What are the benefits of surface installation of decorative water pipes?

Advantages and disadvantages of water pipes:

Advantages: 1. It is conducive to maintenance and replacement. If there is a quality problem with the water pipe in the future, it can be found in time, and there is no need to make a big deal to repair it, so it is not so troublesome.

Disadvantages: 1. The aesthetics are very poor, which directly lowers the indoor grade to the level of rental housing. 2. The water pipe is easy to be stained, and even moss will grow, which affects the appearance, and it is more troublesome to clean and clean it daily.

Advantages and disadvantages of water pipes going dark:

Advantages: The pipeline is the easiest to install, the material is not much, and the length of the water pipe is the shortest, so it is the most cost-effective method if it is calculated by meters.

Disadvantages: In case of water leakage, it is not easy to find, the maintenance is the most troublesome and may cause significant damage (such as soaking the floor, destroying the downstairs neighbor's cabinets and ceilings), and the floor needs to be pried open for repair.

After the above analysis, whether it is open or covert has its own merits, and the regulations do not clearly have to go. Obviously, it is a more prudent choice for the water pipe to go to the top, but the cost is relatively high, and although the cost of walking to the ground is low, it is not easy to find the problem. How to choose, please decide according to your actual situation.

The biggest advantage of the exposed water pipe is that if there is any problem in the future, it will be easier to repair and deal with, because there is no need to remove the bricks. But choose the surface, the water pipe try not to choose plastic material, easy to age and fade, affect the appearance and hygiene, it is best to choose the thin-walled stainless steel water pipe, its pipe wall is bright and beautiful, easy to clean, basically with warm water brush, that is, to restore the original bright characteristics of stainless steel, more importantly, its health performance is good, the appearance of high-end and generous. Huaran decoration shares hope it can help you.

Surface-mounted pipes are laid indoors along walls, beams, columns, under ceilings, and next to floors.

The advantages of surface-mounted installation are low cost, convenient construction, installation, and later maintenance and repair. The disadvantage is that the surface of the pipeline is dusty, condensation, etc., which affects environmental hygiene.

The comparison table of water pipe specifications and sizes is shown below.

1. Size: DN15 (4 pipes), DN20 (6 pipes), DN25 (1 inch tube), DN32 (1 inch 2 tubes), DN40 (1 inch half tube), DN50 (2 inch tubes), DN65 (2 inch half tubes), DN80 (3 inch tubes), DN100 (4 inch tubes), DN125 (5 inch tubes), DN150 (6 inch tubes), DN200 (8 inch tubes), DN250 (10 inch tubes), etc.

2. Divide 1 inch into 8 equal parts of 8 inches.

It is equivalent to 1 to 7 points, and the smaller size is represented by 64, and the unit is still inches. If the denominator and the numerator can be reduced (e.g., the numerator is ), they should be reduced.

The indication of inches is to put two apostrophes in the upper right corner, such as 1 2"

For example, the water pipe of DN25 (25mm, the same below) is the imperial system 1"The water pipe, which is also the former 8-point pipe.

The water pipe of DN15 is the imperial system 1 2"The water pipe, which is also the former 4-point water pipe.

For example, the water pipe of DN20 is an imperial 3 4"The water pipe, which is also the former 6-point pipe.

1. The thickness of the wall of the cold and hot water pipes is different, and the cold water pipes cannot be used as hot water pipes, and the easy way to distinguish the cold and hot water pipes is to have a red line mark on the hot water pipe.

2. The newly installed water supply pipeline must be pressurized in accordance with the relevant regulations. The test pressure of the metal and its composite pipe is stabilized for 10 minutes, and the pressure drop in the pipe should not be greater than that, and there is no leakage; The pressure of the plastic pipe should be stabilized for 20 minutes, and the pressure drop in the pipe should not be greater than that, and there should be no leakage.

