-
If the graphics card driver is problematic, delete the graphics card driver in safe mode, and then reinstall the driver.
There was this virus a year or two ago, you can change the graphics card driver, after deleting the graphics card driver, it is best to shut down, take off the motherboard battery, 5 seconds to 10 seconds, and then find and hold the power button for 6 seconds, let the machine completely discharge, and then enter the safe mode to install the graphics card driver.
I've tried to reinstall the system but it didn't work, and I really thought the graphics card was broken
-
Oh, it must be that your system has the wrong driver but installed it, just the system's own driver, so you try to change the system, because it should be no problem.
-
You can check your device management after entering safe mode, and if you have a problem with the driver, you can turn it off and start it again. It is estimated that the drivers of some devices need to be updated (with drivers that are one grade higher than the original driver).
-
It must be a problem with the system, you are reinstalling the system.
-
Then your machine should be a single display, unplug the graphics card, clean it up, plug it in, and take a look.
The above didn't use to reinstall the system, my teacher told me to stop at the welcome screen, it might be a PCI slot problem.
-
It is recommended that you do not use the ghost version! Use Slow Loading! Maybe your computer is older!
-
ghost will have a lot of unexpected problems, it is recommended to install it normally.
-
The computer cannot load the graphics driver.
-
F8 enters safe mode to try If it doesn't work, just reinstall the system.
-
When the computer is not in use for a long time, the chassis and accessories should be thoroughly dusted and cleaned, the gold finger (yellow copper sheet) of the memory and graphics card should be wiped clean with an eraser, and the computer should be warmed up several times after assembly. The power supply should also be dusted clean.
This is caused by poor circuitry caused by dust, which affects heat dissipation, and some contacts have poor contact due to copper oxidation.
If it has been reinstalled, there is no virus or Trojan horse. There are a lot of things that don't load in safe mode, so sometimes the driver settings are wrong or conflicting, you can't see it in safe mode, you can try to remove some unnecessary boards first to see if it can start normally, and then add them step by step and try again until you find the problem.
Also, you try to change the installation disk, maybe there is a problem with the disk.
-
That's because your software has a conflict with the system or software with the hardware.
All you have to do is find the conflicting software and uninstall one of them.
If you can't figure it out, you'll have to reinstall the system.
-
There is a conflict in the interrupt request for the hardware. The solution is to discharge the motherboard, there is a button cell battery on the motherboard, detain it, and install it after five minutes. If it doesn't work, it should be a power supply problem.
-
In this case, most of the drivers are more likely to be larger,I was the network card driver two days ago,Later, a friend recommended me to update the driver with 360 hardware masters。 I know you can't enter normal mode, but you can disable suspicious drivers in safe mode, test them one by one, and then use 360 Hardware Master when you can use normal mode.
Graphics card issues. Check to see if your graphics card driver is installed. Or the graphics card is not compatible with the motherboard.
It may be that there is a problem with the data cable.
Just use Windows Optimizer.
Based on the information you provide, it can be judged as the following problems! >>>More
The reason for this problem is that the startup was deleted. >>>More