Seek help! Problems with my Samsung S800 camera!

Updated on number 2024-04-30
18 answers
  1. Anonymous users2024-02-08

    The fastest shutter speed of the S800 is only 1 500 seconds (the parameters on the manual are deceptive), so when you set the ISO to a very high level, such as 1000, then as long as it is daytime, all the ** will be overexposed, which is what you say.

    It is possible that the high ISO settings that were used in the automatic mode at that time have been retained, so it has affected the current photography, and it is also possible.

    Of course, it may also be a hardware problem, I can't be sure here, but it's nothing more than a problem with the CCD and the processing chip, so it should be sent for repair as soon as possible.

    It could also be like this:

    1.There's a white balance adjustment inside that you can try to turn to auto white balance.

    2.The lens of the camera is free of dust, as dust can affect light refraction.

    3.There are no loose parts inside, because loose will cause the camera to vibrate and blur when you press the camera's shutter.

    4.You pay attention when adjusting the focus to see if there are any mistakes.

    Check that the white balance is correct. 2, Whether the CCD is broken. 3. Whether the ISO sensitivity is adjusted too high.

    5.Don't face it, it's not in principle.

  2. Anonymous users2024-02-07

    1. Check whether the white balance is correct.

    2, Whether the CCD is broken.

    3. Whether the ISO sensitivity is adjusted too high.

  3. Anonymous users2024-02-06

    Judging by your description, it seems that the ISO sensitivity is too high in program mode, but what about other modes, such as dynamic camera effects?

  4. Anonymous users2024-02-05

    Books on photography.

  5. Anonymous users2024-02-04

    There is a problem with your camera, please take it to a special repair center for repair. I do Samsung wholesale, please trust me, I've seen this situation much better. It's the CCD that's wrong.

  6. Anonymous users2024-02-03

    See what the current shooting parameters, aperture and shutter are.

    Try it in a different mode, but if it doesn't work, you have to go to the repair station to check.

  7. Anonymous users2024-02-02

    You don't have to deal with it.

    The key reason is that it doesn't work out of principle.

    It's going to be reflective.

  8. Anonymous users2024-02-01

    Then you don't have to deal with it.

    The key reason is that it doesn't work out of principle.

    It's going to be reflective.

    It would be good for you to have time to read books on photography.

  9. Anonymous users2024-01-31

    Samsung S800 is indeed a 1-inch CCD Yes But it doesn't matter much The pixel of this camera is 800W very high But the color is not as vivid as Canon But I think it's closer to reality Because Samsung's main product is a mobile phone Because the ranks of digital cameras are relatively late, so**Not very high But this is not important I think S800 is very suitable for home use Not good quality can be used The shell is made of all metal Very beautiful and strong! It's also very clear at night that now**standalone** is about 1600 If you buy it, you can buy a 1g card Totally less than 1800 Compared to Sony, Canon** is much cheaper Your own home is still relatively affordable, and it can meet any requirements The quality and after-sales service are also good The most important thing is that Samsung digital cameras have very few parallel imports!

  10. Anonymous users2024-01-30

    The CCD size of the S800 is smaller than that of other models, and a common disadvantage of Samsung's machines is that the CCD often has problems. And the words on his fuselage are easy to mix. The advantage is that the pixels are high, and there is a manual function.

    None of the others are compared to the 8 million pixels of other brands.

  11. Anonymous users2024-01-29

    Samsung's repair rate is relatively high compared to other products that sell birds, and the lens cannot be retracted, mostly because the part of the lens motor connection is plastic. Extrusion bump, or long-term use will cause falling off or breaking, the general maintenance of hot buried, or direct attack for a new one, the cost is very low, dozens of yuan can be done, the maintenance station charges about 110 yuan, is normal.

  12. Anonymous users2024-01-28

    Look at your situation should be a problem with lens transmission, to repair very cautious Tuanshan is easy, not expensive, less than 100 yuan can be done, to some places that sell cameras to leave the width of the machine will help you take it to repair or empty.

  13. Anonymous users2024-01-27

    Is it that the battery is out of power, you can fully charge the battery and open it to see.

  14. Anonymous users2024-01-26

    I figured out the camera by myself and knew how to focus wwww

  15. Anonymous users2024-01-25

    The memory card is generally an SD card, with a lock card on it, which can be opened until dialed, otherwise the camera memory card will be locked.

    If it still doesn't work, the card is broken, and you can change it.

  16. Anonymous users2024-01-24

    First of all, it is recommended that you restore the factory settings, and secondly, if it is horizontal and horizontal on the screen, if there is nothing wrong with the lens, it is a problem with the screen, and it will not affect your imaging, which is the visual feeling. If there is a problem with the screen, it is recommended that you go to after-sales, but this machine may be about 2 years after you bought it, it is very expensive.

  17. Anonymous users2024-01-23

    I guess it's a camera problem.

    Even sometimes the memory card has a problem, and the camera doesn't have a screen quick capture function, so it's slower, so you go to the dealer or the digital counter and ask.

  18. Anonymous users2024-01-22

    The first method: first move the ** in the mobile phone to the mobile phone expansion card, and then use the card reader to open it on the computer and copy it to the disturbing computer.

    For example, installing Samsung's PC suite Samsung PC Studio 3 on the computer can directly swap the files in the phone's own internal memory with the computer.

Related questions
5 answers2024-04-30

Hello: According to your description, whether the software installed on your phone is caused by an error, please try the following methods: >>>More

8 answers2024-04-30

You can install a third-party camera software to see if it's a software problem. >>>More

15 answers2024-04-30

Samsung phone camera permissions do not need to be set separately, if you can't use the camera function, you can try:1If you can, try to go to Camera - Photo Mode - Settings (click the pinion icon) - Reset - OK2 >>>More

9 answers2024-04-30

Causes: The system is disordered due to incompatibility or root of third-party software, accidentally uninstalling system programs, or the motherboard of the mobile phone is damaged. >>>More

9 answers2024-04-30

If you lose your phone, you can report it to the relevant authorities and register it. And report the loss as soon as possible to reissue the mobile phone card and payment account, and change the login and payment password of the relevant account. >>>More