3. PPR water pipes, steel-plastic water pipes, and copper pipes are commonly used for home decoration water pipes, and the steel-plastic pipes are relatively higher, while the accessories of PPR water pipes are higher than those of steel-plastic pipe fittings, and copper pipes are the most expensive, which is equivalent to about 4 times that of PPR pipes.

4. Home decoration laying water pipes should be avoided from the ground as much as possible, and it is best to line from the top or wall, the amount of pipes may increase slightly, but it is conducive to future pipeline maintenance.

5. Pay attention to the diameter and wall thickness of the water pipe for home decoration, the general general pipe should be in charge with 6 pipes, and the pipes can be selected with 4 pipes, in order to ensure water consumption, the pipes can also use 6 pipes.

6. The standard length of PPR pipes is four meters each, and when you buy it, you should ask clearly whether the merchant is talking about the ** or ** per meter of pipes, and remember to check whether the length of the pipe meets the requirements after the pipe is delivered.

7. When purchasing pipes for home decoration, pay attention to whether the inner diameter of the pipe is symmetrical, and the uneven thickness of the pipe diameter will affect the docking of the two interfaces.

First, the water supply pipe for decoration is good with aluminum-plastic composite pipe, but it is high. The more used is the PPR water pipe, which is moderate.

2. There are three types of general household water pipes: PPR hot melt pipes, aluminum-plastic composite pipes, and steel-plastic composite pipes. The galvanized steel pipes commonly used in the past are rarely used due to rust, difficult processing, and difficult maintenance, and are obsolete products.

PPR hot melt tube: PP-R (polypropylene random) tube is also known as: random copolymer polypropylene tube, type III polypropylene tube, PPR tube.

It has the advantages of environmental protection, light weight and high strength, corrosion resistance, smooth inner wall and no scaling, easy construction and maintenance, long service life, etc., and has a wide range of applications.

The connection of the PPR hot melt tube is thermally fused, and the joints are integrated, so it is very strong and not easy to leak. Decoration buried trench laying will not be corroded.

PPR hot melt pipe is divided into two types: cold water pipe and hot water pipe, in which the wall thickness of the hot water pipe is thicker than that of the cold water pipe, and has the characteristics of high temperature resistance and high pressure. It is recommended to use PPR hot water pipes as household water supply pipes as much as possible.

The strength of PPR is lower. When the ambient temperature reaches 0 degrees, if the pipe is frozen, it is easy to burst.

Aluminum-plastic composite pipe: It is to add a layer of aluminum pipe to the wall of the PPR pipe. In essence, it is a combination of aluminum-plastic pipe and PPR pipe, which not only overcomes the defects that the aluminum-plastic pipe is not easy to make elbows and the strength of the PPR pipe is slightly poor, but also highlights the characteristics of high strength of the aluminum-plastic pipe and good flexibility of the PPR pipe, and has good low-temperature characteristics.

If the home decoration requirements are relatively high, the aluminum-plastic composite pipe should be used as the water supply pipe.

Steel-plastic composite pipe: the strength is higher, but the construction and maintenance are relatively difficult, and the use of home decoration is relatively rare.

It is best to use PPR pipes for decoration, I personally recommend you to use Weixing or Dr. Water, safe and ***, my household is PPR water pipes, ** more affordable than other pipes, cost-effective.

316L stainless steel corrugated water pipe is used for decoration, top products, no joints, no elbows, earthquake-resistant, high-temperature non-toxic, low-temperature non-freezing and cracking, high-grade healthy and sanitary water pipes. 135756860626

The owners of our community look at the water doctor pipe, I also tried to use it, the effect is really good, I recommend and share with you, good products, of course, many people to choose, water doctor pipe is worth having!

My family and relatives and friends around me are using Dr. Water PPR pipes, and the plumber master also said that the material of Dr. Water pipes is good and there is no smell.

Personally, I think that water must be drunk every day, so the water pipe must be selected better. In this way, it is safer, and the following are recommended to some good brands, top ten brands Jinde (Chinese famous brand. A well-known trademark in China.

Top 10 water pipe brands. Place of origin: Shenyang, Liaoning).

