbed by a vacuum cleaner. Since the aluminum sheet of the evaporator is relatively fragile, do not touch it with force when removing dust with a vacuum cleaner, and you can also use a professional air conditioner cleaner to clean it.

Cleaning of the indoor unit shell: Wipe the shell with a damp cloth, if there is too much dirt, you can wipe it with a small amount of cleaning agent.

After the air conditioner is cleaned and installed, start the air supply device of the air conditioner for about 20-30 minutes to dissipate the moisture in the machine.

When the air conditioner is used in summer, it will absorb a large amount of dust, bacteria and harmful substances, if not cleaned in time, the bacteria, viruses and other harmful substances in the air will breed and multiply in the air conditioner, resulting in air pollution and affecting health. Therefore, clean air conditioning is a necessary measure to protect the health of the family.

Here are a few Midea air conditioner dust removal methods::

1.Disassemble the air conditioner filter for cleaning: when the air conditioner is operating, the air will enter the inside through the filter for cold and heat exchange, then the filter screen is easy to be eroded by dust, bacteria and harmful substances in the air.

2.Spray cleaning liquid: For cleaning the exterior of the indoor unit of the air conditioner with a neutral detergent, before spraying, you can use a vacuum cleaner to remove stubborn stains to avoid stains adhering to the air conditioner.

3.Complete cleaning: Disassemble the air conditioner and clean the internal components, using professional tools such as high-pressure water guns and washing machines. After washing, wipe off water stains and dry, and re-assemble the noise.

4.Regular cleaning: When using the air conditioner, clean the inside of the air conditioner every once in a while to avoid the dust accumulated by the air conditioner and the bacteria that affect the air quality and the health of the user.

It should be noted that when cleaning the air conditioner, the power must be turned off. If you don't know how to clean the inside of your air conditioner, it is recommended to ask a professional to do it.

Through the cleaning of the air conditioner, the dust, bacteria and harmful substances attached to the air conditioner can be removed, the air quality can be improved, and the quality of life can be improved, so the air conditioner should be cleaned at least once a year.