How to set up my home wireless solution? It s a test of skill and experience!

What kind of Chinanet telecom signal is the wifi coverage point you are talking about? Or is it your own wireless router transmitting a signal?

Note: If it is Chinanet or CMCC, it cannot be relayed and Qiaolian, they are antenna-type towers.

Solution 1: Buy a wireless router with a relay function to establish a relay or overseas Chinese association.

In case 2, the launcher can purchase <>

For this kind of device that increases the transmission distance of wireless signals, the receiver buys a directional radar receiving antenna<> which can enhance the acceptance of wireless space-renting signals, and then establishes a virtual AP on the laptop to share other wireless devices.

1. It is difficult to install a wireless repeater, and it is generally not recommended to use mesh equipment and bridges. Reasons: high cost and technical difficulty;

2. A computer that uses a wireless network card to access the Internet can use another wireless network card as an AP, which is feasible.

Here's how: Network IP Settings:

Open "Network Connection" which should have both local connection and Wi-Fi connection, click on the "Wi-Fi" menu of the properties "General" option to put it inside.

The IP address is set to the subnet mask.

2. Wireless network configuration:

1.Click on the first option of "Wireless Network Configuration" and check the box before "Configure my wireless network settings with window".

2.In the "Wireless Network Configuration", click "Add" and write the name (both English and numeric) in the network name (SSID) in the "Link" option that appears. For example, we are using M8; Check the "Connect even if this network is not broadcasting" option; Under "Wireless Network Key", select "Network Authentication", select Open, "Data Encryption", you can choose to disable, or you can choose 64 or 128 bits (it doesn't matter to yourself), and then confirm, then you can see a connection point with the name "m8" in the "Preferred Network".

3.Or click "Computer-to-Computer" in the "Advanced" option in the "Wireless Network Tab", click "Off" to exit, and then click OK to complete the wireless network card configuration.

3. Scatter and share settings.

Open the local connection in the network connection (note: the wireless connection should be selected here) --properties--> advanced, in the "allow other network users to connect through this computer's Internet connection" option before the hook, here is basically done.

Enjoy.