2. PPR Top 10 Brands Rifeng (China's famous brand. A well-known trademark in China.

Top 10 water pipe brands. Place of origin: Foshan, Guangdong).

3. PPR Top 10 Brands Weixing (Chinese Famous Brand. A well-known trademark in China.

Top 10 water pipe brands. Origin: Linhai, Zhejiang).

Top 10 brands Jinniu (Chinese famous brand. A well-known trademark in China.

Top 10 water pipe brands. Place of origin: Wuhan, Hubei).

Top 10 brands Zhongcai (Chinese famous brand. A well-known trademark in China.

Top 10 water pipe brands. Place of origin: Hangzhou, Zhejiang).

Top 10 brands Liansu (China famous brand. A well-known trademark in China.

Top 10 water pipe brands. Place of origin: Shunde, Guangdong).

7. PPR Top Ten Brands Gudi (Chinese Famous Brand. A well-known trademark in China.

Top 10 water pipe brands. Origin: Ezhou, Hubei).

8. PPR Top Ten Brands Tongde (Chinese Famous Brand. A well-known trademark in China.

Top 10 water pipe brands. Origin: Shaoxing, Zhejiang).

Top 10 Brands AD (Chinese Famous Brand. A well-known trademark in China.

Top 10 water pipe brands. Origin: Taizhou, Zhejiang).

Top 10 brands Kangtai (Chinese famous brand. A well-known trademark in China.

Top 10 water pipe brands. Origin: Chengdu, Sichuan), generally better are these brands, the quality is about the same, you can compare more, choose a relatively high cost performance.

The first choice for decoration is Dr. Water, imported raw materials from abroad, and the products are trustworthy.

If you want to be healthy and durable, install 304 food-grade stainless steel water pipes. 70 years is not a problem.

Weixing ** high, high visibility, I use Dr. Water pipe is good, cost-effective, recommended by the hydropower master, quality.

This mainly depends on what kind of space your exposed water pipe is in.

For example, if your water pipe is a large drain in the corner of the toilet wall, then you can buy some tiles like the toilet and wrap it with an anti-raised right angle. This does not affect the aesthetics.

If your water pipe is in other places, not the kitchen toilet. Then you can wrap it in wallpaper first, and then arrange some ornamental plants such as Tenghua and creeper on top of the pipe to make it look like a strip plant. It's also very good-looking.

If you are the kind of small water pipe in the kitchen and toilet, then it is really not easy to decorate, but this kind of water pipe is mainly your material is better, and then the installation is more organized, which will not affect the appearance.

The main thing is that you can't see your visual diagram. If you can take a picture, I can help you design it more competently!

The method of installing the open water pipe is similar to the open line of the installed circuit, but the position is different, and the supporting method is also different. Exposed water pipes are generally placed at the base of the wall. The fixed support method is usually a pre-embedded pipe clamp.

There are two kinds of pipe clamps: one is that there are pointed feet on the pipe clamp, but the wooden sleeper needs to be buried first, and after the wooden sleeper is embedded in batches and the mortar is dried, the iron pointed foot can be embedded in the wooden sleeper with a hammer head, and the other is that the lower part of the pipe clamp has a fork foot, but this fork foot must be chiseled out on the wall for the cave and then the foot head is embedded, and then the floating ash is wiped off to make the cave wet, and then the cement mortar is embedded in batches, and the pipe clamp can be stressed only after the mortar is dry. According to the needs of the direction of the water pipe, when digging the wall hole, you can use a portable percussion drill or chisel to chisel out the wall hole in the required part, plug into the water pipe, first pad the wooden block to fix the stop, and then use cement and yellow mortar to embed in batches.

Hello. You can do something decorative with wall painting, such as painting it with color and adding a little decoration!

Or you can get some personality decoration to cover it up, you can get some rattan decoration, just make some fake vine plants to wrap it.

No decoration is required. The surface-mounted pipe should be neat and regular, clean and white.